强流RFQ的稳定性设计研究

对强流RFQ耦合间隙的确定、二极模稳定杆的设计进行了详细的研究和讨论.利用现有的RFQ冷模,进行了本征模频率的测量、场分布的调试和测量、二极模稳定杆的试验.并通过与模拟结果的比较,验证了模拟程序在RFQ腔体设计中的可靠性.同时,对影响RFQ稳定性设计的物理进行了有益的探讨.     

三溴偶氮胂褪色光度法测定土壤及化学试剂中铬（VI）

在 0 .4 8mol/L硝酸介质中 ,Cr( )与三溴偶氮胂 (TBA)发生褪色反应 ,该反应的表观摩尔吸光系数ε516nm=1.0 4× 10 5L· mol-1· cm-1,铬 ( )含量在 0— 1.0× 10 -4 g/L范围内呈良好线性关系。该法用于土样及化学试剂中 Cr( )的测定 ,结果令人满意。     

RPC读出条的阻抗匹配

文章对高阻板探测器读出条的阻抗匹配问题进行了研究;引入了一个用于计算带状线特性阻抗的经验公式.测量的特性阻抗与经验公式很好地符合,说明这个经验公式可以用于RPC读出条特性阻抗的计算,以改善RPC读出信号的质量,利于RPC探测器性能的测量.     

Self-Assembly of Micro-Parts onto Si Substrates at Liquid-Liquid Interface

We report a new approach for the self-assembly of cuboid micro-parts onto Si substrates to construct three-dimensional microstructures. To perform assembly, the Si substrates are prepared with a deep cavity array as binding sites. An aggregate composed of hundreds of uniformly aligned micro-parts is formed at the C10F18-H2O interface. The micro-parts are arranged by passing the substrate through the aggregate of micro-parts, thus the micro-parts are left on the substrate, and then the substrate is vibrated ultrasonically in the solution, making it possible for the micro-parts to fall into the cavities on the substrate. Finally the substrate is pulled out of the solution after assembly. This technique could give a high yield of up to 70%, providing a new method for micro-assembly.     

表面垂直裂痕诱发瑞利波散射的数值分析

激光激发的声表面波为材料表面缺陷的检测提供了有力的工具.针对含缺陷材料在模型边界上的复杂性,建立了基于平面应变的有限元模型并选取了相同厚度但含有不同深度的表面裂痕的单层铝板进行了对比计算,得到了声表面波经过不同深度的表面裂痕时产生的反射及透射信号波形的时域特征.进而引入了基于Wigner-Ville分布理论的时-频分析方法计算裂痕前、后散射的瞬态表面波的能量在时间-频率平面内分布的情形.结果显示：声表面波接近中心频率的某一频率成分在经过深度小于其中心波长的表面缺陷时,随着裂痕深度的增加,对应于该频率的反射系数呈现单调递增的趋势;而透射系数呈现递减的特征,这一结果可以为激光超声检测表面缺陷提供一种定量的表征手段.     

Phenylene vinylene‐based electroluminescent polymers with electron transport block in the main chain

We report a new route for the design of soluble phenylene vinylene (PV) based electroluminescent polymers bearing electron‐deficient oxadizole (OXD) and triazole (TZ) moieties in the main chains with the aryloxy linkage. Both series of the PV‐based polymers were prepared by Wittig reaction. By properly adjusting the OXD and/or TZ content through copolymerization, we can achieve an enhanced balance of hole‐ and electron injections, such that the device efficiency is significantly improved. Light‐emitting diodes fabricated from P1, P2, P3, P4, P5, P6, and P7 with the configuration of Indium–Tin Oxide (ITO)/Poly (styrene sulfonic acid) doped poly (ethylenedioxythiophene) (PEDOT)/polymer/Ca/Al, emit bright green light with the maximum peak around 500 nm. For the device using the optimal polymer (P4) as emitting layer, a maximum brightness of 1300 cd/m² at 20 V and a maximum luminance efficiency of 0.325 cd/A can be obtained. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 3469–3478, 2006     

Synthesis and application as polymer electrolyte of hyperbranched polyether made by cationic ring‐opening polymerization of 3‐{2‐[2‐(2‐hydroxyethoxy)ethoxy]ethoxymethyl}‐3′‐methyl‐oxetane

A novel cyclic ether monomer 3‐{2‐[2‐(2‐hydroxyethoxy)ethoxy]ethoxy‐methyl}‐3′‐methyloxetane (HEMO) was prepared from the reaction of 3‐hydroxymethyl‐3′‐methyloxetane tosylate with triethylene glycol. The corresponding hyperbranched polyether (PHEMO) was synthesized using BF₃·Et₂O as initiator through cationic ring‐opening polymerization. The evidence from ¹H and ¹³C NMR analyses revealed that the hyperbranched structure is constructed by the competition between two chain propagation mechanisms, i.e. active chain end and activated monomer mechanism. The terminal structure of PHEMO with a cyclic fragment was definitely detected by MALDI‐TOF measurement. A DSC test implied that the resulting polyether has excellent segment motion performance potentially beneficial for the ion transport of polymer electrolytes. Moreover, a TGA assay showed that this hyperbranched polymer possesses high thermostability as compared to its liquid counterpart. The ion conductivity was measured to reach 5.6 × 10^?5 S/cm at room temperature and 6.3 × 10^?4 S/cm at 80 °C after doped with LiTFSI at a ratio of Li:O = 0.05, presenting the promise to meet the practical requirement of lithium ion batteries for polymer electrolytes. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 3650–3665, 2006     

Synchronization of Coupled Oscillators on Newman-Watts Small-World Networks

We investigate the collection behaviour of coupled phase oscillators on Newman-Watts small-world networks in one and two dimensions. Each component of the network is assumed as an oscillator and each interacts with the others following the Kuramoto model We then study the onset of global synchronization of phases and frequencies based on dynamic simulations and finite-size scaling. Both the phase and frequency synchronization are observed to emerge in the presence of a tiny fraction of shortcuts and enhanced with the increases of nearest neighbours and lattice dimensions.     

13.5—14.6MeV中子能区锗的同位素反应截面的测量

报道了在13.5—14.6MeV中子能区用活化法测得的⁷⁶Ge(n,2n)⁷⁵Ge, ⁷⁰Ge(n,2n)⁶⁹Ge, ⁷⁰Ge(n, p)⁷⁰Ga, ⁷²Ge(n,p)⁷²Ga, ⁷³Ge(n,p)⁷³Ga, ⁷²Ge(n,α)^69mZn和⁷⁴Ge(n, α)^71mZn的反应截面值. 中子注量用⁹³Nb(n,2n)^92mNb反应截面得到. 单能中子由T(d,n)⁴He反应获得. 同时还列举了已收集到的文献值以作比较.     

a-Si:H掺杂机理的研究

本文利用CNDO/2量子化学理论方法,对P和B原子在四面体配位的Si₄₆和Sl₄₆H₆₀H₄^*原子集团中置换Si原子前后的原子集团能量和能态分布变化进行了计算.计算结果表明:1)在Si₄₆H₆₀H₄^*原子集团中用P(或B)置换引Si原子后在能隙中明显地出现施主(或受主)态子带,同样在Si_{46相似文献}