紫外光辐照下CH3NH3PbI3基钙钛矿太阳能电池失效机制

随着光伏产业的不断发展,有机无机杂化钙钛矿太阳能电池的研发成为科学与工业界广泛关注的焦点。到目前为止,其光电转换效率已经提高到了25.2%,成为替代硅基太阳能电池的核心方案之一。然而,钙钛矿太阳能电池的稳定性较差,容易受到环境中氧气、水分、温度甚至光照的影响,这严重制约了其大规模推广与应用。大量科学研究表明,如何避免紫外辐照下有机无机杂化钙钛矿太阳能电池的性能衰减,对于提高钙钛矿太阳能电池的光照稳定性至关重要。然而到目前为止,仍然没有系统的工作来对紫外辐照下钙钛矿太阳能电池性能以及微结构演化过程进行详细的表征与分析。本文中,我们利用聚焦离子束-扫描电子显微分析(FIB-SEM)以及球差校正透射电子显微分析(TEM)等技术,全面地研究了紫外辐照过程中有机无机杂化钙钛矿太阳能电池性能变化规律以及电池微结构演化特征。实验结果表明,紫外辐照过程中太阳能电池内部会形成0.5–0.6 V的内建电场,钙钛矿中的I^-离子在电场的驱动下向金属Au电极和空穴传输层2, 2’, 7, 7’-四[N, N-二(4-甲氧基苯基)氨基]-9, 9'-螺二芴(Spiro-OMeTAD)一侧迁移;随后,空穴传输层与金电极的界面处,碘离子与光生空穴一起与金电极发生反应,将金属态Au氧化成离子态Au⁺。而Au⁺离子则在内建电场的驱动下反向迁移穿过钙钛矿MAPbI₃层,直接被SnO₂和MAPbI₃界面处的电子还原形成金属Au纳米团簇。除此之外,紫外辐照过程中钙钛矿太阳能电池性能降低的同时,往往伴随着Spiro-OMeTAD与钙钛矿界面处物质迁移、钙钛矿薄膜内晶界展宽以及Au纳米颗粒周围MAPbI₃物相分解等现象。以上各种因素的协同作用,共同导致了紫外光照下有机无机杂化钙钛矿太阳能电池光电转换性能(PCE)、开路电压(V_oc)以及短路电流(J_sc)等性能参数的急剧下降。     

Copper Nanoparticles In鄄Situ Anchored on Nitrogen鄄Doped Carbon for High鄄Efficiency Oxygen Reduction Reaction Electrocatalyst北大核心CSCD

Compared with noble metal platinum (Pt)-based catalysts, inexpensive non-noble metal electrocatalysts have attracted extensive attention for oxygen reduction reaction (ORR). Herein, chitosan as a kind of biomass resource rich in nitrogen and carbon was used to prepare nitrogen-doped carbon (N-C) and N-C in-situ anchored by copper nanoparticles (Cu/N-C). The as-obtained N-C and Cu/N-C nanoparticles were successfully used as non-noble eletrocatalysts tested for ORR. Compared with the N-C, the Cu/N-C showed the high surface area of 607.3 m2窑g-1 with the mean pore size of 2.5 nm and the pore volume of 0.40 cm3窑g-1. The most positive Gibbs free energy change was the rate determining step for ORR process with the 4e mechanism, where the value of the Cu (111)/N-C(-0.39 eV) was lower than that of the N-C(-0.26 eV). The Cu/N-C exhibited superior onset and half-wave potentials (0.96 V and 0.84 V, respectively) in alkaline media (0.1 mol窑L-1 KOH), all of which are much better than those measured for N-C and commercial Pt/C. Furthermore, the Cu/N-C showed superior methanol crossover avoidance and oxygen reduction stability. © 2021 Authors. All rights reserved.     

Imaging intrinsic diffusion of bridge-bonded oxygen vacancies on TiO2(110)

We report the first measurements and calculations of the intrinsic mobility of bridge-bonded oxygen (BBO) vacancies on a rutile TiO2(110). The sequences of isothermal (340-420 K) scanning tunneling microscope images show that BBO vacancies migrate along BBO rows. The hopping rate increases exponentially with increasing temperature with an experimental activation energy of 1.15 eV. Density functional theory calculations are in very good agreement giving an energy barrier for hopping of 1.03 eV. Both theory and experiment indicate repulsive interactions between vacancies on a given BBO row.     

In situ synthesis of CdS/ZnS composite nanoparticles from ZIF-8 for visible light disposal of Cr(VI)

Journal of Sol-Gel Science and Technology - Zeolitic Imidazolate Framework (ZIF-8) micropolyhedra were employed as a raw material for the synthesis of fine cadmium sulfide/zinc sulfide (CdS/ZnS)...     

辐射接枝法制备膨化聚四氟乙烯杂化膜及其抗菌性表征

通过共辐射接枝的方法,将聚丙烯酸成功接枝到膨化聚四氟乙烯薄膜上. 采用NaBH₄还原吸附在接枝链上的银离子,在膜中原位负载银纳米粒子,制备了抗菌性ePTFE杂化膜. 杂化膜的SEM、XPS、XRD和TGA表征结果表明,负载的银纳米粒子粒径为几十纳米至100 nm. 而银纳米粒子的负载量可由聚丙烯酸的接枝率控制. 细菌平板计数法测试结果证明,所制备的杂化膜具有优异的抗菌性,对大肠杆菌的抗菌率高达100%.     

A Complete Solution to Spectrum Problem for Five‐Vertex Graphs with Application to Traffic Grooming in Optical Networks

A G‐design of order n is a decomposition of the complete graph on n vertices into edge‐disjoint subgraphs isomorphic to G. Grooming uniform all‐to‐all traffic in optical ring networks with grooming ratio C requires the determination of graph decompositions of the complete graph on n vertices into subgraphs each having at most C edges. The drop cost of such a grooming is the total number of vertices of nonzero degree in these subgraphs, and the grooming is optimal when the drop cost is minimum. The existence spectrum problem of G‐designs for five‐vertex graphs is a long standing problem posed by Bermond, Huang, Rosa and Sotteau in 1980, which is closely related to traffic groomings in optical networks. Although considerable progress has been made over the past 30 years, the existence problems for such G‐designs and their related traffic groomings in optical networks are far from complete. In this paper, we first give a complete solution to this spectrum problem for five‐vertex graphs by eliminating all the undetermined possible exceptions. Then, we determine almost completely the minimum drop cost of 8‐groomings for all orders n by reducing the 37 possible exceptions to 8. Finally, we show the minimum possible drop cost of 9‐groomings for all orders n is realizable with 14 exceptions and 12 possible exceptions.     

Excellent passivation of thin silicon wafers by HF‐free hydrogen plasma etching using an industrial ICPECVD tool

In this work, hydrogen plasma etching of surface oxides was successfully accomplished on thin (～100 µm) planar n‐type Czochralski silicon wafers prior to intrinsic hydrogenated amorphous silicon [a‐Si:H(i)] deposition for heterojunction solar cells, using an industrial inductively coupled plasma‐enhanced chemical vapour deposition (ICPECVD) platform. The plasma etching process is intended as a dry alternative to the conventional wet‐chemical hydrofluoric acid (HF) dip for solar cell processing. After symmetrical deposition of an a‐Si:H(i) passivation layer, high effective carrier lifetimes of up to 3.7 ms are obtained, which are equivalent to effective surface recombination velocities of 1.3 cm s^–1 and an implied open‐circuit voltage (V_oc) of 741 mV. The passivation quality is excellent and comparable to other high quality a‐Si:H(i) passivation. High‐resolution transmission electron microscopy shows evidence of plasma‐silicon interactions and a sub‐nanometre interfacial layer. Using electron energy‐loss spectroscopy, this layer is further investigated and confirmed to be hydrogenated suboxide layers. (© 2015 WILEY‐VCH Verlag GmbH &Co. KGaA, Weinheim)     

Trapezoidal phase mask coronagraph

An angular trapezoidal phase mask used for a wideband coronagraph is proposed. The azimuthal phase of the mask is double-periodic and has both trapezoidal and constant parts in each period. This kind of continuous phase distribution can be employed to avoid the abrupt phase variation of the 6-level phase distribution we proposed previously. Numerical calculations show that this more practical phase mask can still keep its superior performance in terms of starlight elimination, small inner working angle, and good achromatism. It is of great importance that there is no singularity in this kind of mask except for a singularity at the center. This mask design is close to real manufacturing conditions, and the process technology is superior.     

Preparation and thermal properties of poly[acrylonitrile-co-(β-methylhydrogen itaconate)] used as carbon fiber precursor

In order to replace terpolymer with bipolymer, a bifunctional comonomer β-methylhydrogen itaconate (MHI) containing carboxyl group and ester group was synthesized to prepare poly[acrylonitrile-co-(β-methylhydrogen itaconate)] [P(AN-co-MHI)] bipolymers used as carbon fiber precursor for improving the stabilization and spinnability at the same time. The P(AN-co-MHI) bipolymers with different monomer feed ratios were characterized by elemental analysis, Fourier transform infrared spectroscopy (FTIR), X-ray diffraction (XRD), and differential scanning calorimetry (DSC). The results show that both the polymerization conversion and molecular mass of P(AN-co-MHI) reduce with the increasing MHI amounts in the feed due to the larger molecular volume of MHI than acrylonitrile (AN). The monomer reactivity ratios were calculated by Fineman–Ross and Kelen–Tüdõs methods, the results show good agreement and MHI possesses higher reactivity than AN. Two parameters $ E_{\text{s}} = A_{{1,629\,{\text{cm}}^{ - 1} }} /A_{{2,244\,{\text{cm}}^{ - 1} }} $ and $ SI = (I_{0} - I_{\text{S}} )/I_{0} $ were defined to evaluate the extent of stabilization, and the activation energy (E _a) of the cyclization was calculated by Kissinger method and Ozawa method. The FTIR, XRD, and DSC results show that P(AN-co-MHI) bipolymers exhibit significantly improved stabilization characteristics than PAN homopolymer, such as larger extent of stabilization, lower initiation temperature, and smaller E _a of cyclization, which is attributed to the ionic initiation by MHI comonomer and it is beneficial to preparing high-performance carbon fiber.