奇妙的惯性力

实际的参考系都不是惯性系，因此必须考虑惯性力．     

Improvement of the Performance of an Acousto-Optical Q-Switched Nd:YAG 946 nm Laser Using a Convex–Plane Cavity

We improve the performance of an acousto-optical Q-switched Nd:YAG 946 nm laser using a convex–plane cavity. We obtain the highest output average power of 2.3 W with a pulse width of 15.3 ns in a 10 kHz 946 nm laser with a convex–plane cavity. The maximum peak power 15.0 kW is about three times higher than that in a plane–plane cavity. Also we investigate the output performances of the pulsed 946 nm laser with the convex–plane cavity at 20 and 50 kHz.     

Li-Y-H三元氢化物的结构和稳定性研究

本文基于粒子群优化算法的结构预测方法结合第一性原理计算,研究了LiYH₄,Li₂YH₅和Li₃YH₆在0—300 GPa压力范围内的晶体结构、电子结构、热力学和动力学稳定性.研究结果表明LiYH₄-P4/nmm,Li₂YH₅-I4/mmm和Li₃YH₆-P4/nmm结构可分别在169—221 GPa,141—300 GPa和166—300 GPa压力范围内由LiH和YH₃按一定配比加压合成.富氢化合物的超导电性研究成为近年来高温超导体研究领域的热点,该研究结果有希望为Li-Y-H三元体系氢化物的超导电性研究及实验合成提供数据支撑.     

探针体耐尔蓝(NB)与DNA结合反应研究

应用微相吸附-光谱修正（MPASC）新技术研究DNA与耐尔蓝（NB）探针分子间的相互作用,分析生物大分子内静电场的形成与Langmuri吸附的关联性,测定了结合产物结合比、平衡常数等。通过在pH=10.38介质中对DNA-NB反应的光谱分析,结果表明产物结合比NB：DNA-P=3：1、平衡常数K=3.33×10^5,摩尔吸收系数ε^660nm=4.81×10^3L/mol cm。样品分析表明DNA回收率95.6%-108%,相对标准偏差RSD=2.8%。     

新型结构超宽带LiNbO3电光调制器的优化设计

采用有限元软件对新型结构的铌酸锂电光调制器进行了优化设计.分析表明,采用脊波导和T型电极相结合的方式,能在保持高的特征阻抗的同时有效的实现相速匹配和有效降低电极损耗,从而较好的提高器件性能,是一种比较有潜力的调制器.利用优化结果,给出一种带宽达153 GHz,半波电压为8.55 V,特征阻抗为44 Ω的调制器的设计例子.     

高功率宽调谐范围掺Yb3+光子晶体光纤激光器

采用闪耀光栅作为色散元件,构建了前向、后向输出两种结构的可调谐掺Yb3 光子晶体光纤激光器,并对其输出特性进行了分析研究.在抽运功率5.75W时,前向输出结构实现了1050.6～1110.2 nm的连续调谐输出,光谱线宽约0.1 nm,边模抑制比大于44 dB.在调谐激光波长为1085 nm时,得到最高输出功率677 mW.结构改进的后向输出结构的可调谐输出结构在抽运功率4.43 W,调谐波长1075 nm,实现了2.21 W的功率输出,斜率效率为73%;调谐范围50.9 nm(1042.1～1093 nm),光谱线宽小于0.08 nm,边模抑制比大于50 dB.两种结构的可调谐激光器输出均为线偏振光,偏振度大于89.5%.     

Tribological Behavior of Multiply-Alkylated Cyclopentanes (MACs)-Cu Nanoparticles Composite Thin Film

Multiply-alkylated cyclopentanes (MACs) composite thin films containing Cu nanoparticles are fabricated on the octadecyltrichlorosilane (OTS)-modified substrate by a spin-coating technique. The thickness, wetting behavior, and nanoscale morphologies of the films are characterized by means of ellipsometry, contact angle measurement, and atomic force microscope (AFM). The friction and wear behaviors of the thin films sliding against Si₃N₄ ball are examined on a UMT-2MT tribometer in a ball-on-disk contact mode. The worn surfaces of the OTS-MAC-Cu composite film and the counterpart Si₃N₄ balls are investigated with a scanning electron microscope. Water contact angle on OTS-MAC-Cu composite film is higher than that of OTS-MAC film. OTS-MAC-Cu composite film exhibits higher load-carrying capacity and better friction reduction and antiwear behavior as compared with OTS-MAC film. This may be attributed to the load-carrying and self-repairing property of the Cu nanoparticles in the composite film and the formation of a transfer layer composed of OTS, MAC, and Cu on the rubbing surface of the counterpart ball.     

基于低相干光的阵列透镜束匀滑技术研究

基于激光加载的材料状态方程的实验研究对靶面光强分布的均匀性及稳定性提出了极高的要求,靶面光强的上述两大特性在很大程度上决定了实验结果的精度和可重复性.本文针对传统窄带高相干激光装置在激光加载材料状态方程实验中表现出的靶面光强均匀性和光强分布稳定性两方面可能存在的问题,提出了基于宽带低相干激光,利用消衍射阵列透镜联合诱导非相干技术的束匀滑方案,并重点分析了波前相位畸变对靶面不均匀性及稳定性的影响.模拟结果表明,该方法明显降低了靶面不均匀性,提高了对波前相位畸变的包容度,获得了均匀、稳定的光强分布.统计分析显示,焦斑强度分布极差和不均匀性与波前相位畸变均方根梯度相关性较强.因此,可以根据统计结果以及实验对焦斑强度分布的要求,给出波前相位畸变的容差范围,对状态方程实验中激光驱动器参数的设计与优化具有指导意义.     

Derivation of baroclinic Ertel–Rossby invariant-based thermally-coupled vorticity equation in moist flow

For the potential vorticity （PV） invariant, there is a PV-based complete-form vorticity equation, which we use heuris- tically in the present paper to answer the following question： for the Ertel-Rossby invariant （ERI）, is there a corresponding vorticity tendency equation？ Such an ERI-based thermally-coupled vorticity equation is derived and discussed in detail in this study. From the obtained new vorticity equation, the vertical vorticity change is constrained by the vertical velocity term, the term associated with the slope of the generalized momentum surface, the term related to the horizontal vorticity change, and the baroclinic or solenoid term. It explicitly includes both the dynamical and thermodynamic factors＇ influence on the vorticity change. For the ERI itself, besides the traditional PV term, the ERI also includes the moisture factor, which is excluded in dry ERI, and the term related to the gradients of pressure, kinetic energy, and potential energy that reflects the fast-manifold property. Therefore, it is more complete to describe the fast motions off the slow manifold for severe weather than the PV term. These advantages are naturally handed on and inherited by the ERI-based thermally-coupled vorticity equation. Then the ERI-based thermally-coupled vorticity equation is further transformed and compared with the traditional vorticity equation. The main difference between the two equations is the term which describes the contribution of the solenoid term to the vertical vorticity development. In a barotropic flow, the solenoid term disappears, then the ERI-based thermally-coupled vorticity equation can regress to the traditional vorticity equation.     

“天光”一号MOPA系统光学元件加工与镀膜的进展

本文阐述了在中国原子能科学研究院“天光一号”ＫｒＦ激光核聚变实验装置上，ＭＯＰＡ系统光学元件加工与镀膜研究工作的进展。实验测量结果表明，加工后的基片表面均方根粗糙度对于Ｋ９光学玻璃与熔融石英玻璃来说分别为σｒｍｓ＝１．８±０．５ｎｍ，σｒｍｓ＝２．０±０．４ｎｍ。镀ＨｆＯ２／ＳｉＯ２高反射膜的光学元件的反射率与破坏阈值分别为Ｒ＞９９．５％，Ｅｔｈ＝１．３０～１．３３Ｊ／ｃｍ２。镀Ａｌ２Ｏ３／ＭｇＦ２增透膜的光学元件的透射率与破坏阈值分别为Ｔ＞９９．５％，Ｅｔｈ＝１．３～１．９７Ｊ／ｃｍ２。