Phasing of three vircators simulated in terms of coupled van der Pol oscillators

Phase synchronization in a system of three virtual-cathode microwave oscillators (vircators) simulated by coupled van der Pol oscillators is studied. The phasing dynamics of the vircators is visualized with the phase portraits of the system in the triangular coordinates. Different phasing conditions are found.     

Fundamental aspects of initiated oxidation of tridecane and polyethylene in solutions

Specific features of the initiated oxidation of polyethylene and its low-molecular-weight analogue tridecane, associated with the occurrence of the process in the short-chain mode, were studied.     

Cosmic γ-ray bursts: Observations and modeling

It is now commonly accepted that cosmic γ-ray bursts (GRBs) are of cosmological origin. This conclusion is based on the statistical analysis of GRBs and the measurements of line redshifts in GRB optical afterglows, i.e., in the so-called long GRBs. In this review, the models of radiation and models of GRB sources are considered. In most of these models, if not in all of them, the isotropic radiation cannot provide the energy release necessary for the appearance of a cosmological GRB. No correlation is noted between the redshift, the GRB-spectrum shape, and the total detected energy. The comparison between data obtained in the Soviet experiment KONUS and the American experiment BATSE shows that they substantially differ in statistical properties and the detection of hard x-ray lines. The investigation of hard gamma (0.1–10 GeV) afterglows, the measurement of prompt optical spectra during the GRB detection, and the further investigation of hard x-ray lines is of obvious importance for gaining insight into the GRB origin. Observations of two bright optical GRB afterglows point to the fact that an initially bright optical flare is directly related to the GRB itself, and the subsequent weak and much more continuous optical radiation is of a different nature. The results of observations of optical GRB afterglows are discussed. They point to the fact that the GRBs originate in distant galaxies with a high matter density, where intense star formation takes place. The interaction of the cosmological GRB radiation with a dense surrounding molecular cloud results in the appearance of long-duration (up to 10 years) weak optical afterglows associated with the heating and reradiation of gas. Results of 2D numerical simulation of the heating and reradiation of gas in various variants of the relative disposition of GRB and molecular clouds are presented. In conclusion, the possible relation between the so-called short GRBs and recurrent sources of soft γ rays in our Galaxy, the so-called “soft gamma repeaters,” is discussed.     

Elektrische Charakterisierung von Hochfrequenz-Niederdruck-Gasentladungen

In recent years there has emerged significant interest in low pressure radio frequency (rf) glow discharges which are used widely particulary in IC fabrication. Various parameters of the rf glow discharge have been found to be useful for its electrical characterization; however, there is no uniformity and agreement. Extensive experimental investigations on various discharge systems have shown, that the self-bias on the rf driven electrode, the complex conductivity and the breakdown characteristic are preferable parameters of rf discharges. Advantageously the self-bias and the complex conductivity should be presented in dependence on the pressure and the applied rf voltage. The discharge current cannot be measured quite accurately due to currents via leaky capacitors and the deviations from a sinusoidal form of the current due to nonlinearities.     

Chemical analysis and distribution investigation of trace elements in indium matrix by spark source mass spectrometry

Summary High-purity indium was analysed by spark source mass spectrometry, using electrical and photoplate detection. For the calibration of the differences in elemental sensitivity, a standard sample was prepared in which 10 impurities were determined by graphite furnace atomic absorption spectrometry. In this way accuracies of less than 40% were obtained for relatively homogeneous elements at ppm and sub-ppm level. About 40 elements could be determined with detection limits of 10 to 30 ppb. Two pattern recognition methods, principal component analysis and clustering analysis, were applied to obtain information on trace element distribution, which indicated that a number of elements were strongly spatially correlated in the analysed sample.

---

Chemische Analyse und Verteilungsbestimmung von Spurenelementen in Indium-Matrix durch Funkenquellen-Massenspektrometrie

---

On leave from: Department of Chemistry, Nanjing Normal University, Nanjing, People's Republic of China     

Latex particles bearing hydrophilic grafted hairs with controlled chain length and functionality synthesized by reversible addition–fragmentation chain transfer

A method is described for synthesizing latex particles with anchored hairs by the grafting of hydrophilic chains, synthesized by reversible addition–fragmentation chain transfer, onto functionalized latex particles. These have the potential to bind biologically active species. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 1188–1195, 2003     

1,1,3-Trimethyl-3-phenylindan as a Luminescent Additive to a Plastic Scintillator Based on Poly(methyl Methacrylate)

The luminescence and scintillation properties of poly(methyl methacrylate) containing 1,1,3-trimethyl-3-phenylindan were studied.     

Mass‐lumping or not mass‐lumping for eigenvalue problems

In this article we analyze the effect of mass‐lumping in the linear triangular finite element approximation of second‐order elliptic eigenvalue problems. We prove that the eigenvalue obtained by using mass‐lumping is always below the one obtained with exact integration. For singular eigenfunctions, as those arising in non convex polygons, we prove that the eigenvalue obtained with mass‐lumping is above the exact eigenvalue when the mesh size is small enough. So, we conclude that the use of mass‐lumping is convenient in the singular case. When the eigenfunction is smooth several numerical experiments suggest that the eigenvalue computed with mass‐lumping is below the exact one if the mesh is not too coarse. © 2003 Wiley Periodicals, Inc. Numer Methods Partial Differential Eq 19: 653–664, 2003