全文获取类型
收费全文 | 8772篇 |
免费 | 1696篇 |
国内免费 | 1613篇 |
专业分类
化学 | 6095篇 |
晶体学 | 163篇 |
力学 | 700篇 |
综合类 | 119篇 |
数学 | 1009篇 |
物理学 | 3995篇 |
出版年
2024年 | 19篇 |
2023年 | 135篇 |
2022年 | 282篇 |
2021年 | 261篇 |
2020年 | 328篇 |
2019年 | 305篇 |
2018年 | 319篇 |
2017年 | 300篇 |
2016年 | 443篇 |
2015年 | 521篇 |
2014年 | 578篇 |
2013年 | 748篇 |
2012年 | 794篇 |
2011年 | 837篇 |
2010年 | 663篇 |
2009年 | 625篇 |
2008年 | 679篇 |
2007年 | 616篇 |
2006年 | 616篇 |
2005年 | 531篇 |
2004年 | 387篇 |
2003年 | 329篇 |
2002年 | 308篇 |
2001年 | 269篇 |
2000年 | 210篇 |
1999年 | 156篇 |
1998年 | 108篇 |
1997年 | 101篇 |
1996年 | 115篇 |
1995年 | 64篇 |
1994年 | 69篇 |
1993年 | 52篇 |
1992年 | 45篇 |
1991年 | 48篇 |
1990年 | 52篇 |
1989年 | 45篇 |
1988年 | 26篇 |
1987年 | 24篇 |
1986年 | 25篇 |
1985年 | 15篇 |
1984年 | 2篇 |
1983年 | 2篇 |
1982年 | 3篇 |
1981年 | 3篇 |
1979年 | 3篇 |
1976年 | 2篇 |
1957年 | 3篇 |
1936年 | 5篇 |
1930年 | 2篇 |
1923年 | 1篇 |
排序方式: 共有10000条查询结果,搜索用时 15 毫秒
91.
通过对合成金刚石的原材料和合成产物——石墨、Ni70Mn25Co5触媒、普通人造金刚石、黑色人造金刚石、NiMnCoC熔体的磁化率测试,以及对黑色人造金刚石和普通人造金刚石破碎断面扫描电镜的对比分析,认为黑色人造金刚石形成低磁性的原因是由于合成过程中温度偏高、压力偏低,生长的金刚石质量差、裂纹多。晶体内夹杂了很多石墨与触媒包裹体,同时金刚石表面与金刚石晶体内的触媒包裹体之间形成贯穿性的裂纹。在金刚石化学提纯处理过程中,金刚石晶体内的铁磁性触媒包裹体杂质被通过裂纹进入的酸除去。因而在检测金刚石磁性时,黑色金刚石的磁性很小,呈弱磁性。 相似文献
92.
93.
94.
制备了四种不同铒离子掺杂浓度的碲酸盐玻璃,通过测定吸收光谱计算了吸收谱线的振子强度,根据Judd-Ofelt理论计算了不同浓度下Er3 离子发光光谱的强度参数Ωi(i=2,4,6),计算了自发辐射电偶和磁偶跃迁概率、辐射寿命、荧光分支比等参数,讨论了Er3 离子浓度变化对以上这些参数的影响.测试了Er3 :4I13/2→4I15/2跃迁对应的荧光光谱和Er3 :4I13/2能级荧光寿命.最后应用McCumber理论计算了玻璃中Er3 :4I13/2→415/2跃迁对应的受激发射截面大小.结果表明:振子强度基本上随Er3 离子浓度的增大而增强;随着Er3 离子浓度的增加,自发辐射跃迁概率A基本呈现出递增的趋势,但荧光分支比β却只有很小的变化;Er3 :4I13/2→4I15/2的发射截面随Er3 离子浓度的增大而改变很小,有效线宽都在50 nm左右. 相似文献
95.
利用平场光栅谱仪,分别在2和3 kPa的低气压下,测量了脉宽35 fs的圆偏振超强超短激光脉冲与5 mm长氙气体靶相互作用产生的波长在5~60 nm范围内的离子谱线。2 kPa时最强的跃迁为XeⅧ:4d105s(2S1/2)—4d95s5p(2P3/2)的17.085 6 nm线,3 kPa时最强的跃迁为11.343 nm的XeⅦ 4d105s2(1S0)—4d95s25f(3P1)跃迁。两种气压下,Xe均被电离到XeⅦ,XeⅧ,XeⅨ态。 相似文献
96.
利用自行设计的反应器研究了高温条件下水蒸汽对无水五硼酸钾晶体结构的影响,借助于X射线衍射、红外光谱、Raman光谱等手段分析了无水五硼酸钾晶体高温性质的振动光谱。在水蒸汽的作用下,五硼酸钾的B2O3/K2O(摩尔比)变小,X射线衍射分析表明750 ℃时晶体中有K5B19O<sub>31存在,而红外光谱与Raman光谱分析表明由于水蒸汽的作用使得晶体中的三角形B(3)—O结构单元向四面体B(4)—O结构单元转变,四面体的B(4)—O含量增加并且硼氧网络结构被进一步打断。 相似文献
97.
Zhao Wei Xinlei Zhang Huifang Nie Lin Yao Yanqin Liu Zhibing Zheng Qin Ouyang 《Molecules (Basel, Switzerland)》2022,27(3)
A family of novel efficient non-oxime compounds exhibited promising reactivation efficacy for VX and sarin inhibited human acetylcholinesterase was discovered. It was found that aromatic groups coupled to Mannich phenols and the introduction of imidazole to the ortho position of phenols would dramatically enhance reactivation efficiency. Moreover, the in vivo experiment was conducted, and the results demonstrated that Mannich phenol L10R1 (30 mg/kg, ip) could afford 100% 48 h survival for mice of 2*LD50 sarin exposure, which is promising for the development of non-oxime reactivators with central efficiency. 相似文献
98.
Transport in Porous Media - The effective slip length at the interface between pure fluid flow and porous media composed of packed spheres has been accurately characterized. In this study, as the... 相似文献
99.
基于分灾抗震设计概念,发展了基于三线性分灾模型的结构多目标优化设计方法。以防屈曲支撑为分灾构件的框架结构为例,针对分灾构件设计参数,采用多目标遗传算法进行分灾结构多目标优化设计。最终得到了分灾框架结构分灾构件用量和层间位移角等重要特性的多目标优化关系,并进行了相关讨论。结果表明,结构多目标分灾优化模型可以综合考虑结构造价和抗震性能等,并可以根据目标偏好有效地满足设计需求;分灾构件对抗震性能的作用随着震级增大而增强,使用分灾构件的结构能够更好地抵御强震的作用。 相似文献
100.
ABSTRACT In Ni-based superalloys, it is usually found that borides can strengthen the grain boundaries, thereby resulting in an increase in mechanical strength and high-temperature creep properties. Due to their importance and prevalence in Ni-based superalloys, this study employs first-principles methods to investigate the crystallographic structure, anisotropic elastic response, and electronic properties of the major borides, such as M2B, M5B3 and M3B2 (M: Cr, Mo, W), respectively, which is necessary for the assessment of complex mechanical responses of Ni-based superalloys. The results demonstrate that the studied borides are all thermodynamically and mechanically stable. Among the M x B y binary borides analysed, Cr x B y exhibits the largest shear modulus, Young’s modulus, and Vicker hardness values, and these properties increase with the increase of B contents. The studied borides display nearly isotropic elastic properties except for W5B3 and W3B2. The electronic structure analysis of M x B y shows that the strong hybridisation between M-d and B-p orbitals leads to these borides exhibiting higher theoretical hardness, and the overlapping peaks of M-d and B-p orbitals move to a lower energy area with the increase of B contents, which leads to the increase of shear and Young’s moduli of M x B y . Furthermore, for M3B2 borides, the Cr-B bonds and Cr–Cr bonds are much stronger than the W-B & Mo-B bonds, and W-W & Mo-Mo bonds, respectively, which leads to Cr x B y yielding the largest values of elastic moduli. 相似文献