Copper catalyst activation driven by photoinduced electron transfer: a prototype photolatent click catalyst

PET cat. While the copper(II) tren ketoprofenate precatalyst 1 (see picture) is inactive at room temperature in methanol, it is quantitatively and rapidly reduced to its cuprous state upon light irradiation to provide a highly reactive click catalyst. By simply introducing air into the reaction medium the catalysis can be switched off and then switched on again by bubbling argon followed by irradiation.     

A study of cysteamine ionization in solution by Raman spectroscopy and theoretical modeling

Different cysteamine (H2N-CH2-CH2-SH) ionization forms have been studied by polarized Raman spectroscopy in solutions prepared with H2O and D2O and by DFT calculations at the B3LYP/6-31++G(d,p) level. To account for solvation effects, we employed the integral equation formalism polarizable continuum model (IEFPCM) option and explicit water molecules. Calculated relative energies and Raman spectra revealed that gauche rotamers around the C-C bond are the most stable conformers in solution. The experimental pKa values and Raman spectra of various ionization forms were best predicted by using a model with three explicit water molecules and the IEFPCM option. In general, the use of IEFPCM tends to lower the calculated frequencies for a few bands, but in some cases (S-H stretching mode) this effect is expressed very strongly. Potential energy distribution (PED) analysis of gauche conformers of various cysteamine ionization forms provided the possibility of discriminating spectroscopically methylene groups adjacent to sulfur, (CH2)S, and nitrogen, (CH2)N, sites. In general, stretching and scissoring modes as well as wagging and twisting vibrations of the (CH2)N group were found to be at higher frequencies. The influence of ionization of SH and NH2 groups on the vibrational spectrum is discussed, and Raman markers for further amine group ionization studies are suggested.     

On the Mean Value of the Product of Multiplicative Functions with Shifted Argument

In this paper, we consider the mean value of the product of multiplicative arithmetic functions with shifted argument. The investigated functions have to satisfy the following conditions: their moduli do not exceed 1; the values on the set of primes are close to 1 for one of the functions and close to a fixed complex number for the other function. Some consequences for the classical functions are given.     

Terpy(Pt–salphen)2 Switchable Luminescent Molecular Tweezers

The design and synthesis of switchable molecular tweezers based on a luminescent terpy(Pt‐salphen)₂ ( 1 ; terpy=terpyridine) complex is reported. Upon metal coordination, the tweezers can switch from an open “W”‐shaped conformation to a closed “U”‐shaped form that is adapted for selective recognition of cations. Closing of the tweezers by metal coordination (M=Zn²⁺, Cu²⁺, Pb²⁺, Fe²⁺, Hg²⁺) was monitored by ¹H NMR and/or UV/Vis titrations. During the titration, exclusive formation of the 1:1 complex [M( 1 )] was observed, without appearance of an intermediate 1:2 complex [M( 1 )₂]. The crystallographic structure of the 1:1 complex was obtained with Pb²⁺ and showed a distorted helical structure. Selective intercalation of Hg²⁺ cations by the closed “U” form was observed. The tweezers were reopened by selective metal decoordination of the terpyridine ligand by using tris(2‐aminoethyl)amine (tren) as a competitive ligand without modification of the Pt–salphen complex. Detailed photophysical studies were performed on the open and closed tweezers. Structured emission was observed in the open form from the Pt–salphen moieties, with a high quantum yield and a long lifetime. The emission is slightly modified upon closing with 1 equivalent of Zn²⁺ or Hg²⁺, whereas a dramatic quenching was obtained upon intercalation of additional Hg²⁺.     

Mass Discrimination in High-Mass MALDI-MS

In high-mass matrix-assisted laser desorption/ionization mass spectrometry (MALDI-MS), the accessible m/z range is limited by the detector used. Therefore, special high-mass detectors based on ion conversion dynodes (ICDs) have been developed. Recently, we have found that mass bias may exist when such ICD detectors are used [Weidmann et al., Anal. Chem. 85(6), 3425–3432 (2013)]. In this contribution, the mass-dependent response of an ICD detector was systematically studied, the response factors for proteins with molecular weights from 35.9 to 129.9 kDa were determined, and the reasons for mass bias were identified. Compared with commonly employed microchannel plate detectors, we found that the mass discrimination is less pronounced, although ions with higher masses are weakly favored when using an ICD detector. The relative response was found to depend on the laser power used for MALDI; low-mass ions are discriminated against with higher laser power. The effect of mutual ion suppression in dependence of the proteins used and their molar ratio is shown. Mixtures consisting of protein oligomers that only differ in mass show less mass discrimination than mixtures consisting of different proteins with similar masses. Furthermore, mass discrimination increases for molar ratios far from 1. Finally, we present clear guidelines that help to choose the experimental parameters such that the response measured matches the actual molar fraction as closely as possible.

Tuning the refractive index in 3D direct laser writing lithography: towards GRIN microoptics

We report a study of the determination of polymer cross‐linking, namely the degree of conversion and refractive index of the microstructures created by two‐photon polymerization (TPP). The influence of TPP processing parameters such as laser intensity and scanning velocity is investigated. The degree of conversion is analyzed via Raman microspectroscopy and the refractive index is measured with the interferometric technique employing a Michelson interferometer. Moreover, the relationship between these two properties is revealed and details are discussed. The largest refractive index change that we have obtained is of the order of 10⁻². Finally, we propose and demonstrate experimentally the realization of the gradient‐index (GRIN) structure, resulting from a laser‐induced local refractive index modification due to monomer cross‐linking, i.e. degree of conversion. This work implies that the TPP technique is a valuable tool for the fabrication of GRIN microoptics for (in)homogeneous molding of light flow at the micrometer scale.

     

BF2-azadipyrromethenes: probing the excited-state dynamics of a NIR fluorophore and photodynamic therapy agent

BF(2)-Azadipyrromethene dyes are a promising class of NIR emitter (nonhalogenated) and photosensitizer (halogenated). Spectroscopic studies on a benchmark example of each type, including absorption (one and two photon), time-resolved transient absorption (ps-ms) and fluorescence, are reported. Fast photodynamics reveal that intense nanosecond NIR fluorescence is quenched in a brominated analog, giving rise to a persistent (21 μs) transient absorption signature. Kinetics for these changes are determined and ascribed to the efficient population of a triplet state (72%), which can efficiently sensitize singlet oxygen formation (ca. 74%), directly observed by (1)Δ(g) luminescence. Photostability measurements reveal extremely high stability, notably for the nonhalogenated variant, which is at least 10(3)-times more stable (Φ(photodeg.) = < 10(-8)) than some representative BODIPY and fluorescein dyes.