AlSiP3, a compound with a novel wurtzite-pyrite intergrowth structure

AlSiP₃ is formed by heating aluminum and silicon powder with red phosphorus and adding small amounts of iodine or AlCl₃. Small, black crystals with metallic lustre grow at 1200°K. The compound crystallizes in the orthorhombic space group Pmnb (No. 62) with a = 987.2 pm, b = 586.1 pm, c = 608.8 pm and four formula units. In the structure isolated P atoms as well as P₂ pairs are present (PP = 218.2 pm). Silicon is tetrahedrally bonded (SiP = 224.2 ? 228.2 pm) whereas aluminum has octahedral coordination (AlP = 244.2 – 260.8 pm). The structure can be described as an intergrowth structure of wurtzite and pyrite type.     

Mass spectrometry of onium salts—I. Studies on anilinium oxides

The mass spectra of the three isomeric trimethylanilinium oxides and their methyl-d₃ analogues show that the m- and p- isomers undergo intermolecular trans-O-alkylation before evaporation. In the o-isomer, only 10% transalkylated product is observed and there is strong evidence that most of this isomer evaporates without undergoing structural changes. By indirect introduction, however, the o-isomer showed only transalkylated product. The most important fragmentation patterns on electron-impact are α-cleavage on the N-methyl carbon or expulsion of the O-substituent with formation of a quinoid structure. The latter dominates for the o- and p-methyl ethers while the former is the most important pathway for the m-isomer and for the corresponding phenols. Lower fragments are of modest intensity.     

An investigation into the initial degradation steps of four major dye chromophores: study of their one-electron oxidation and reduction by EPR, ENDOR, cyclic voltammetry, and theoretical calculations

The degradation of dyes is frequently initiated by one-electron oxidation or reduction; however, relatively little is known about the initially formed radicals. Acid Green 25 (AG25), Crystal Violet (CVI), Methylene Blue (MB), and Acid Orange 7 (AO7), representing paradigms of four types of commercial organic dyes, were therefore investigated in terms of their redox behavior. Their redox potentials in MeCN and buffered aqueous solutions were determined by cyclic voltammetry. The structures of the one-electron reduced and oxidized dyes were established by EPR spectroscopy and by theoretical calculations on the density functional level of theory.     

Thermische Polymerisation von Acenaphthylen

Zusammenfassung Acenaphthylen wurde durch Anpolymerisation und zweifache Hochvakuumsublimation gereinigt. Die Reinigungsmethode wird ausführlich beschrieben.Bei verschiedenen Temperaturen wurde mit einer dilatometrischen Methode die thermische Bruttogeschwindigkeit gemessen. Zwischen 95 und 105 °C giltk _br=7,0₈·10¹⁰ exp (– 30,9 kcal/RT).Die beträchtliche Aktivierungsenergie der Bruttoreaktion ist sowohl auf eine große Aktivierungsenergie der thermischen Startreaktion als auch auf eine relativ hohe Wachstumsaktivierungsenergie zurückzuführen.Das Polymerisationsverhalten von Acenaphthylen kann vermutlich aufgrund seiner sterischen Eigenschaften erklärt werden.

---

Summary Acenaphthylene was purified by partial polymerisation, followed by double stage high vacuum sublimation. The method of purification is described in detail.The thermal overall rate was measured at different temperatures by a dilatometric method. Between 95 and 105 °C the following relation holds:k _th=7,0₈ · 10¹⁰ exp (– 30,9 kcal/RT).The considerable energy of activation of the overall reaction depends on a relatively high energy of activation of both the thermal initiation and the propagation reaction.It is supposed, that the polymerisation behaviour of acenaphthylene depends mainly on its steric properties.

     

Atomic force microscopy study of the adsorption and electrostatic self-organization of poly(amidoamine) dendrimers on mica

The adsorption behavior of poly(amidoamine) dendrimers to mica surfaces was investigated as a function of ionic strength and pH. The conformation and lateral distribution of the adsorbed dendrimers of generations G8 and G10 were obtained ex situ by tapping mode atomic force microscopy (AFM). The deposition kinetics of the dendrimers was found to follow a diffusion-limited process. Fractional surface coverage and pair correlation functions of the adsorbed dendrimers were obtained from the AFM images. The data are interpreted in terms of the random sequential adsorption (RSA) model, where electrostatic repulsion due to overlapping double layers is considered. Although the general trends typical for an RSA-determined process are well-reproduced, quantitative agreement is lacking at low ionic strengths.     

Square‐Planar Carbonylchlororhodium(I) Complexes Containing trans‐Spanning Diphosphine Ligands as Catalysts for the Carbonylation of Methanol

The rhodium(I) complexes trans‐[Rh(diphos)(CO)Cl] 7 (diphos=pbpb), 8 (diphos=nbpb), and 9 (diphos=cbpb) were synthesized (Scheme 4) and used as catalysts for the carbonylation of MeOH to AcOH (Scheme 1). The trans coordination imposed by the rigid C‐spacer framework of the diphos ligands pbpb, nbpb, and cbpb, demonstrated by ³¹P‐NMR and IR spectroscopy of 7 – 9 and unambiguously confirmed by single‐crystal X‐ray structure analysis of 7 , improved the thermal stability of the rhodium(I) system under carbonylation conditions and, hence, the catalytic performance of the complexes. For the catalytic carbonylation of MeOH, the active catalyst could be prepared in situ from the mixture of [Rh(CO)₂Cl]₂ and the corresponding diphos ligand pbpb, nbpb, or cbpb, giving the same results as carbonylation in the presence of the isolated complexes 7, 8 or 9 (see Table). The highest activity was observed for complex 7 (or the mixture [Rh(CO)₂Cl]₂/pbpb, the catalytic turnover number (TON) being 950 after 15 min (170°, 22 bar).     

Sulfur speciation by capillary zone electrophoresis: conditions for sulfite stabilization and determination in the presence of sulfate, thiosulfate and peroxodisulfate

Capillary zone electrophoresis (CZE) was used for the separation of the sulfur species SO3(2-), SO4(2-), S2O(3-) and S2O8(2-). Using an electrolyte system with 9.5 mmol L(-1) potassium chromate as UV-absorbing probe and 1 mmol L(-1) diethylenetriamine (DETA) as electroosmotic flow modifier, various possibilities for the stabilization of sulfite and electrophoretic separation of the sulfur anions were investigated. By adding 5% propanol as a stabilizer to both the working electrolyte and the sample solution, a good stabilization for sulfite and a separation of the sulfur anions in a short analysis time (4 min) was achieved. The advantages by using propanol instead of other stabilizers often used in analytical techniques are discussed. The electrophoretic separation of the sulfur anions was optimized with respect to the pH of the working electrolyte and concentration of the electroosmotic flow modifier (DETA). The detection limits achieved for SO3(2-), SO4(2-), S2O3(2-) and S2O8(2-) were 0.35, 0.25, 0.78 and 0.80 mg L(-1), respectively.     

Gitterpunkte in Lemniskatenscheiben

Let G (R) denote the number of lattice points (,) **Z² in the domain B(R) bounded by the lemniscate (x²+y²)²=2R² (x²–y²) and put P(R)=G(R)-R²(R² being the area of B(R)). The purpose of this paper is to determine the order of magnitude of P(R) for large R by proving the asymptotic relation (3). An analogous result is given for the eight curve x⁴=R² (x²–y²).     

Wismutmonojodid BiJ,eine Verbindung mit Bi(O) und Bi(II)

Bismuth Monoiodide, a Compound with Bi(O) and Bi(II) Bismuth monoiodide was synthesized in closed tubes from the elements as well as from Bi and HgI₂ as a black coloured crystalline compound. With increasing temperature BiI passes two transitions. α-BiI is stable below 370 K and changes to β-BiI by a martensitic transition. γ-BiI is the stable modification above 564 K and decomposes at 585 K peritectically to BiI₃ and a lower iodide. All three modification crystallize in the monoclinic space group C2/m. The structures (single crystal studies) of α-BiI and β-BiI are characterized by onedimensional infinite chains [Bi₄I₄] with covalent bonds but only weak interactions in between. The [Bi₄I₄]-chains are built up by two completely different Bi atoms. Bi(A) is only bonded to three Bi whereas Bi(B) has bonds to one Bi and four I. The average bond lengths are Bi? Bi = 304.5 pm and Bi? I = 313.7 pm respectively. The configuration of the Bi(A) atoms is typical for Bi^O and that one of the Bi(B) atoms is characteristic for Bi²⁺ with the electron configuration s²p¹. Therefore, α-BiI and β-BiI are mixed valence compounds [Bi^OBi²⁺I₄]. The structures are variants of the simple cubic polonium type of structure and differ in the stacking of connected units. The structures and their transitions, the possible configurations for monohalides BiX on principle as well as the energy balances of the disproportionation of Bi⁺ are discussed together in detail.