A new solution to the problem of an acoustically transparent body

The method of active impedance matching is applied to the well-known problem of an acoustically transparent body. Two laws of active force control, by velocity and by pressure, are obtained for solving the problem.     

Measured and calculated vertical structure of a sound field in the ocean

Results of measuring the monochromatic sound field with a dipping probe in the deep ocean are presented. The sound speed profile in the region of measurements had a minimum at a depth of 1600 m. The experiment was carried out in the Atlantic Ocean with the use of two vessels separated by a distance of approximately four ray cycles (～240 km). The experimental data are compared with the calculations based on a new concept of the Brillouin waves for describing the vertical structure of the sound field produced by rays. It is shown that a satisfactory agreement between experiment and calculation can be achieved by fitting the parameters of the experiment. Such a procedure allows one to refine or even to determine the experimental conditions, which not are always known. The proposed method of calculation offers an opportunity for solving inverse problems of ocean acoustics.     

Effects of localization of the areas of sound scattering by surface wind waves

Experimental studies of the scattering of a monochromatic sound signal by a rough sea surface are carried out. The signal is produced by a point source in a shallow-water basin. The measurements are performed with the use of horizontal and vertical linear receiving arrays. The experimental data are compared with the estimates obtained on the basis of the model developed by the authors for resonant sound scattering by surface roughness. A satisfactory agreement between the experiments and the calculations is achieved. It is shown that the scattered signal is formed within small surface areas, whose sizes have the same order of magnitude as the first Fresnel zone with respect to the source and the receiving system.     

Dispersion of waves in a plane acoustic layer with flexible elastic walls

A plane acoustic layer bounded by elastic membranes is considered. Dispersion relations for symmetric and antisymmetric waves are derived. The limit behavior of dispersion curves is investigated for wave numbers tending to zero and to infinity. With the use of the resulting asymptotic expansions, the two-point Pade approximations are constructed. The orthogonality relations for eigenmodes are presented.     

The total acoustic impedance of a prolate spheroid performing transverse oscillatory movements

Using the theory of spheroidal wave functions, the total acoustic impedance is determined for a prolate spheroid performing transverse translational and rotational oscillatory movements. Expressions for the radiation resistance, the added mass, and the added moment of inertia are derived. It is shown that, in the lowfrequency approximation, this mass and moment of inertia reach limiting values identical to hydrodynamic ones. The components of the total acoustic impedance are calculated for spheroids of different relative thicknesses at an arbitrary frequency.     

DX<Superscript>−</Superscript> center formation in planar-doped GaAs:Si in strong electric fields

The kinetics of current decay and partial restoration in planar doped GaAs:Si due to the formation of DX^? centers in strong electric fields has been experimentally studied. The existence of thresholds with respect to the field strength and donor concentration is explained. A model of the DX^? center formation is proposed, which is based on the notions about variation of the depth and width of a potential well created by planar doping, caused by the redistribution of hot electrons between quantum confinement subbands. As a result, the energy level of DX^? centers, which is situated above the potential well depth in the absence of strong field, decreases and falls within the potential well. This makes possible the DX^? center formation, provided that hot electrons, occupying the resonance electron levels in the conduction band, simultaneously excite local vibrational modes.     

Characteristics of high-power radiating imploding discharge with cold start

A qualitative model of the dynamics of a multiterawatt radiating Z-pinch with cold start and high rate of current rise is proposed. The model is used to analyze discharges with currents I ～ 2–5 MA (with dI/dt > 10¹³ A/s) through uniform or structured plasma-producing loads, including wire arrays. The most important consequence of cold start is that spatially nonuniform plasma production is prolonged to almost the entire current rise time. Under these conditions, the Ampére force begins to play a dominant role in the plasma dynamics before the plasma-producing load is completely transformed into an accelerated plasma. The results of computations of wire-array vaporization are presented. A formula is proposed for estimating the highest attainable velocity of plasma flow into a heterogeneous liner driven by the Ampére force. It is shown that local imbalance between radial motion of the produced plasma and supply of the plasma-producing substance to be ionized leads to axially nonuniform breakthrough of magnetic flux into the liner, which precedes plasma collapse. The magnetic-flux breakthrough gives rise to a chaotic azimuthal-axial plasma structure consisting of radial plasma jets of relatively small diameter, which is called a radial plasma rainstorm. The breaking-through azimuthal magnetic flux obstructs further current flow in the breakthrough region. Analyses of Z-pinch implosion based on the theory of Rayleigh-Taylor instability or the snowplow model are incorrect under the plasma-rainstorm conditions. The processes taking place in a stagnant Z-pinch include conversion of the energy carried by the current-generated magnetic field into turbulent MHD flow of the ion component of the plasma, its convective mixing with magnetic field, heating, energy transfer from ions to electrons, and emission from the plasma. Under typical experimental conditions, emission plays a key role in the energy balance in an imploding pinch. Z-pinch is modeled by an electric-circuit component that has a time-dependent nonlinear impedance and consumes the magnetic energy supplied by a generator through a magnetically insulated transmission line (MITL). The peak power reached in the circuit is comparable to the peak soft X-ray power output emitted by the pinch in terms of magnitude and timing. Optimum matching conditions are formulated for the generator-MITL-pinch circuit.