111In–L–LDL and 153Gd–L–LDL as radiotracers for detection of AR4‐2J rat pancreatic tumors

Pancreatic cancer has an extremely poor prognosis, due, in part, to lack of methods for early diagnosis. The present study was designed to evaluate the potential of labeling low‐density lipoprotein (LDL) with a radionuclide using a lipid chelating agent, bis(stearylamide) of diethylenetriaminepentaacetic acid (L), to detect pancreatic tumors by gamma‐scintigraphy. Previous studies indicated that the difficulty of visualization of pancreatic tumors was due to their poor vascularization. This study compares the ability of two radiotracers, ¹¹¹In–L–LDL and ¹⁵³Gd–L–LDL to target highly vascularized rat pancreatic tumors (AR4‐2J) implanted in nude mice. Biodistribution studies showed that the tumor uptake of ¹¹¹In–L–LDL and ¹⁵³Gd–L–LDL tracers was twofold and fivefold higher respectively than with the controls (¹¹¹In citrate and ¹⁵³Gd citrate respectively). These tracers would thus be suitable for scintigraphic imaging. We show here that LDL could be employed as a delivery system for tracers such as ¹¹¹In or ¹⁵³Gd when these two radionuclides are complexed by a lipid‐chelating anchor, and that ¹¹¹In–L–LDL and ¹⁵³Gd–L–LDL enabled better visualization of the pancreatic tumor tissues, with a better result with ¹⁵³Gd–L–LDL. Copyright © 2004 John Wiley & Sons, Ltd.     

Schiff碱水杨醛苯甲酰腙的特性

研究了 Schiff碱水杨醛苯甲酰腙 (简称 SBH)晶体在 DMSO及其 DMSO- H2 O的混合溶剂中的红外光谱 ,通过 SBH氘代前后的 IR对比发现 ,羟基氢质子与混合溶剂 DMSO- H2 O(3∶ 1 ,V/ V)产生较大的相互作用。向溶有 SBH的 75 % DMSO- 2 5 % H2 O的溶液滴加 KOH发现 ,SBH分子上的 C O羰基基团先与 KOH作用 ,其后与 O H 羟基基团作用     

加热炉热过程动态操作数学模型

根据加热炉生产特点,建立了钢坯加热过程的动态操作数学模型,分析了待轧时间变化时炉内钢坯温度分布情况。并针对加热炉待轧的灰色性,采用多目标灰色局势决策方法,得出了相应合理的待轧优化控制策略。模拟结果表明:该方法具有良好的动态性能,适合于在线控制。     

Broadband spectral shaping in a Ti:sapphire regenerative amplifier

A birefringent crystal quartz plate of known thickness has been used as a spectral filter for spectral shaping in a Ti:sapphire regenerative amplifier. The spectral profile of the amplified pulse ejected from the regenerative amplifier was observed while adjusting the birefringent crystal plate in the cavity. By altering the gain spectrum, the bandwidth of the regeneratively amplified pulse was increased from 18 to 35 nm by using a 0.34-mm thick birefringent plate. The output pulse spectrum from the regenerative amplifier neared the bandwidth of the seed pulse. As a comparison, we used a coated filter outside the regenerative amplifier cavity, and the bandwidth of the regeneratively amplified pulse was stretched to 28 nm. When the bandwidth was stretched to 35 nm, the pulse was compressed to 35 fs.     

A Comparative Study on Dynamic and Static Sparsity Patterns in Parallel Sparse Approximate Inverse Preconditioning

Sparse approximate inverse (SAI) techniques have recently emerged as a new class of parallel preconditioning techniques for solving large sparse linear systems on high performance computers. The choice of the sparsity pattern of the SAI matrix is probably the most important step in constructing an SAI preconditioner. Both dynamic and static sparsity pattern selection approaches have been proposed by researchers. Through a few numerical experiments, we conduct a comparable study on the properties and performance of the SAI preconditioners using the different sparsity patterns for solving some sparse linear systems. This revised version was published online in July 2006 with corrections to the Cover Date.     

Kinetics of phenyl radical reactions with propane,n‐butane,n‐hexane,and n‐octane: Reactivity of C6H5 toward the secondary C?H bond of alkanes

The kinetics of C₆H₅ reactions with n‐C_nH_2n+2 (n = 3, 4, 6, 8) have been studied by the pulsed laser photolysis/mass spectrometric method using C₆H₅COCH₃ as the phenyl precursor at temperatures between 494 and 1051 K. The rate constants were determined by kinetic modeling of the absolute yields of C₆H₆ at each temperature. Another major product C₆H₅CH₃ formed by the recombination of C₆H₅ and CH₃ could also be quantitatively modeled using the known rate constant for the reaction. A weighted least‐squares analysis of the four sets of data gave k (C₃H₈) = (1.96 ± 0.15) × 10¹¹ exp[?(1938 ± 56)/T], and k (n‐C₄H₁₀) = (2.65 ± 0.23) × 10¹¹ exp[?(1950 ± 55)/T] k (n‐C₆H₁₄) = (4.56 ± 0.21) × 10¹¹ exp[?(1735 ± 55)/T], and k (n?C₈H₁₈) = (4.31 ± 0.39) × 10¹¹ exp[?(1415 ± 65)T] cm³ mol^?1 s^?1 for the temperature range studied. For the butane and hexane reactions, we have also applied the CRDS technique to extend our temperature range down to 297 K; the results obtained by the decay of C₆H₅ with CRDS agree fully with those determined by absolute product yield measurements with PLP/MS. Weighted least‐squares analyses of these two sets of data gave rise to k (n?C₄H₁₀) = (2.70 ± 0.15) × 10¹¹ exp[?(1880 ± 127)/T] and k (n?C₆H₁₄) = (4.81 ± 0.30) × 10¹¹ exp[?(1780 ± 133)/T] cm³ mol^?1 s^?1 for the temperature range 297‐‐1046 K. From the absolute rate constants for the two larger molecular reactions (C₆H₅ + n‐C₆H₁₄ and n‐C₈H₁₈), we derived the rate constant for H‐abstraction from a secondary C? H bond, k_s?CH = (4.19 ± 0.24) × 10¹⁰ exp[?(1770 ± 48)/T] cm³ mol^?1 s^?1. © 2003 Wiley Periodicals, Inc. Int J Chem Kinet 36: 49–56, 2004     

Effects of barium on the nonlinear electrical characteristics and dielectric properties of SnO2-based varistors

The effects of barium on electrical and dielectric properties of the SnO_2·Co_2O_3·Ta_2O_5 varistor system sintered at 1250℃ for 60min were investigated. It is found that barium significantly improves the nonlinear properties. The breakdown electrical field increases from 378.0 to 2834.5V/mm, relative dielectric constant (at 1kHz) falls from 1206 to 161 and the resistivity (at 1kHz) rises from 60.3 to 1146.5kΩ·cm with an increase of BaCO_3 concentration from 0mol% to 1.00mol%. The sample with 1.00mol% barium has the best nonlinear electrical property and the highest nonlinear coefficient (α=29.2). A modified defect barrier model is introduced to illustrate the grain-boundary barrier formation of barium-doped SnO_{2}-based varistors.     

Low-threshold, high-efficiency, high-repetition-rate optical parametric generator based on periodically poled LiNbO3

We report a high-repetition-rate optical parametric generator (OPG) with a periodically poled lithium niobate (PPLN) crystal pumped by an acousto-optically Q-switched CW-diode-end-pumped Nd:YVO_4 laser. For the maximum 1064nm pump power of 970mW, the maximum conversion efficiency is 32.9% under the conditions of 250℃, 1064nm pulse repetition rate of 22.6kHz and pulse width of 12ns, and the PPLN OPG threshold in the collinear case is less than 23.7μJ. The output power increases with the increase of the crystal temperature. The 1485－1553nm signal wave and 3383－3754nm idler wave are obtained by changing the temperature and the angle of the PPLN crystal.     

Influence of Turbid Medium Parameters on Back Scattered Intensity and Pulsewidth of Picosecond Pulse

In this paper, we simulate a practical in vivo technique in which is produced influence of turbid medium parameters on backscattered intensity and pulsewidth of picosecond for turbid tissue surface of a semiinfinite medium by a small narrow linewidth laser beams. It is shown that the interaction of the ultra short pulse and the turbid tissue is very used as researching the optical parameters of the turbid medium.     

On the evaluation of the nonisothermal kinetic parameters of (GeS2)0.3(Sb2S3)0.7 crystallization using the IKP method

The isoconversional method suggested by Friedman and the invariant kinetic parameters method (IKP) were used in order to examine the kinetics of the nonisothermal crystallization of (GeS₂)_0.3(Sb₂S₃)_0.7. The objective of the paper is to show the usefulness of the IKP method both for determining the activation parameters as well as the model of the investigated process. It was shown that the kinetic triplet [(E, A, f(α), where E is the activation energy, A is the preexponential factor, and f(α) is the differential function of conversion], which results through the application of the IKP method, depends on the set of kinetic models considered. For different sets of kinetic models, proportional values of f(α) are obtained. A criterion for the selection of this set, the use of which lead to the true kinetic triplet corresponding to the analyzed process (E = 163.2 kJ mol^?1; A = 2.47 × 10¹² min^?1 and the Avrami‐Erofeev model, A_m, for m = 2.5–2.6 was suggested. © 2004 Wiley Periodicals, Inc. Int J Chem Kinet 36: 309–315, 2004