Determination of higher carboxylic acids in snow samples using solid-phase extraction and LC/MS-TOF

The objective of this work was to develop a method to determine the concentrations of higher organic acids in snow samples. The target species are the homologous aliphatic alpha,omega-dicarboxylic acids from C(5) to C(13), pinonic acid, pinic acid and phthalic acid. A preconcentration procedure utilizing solid phase extraction was developed and optimized using solutions of authentic standards. The influences of different parameters such as flow rate during extraction and the concentration of the eluent on the efficiency of the extraction procedure were investigated. The compounds of interest were separated by HPLC and detected by a quadrupole time-of-flight mass spectrometer (qTOF-MS). The recovery rate (extraction efficiency) of the extraction procedure was found to vary between 41% for tridecanedioic acid and 102% for adipic acid. The limits of detection were determined for all compounds and were between 0.9 nmol/L (dodecanedioic acid) and 29.5 nmol/L (pinonic acid). An exception is pinic acid, for which a considerably higher detection limit of 103.9 nmol/L was calculated. Snow samples were collected in December 2006 and January 2007 at the Fee glacier (Switzerland) from locations at heights from 3056 to 3580 m asl and from different depths within the snow layer. In total, the analysis of 61 single snow samples was performed, and the following compounds could be quantified: homologous aliphatic alpha,omega-dicarboxylic acids with 5-12 carbon atoms and phthalic acid. Tridecanedioic acid, pinonic and pinic acid were identified in the samples but were not quantified due to their low concentrations. The three most abundant acids found in the molten snow samples were glutaric acid (C(5)-di; 3.90 nmol/L), adipic acid (C(6)-di; 3.35 nmol/L) and phthalic acid (Ph; 3.04 nmol/L).     

On-line size exclusion chromatography-pyrolysis-gas chromatography-mass spectrometry for copolymer characterization and additive analysis

On-line coupled size exclusion chromatography-pyrolysis gas chromatography mass spectrometry (SEC-Py-GC-MS) is studied as a novel tool for the characterization of complex polymer samples. An automated system for on-line SEC-Py-GC-MS allowing transfer of multiple fractions was developed based on stop-flow operation of the SEC dimension, syringe-based transfer of the SEC fraction to the GC instrument and solvent elimination with subsequent pyrolysis in a programmed temperature vaporization (PTV) injector. After optimization the system was applied to the characterization of a complex terpolymer composed of very similar monomers. The use of the system for combined pyrolysis and additive analyses in polycarbonate was also demonstrated. Results obtained with the new method indicate the interesting potentials of the method for detailed characterization of polymeric materials.     

Plumbonacrite Identified by X‐ray Powder Diffraction Tomography as a Missing Link during Degradation of Red Lead in a Van Gogh Painting

Red lead, a semiconductor pigment used by artists since antiquity, is known to undergo several discoloration phenomena. These transformations are either described as darkening of the pigment caused by the formation of either plattnerite (β‐PbO₂) or galena (PbS) or as whitening by which red lead is converted into anglesite (PbSO₄) or (hydro)cerussite (2 PbCO₃?Pb(OH)₂; PbCO₃). X‐ray powder diffraction tomography, a powerful analytical method that allows visualization of the internal distribution of different crystalline compounds in complex samples, was used to investigate a microscopic paint sample from a Van Gogh painting. A very rare lead mineral, plumbonacrite (3 PbCO₃? Pb(OH)₂?PbO), was revealed to be present. This is the first reported occurrence of this compound in a painting dating from before the mid 20th century. It constitutes the missing link between on the one hand the photoinduced reduction of red lead and on the other hand (hydro)cerussite, and thus sheds new light on the whitening of red lead.     

A new metallostar complex based on an aluminum(iii) 8-hydroxyquinoline core as a potential bimodal contrast agent

A ditopic DTPA monoamide derivative containing an 8-hydroxyquinoline moiety was synthesized and the corresponding gadolinium(iii) complex ([Gd(H5)(H(2)O)](-)) was prepared. After adding aluminum(iii), the 8-hydroxyquinoline part self-assembled into a heteropolymetallic triscomplex [(Gd5)(3)Al(H(2)O)(3)](3-). The magnetic and optical properties of this metallostar compound were investigated in order to classify it as a potential in vitro bimodal contrast agent. The proton nuclear magnetic relaxation dispersion measurements indicated that the relaxivity r(1) of [Gd(H5)(H(2)O)](-) and [(Gd5)(3)Al(H(2)O)(3)](3-) at 20 MHz and 310 K equaled 6.17 s(-1) mM(-1) and 10.9 s(-1) mM(-1) per Gd(iii) ion respectively. This corresponds to a relaxivity value of 32.7 s(-1) mM(-1) for the supramolecular complex containing three Gd(iii) ions. The high relaxivity value is prominently caused by an increase of the rotational tumbling time τ(R) by a factor of 2.7 and 5.5 respectively, in comparison with the commercially used MRI contrast agent Gd(iii)-DTPA (Magnevist?). Furthermore, upon UV irradiation, [(Gd5)(3)Al(H(2)O)(3)](3-) exposes green broad-band emission with a maximum at 543 nm. Regarding the high relaxivity and the photophysical properties of the [(Gd5)(3)Al(H(2)O)(3)](3-) metallostar compound, it can be considered as a lead compound for in vitro bimodal applications.     

Intercomparison on measurements of PCBs in pork fat during the Belgian PCB-crisis

During the Belgian PCB crisis (1999/2000) the quality of the data from the PCB monitoring were studied with a proficiency testing experiment. Pork fat that was spiked at the Institute for Reference Materials and Measurements (EC-JRC-IRMM) was sent out as unknown to all laboratories that participated in the monitoring. In parallel, the material was certified on the basis of the results of several leading PCB laboratories throughout Europe that did not participate in the monitoring. During the first round 15 to 25% deviation was experienced, while in the end of this multistep intercalibration procedure the average deviation for the respective PCBs was 10.9% (PCB 28), 13.1% (PCB 52), 10.1% (PCB 101), 10.7% (PCB 118), 10.7% (PCB 138), 9.1% (PCB 153), 8.1% (PCB 180) and 8.2% for the sum of the 7 PCBs. The concentrations measured for the higher volatile PCB 28 had a tendency to show lower levels, while for PCB 180 this was less pronounced. On the other hand, PCB 153 showed results rather to the higher side. During this exercise the material was also tested for stability by one of the certifying laboratories.     

The Donor-Dependent and Colon-Region-Dependent Metabolism of (+)-Catechin by Colonic Microbiota in the Simulator of the Human Intestinal Microbial Ecosystem

The intestinal absorption of dietary catechins is quite low, resulting in most of them being metabolized by gut microbiota in the colon. It has been hypothesized that microbiota-derived metabolites may be partly responsible for the association between catechin consumption and beneficial cardiometabolic effects. Given the profound differences in gut microbiota composition and microbial load between individuals and across different colon regions, this study examined how microbial (+)-catechin metabolite profiles differ between colon regions and individuals. Batch exploration of the interindividual variability in (+)-catechin microbial metabolism resulted in a stratification based on metabolic efficiency: from the 12 tested donor microbiota, we identified a fast- and a slow-converting microbiota that was subsequently inoculated to SHIME, a dynamic model of the human gut. Monitoring of microbial (+)-catechin metabolites from proximal and distal colon compartments with UHPLC-MS and UPLC-IMS-Q-TOF-MS revealed profound donor-dependent and colon-region-dependent metabolite profiles with 5-(3′,4′-dihydroxyphenyl)-γ-valerolactone being the largest contributor to differences between the fast- and slow-converting microbiota and the distal colon being a more important region for (+)-catechin metabolism than the proximal colon. Our findings may contribute to further understanding the role of the gut microbiota as a determinant of interindividual variation in pharmacokinetics upon (+)-catechin ingestion.     

Voice Characteristics in Adults With Neurofibromatosis Type 1

Neurofibromatosis type 1 (NF1) is an autosomal dominant neurocutaneous disorder caused by mutations in the NF1 gene, which is located at the long arm of chromosome 17. Major characteristics include multiple café-au-lait spots and neurofibromas. Voice abnormalities have been reported to occur in this patient group. However, most studies relied on subjective measurements only. The present study reports the results of an objective voice assessment based on a multiparameter approach in 22 adults with NF1. Aerodynamic measurements, voice range profiles, acoustic voice quality and intonation measurements, and dysphonia severity indices were obtained and compared with data from a control group, consisting of 22 healthy adults. It was found that NF1 patients show a poorer overall voice quality compared with controls. Particularly, a reduction of vital capacity and limitations in laryngeal possibilities with respect to frequency and intensity were observed in the NF1 group.     

Raman lasing with a cold atom gain medium in a high-finesse optical cavity

We demonstrate a Raman laser using cold (87)Rb atoms as the gain medium in a high-finesse optical cavity. We observe robust continuous wave lasing in the atypical regime where single atoms can considerably affect the cavity field. Consequently, we discover unusual lasing threshold behavior in the system causing jumps in lasing power, and propose a model to explain the effect. We also measure the intermode laser linewidth, and observe values as low as 80 Hz. The tunable gain properties of this laser suggest multiple directions for future research.     

Noncollinear magnetic hyperfine fields in the Ag spacers of Fe/Ag multilayers

Nearly perpendicular magnetic hyperfine fields have been observed for the first time in the Ag "spacers" of Fe/Ag multilayers using low temperature nuclear orientation of (110)Ag(m) at 6 mK. At the same time, vibrating sample magnetometry measurements at temperatures down to 4 K have shown the magnetic anisotropy of the Fe to be in plane. The direction of the Ag hyperfine field is thus noncollinear (nearly orthogonal) to the Fe anisotropy. These results are compared with full potential linearized augmented plane wave calculations using the wien97 code.