Effect of freezing rate on physical stability of lyophilized cationic liposomes

Factors affecting the storage stability of lyophilized cationic liposomes were investigated using liposomes prepared with various excipients and by different freezing rates, either quick freezing (freezing by immersion into liquid nitrogen) or slow freezing (cooling to -50 degrees C at a rate of -10 degrees C/h). Increases in the particle size of cationic liposomes observed during freeze-drying were inhibited by the addition of sucrose, trehalose and sucrose-dextran mixtures (1 : 1 and 2 : 1 by weight). The storage instability of the formulations, as indicated by changes in particle size, was affected by their glass transition temperature (T(g)). Addition of high-T(g) excipients resulted in smaller increases in the particle size, indicating improvement of storage stability. The storage stability of cationic liposome formulations was also affected by freezing rate. Formulations prepared by slow freezing exhibited better stability. Longer shear relaxation times were observed for formulations prepared by slow freezing compared with those prepared by quick freezing. This indicates that formulations prepared by slow freezing have a lower matrix mobility, which may result in better storage stability. T(g) or (1)H-NMR relaxation measurements could not detect differences in matrix mobility between formulations prepared by different freezing rates. Shear relaxation measurements seem to be a useful method for evaluating the storage stability of cationic liposome formulations.     

Photoinduced ionic polymerization. VII. Cationic polymerization of cyclohexene oxide in solid state

Photopolymerization of cyclohexene oxide in the presence of electron acceptors was studied in a bulk system (in liquid as well as in solid states). The polymerization was proved to proceed by a cationic mechanism in both states by the effect of inhibitors. In a liquid phase the light intensity dependence of the rate of polymerization and the molecular weight distribution showed a contribution of a free ionic polymerization. Any discontinuous phenomenon in the rate as well as in the molecular weight was not discerned between liquid(above ?36°C) and plastic crystal (between ?36 and ?81°C) phases. A quantum yield of monomer consumption as high as 8 × 10³ was observed in the plastic crystal phase. Below ?81°C in the normal crystal phase the rate as well as the molecular weight was remarkably suppressed.     

Three novel quassinoids, javanicolides A and B, and javanicoside A, from seeds of Brucea javanica

Two novel quassinoids, javanicolides A and B, and one novel quassinoid glucoside, javanicoside A were isolated from the seeds of Brucea javanica Merr. (Simaroubaceae), along with four known quassinoids, yadanziolides A and D, and bruceins D and E, and two known quassinoid glucosides, yadanziosides D and L. Their structures were elucidated by the analysis of spectral data and chemical evidence.     

Solution-phase synthesis of alpha-human atrial natriuretic peptide (alpha-hANP)

Alpha-human atrial natriuretic peptide (alpha-hANP) was synthesized by assembling six peptide fragments in solution followed by deprotection with HF and subsequent air-oxidation. The trimethylbenzyl group was employed as an S-protecting group of cysteine. The HF-dimethylselenide-m-cresol system was employed as a final deprotecting reagent and, at the same time, as a reducing reagent of Met(O). Synthetic alpha-hANP elicited potent diuretic and natriuretic activity in rats.     

Single molecular multianalyte sensor: jewel pendant ligand

[structure: see text] The jewel pendant ligand has multiple chromogenic units combined in a single molecule with the dyes linked to a semiselective binding site by three heteroatoms (O, N, S) having different HSAB characteristics, to indicate diverse response to individual transition metal ions. Using a single-molecular multianalyte sensor, multiple analytes could be determined with a minimal sensing system.     

Comparison of the glass transition temperature and fragility parameter of isomalto-olygomer predicted by molecular dynamics simulations with those measured by differential scanning calorimetry

The purpose of this study is to examine whether molecular dynamics (MD) simulations using a commercially available software for personal computers can estimate the glass transition temperature (Tg) of amorphous systems containing pharmaceutically-relevant excipients. MD simulations were carried out with an amorphous matrix model constructed from isomaltoheptaose, and the Tg estimated from the calculated density versus temperature profile was compared with the Tg measured by differential scanning calorimetry (DSC) for freeze-dried isomalto-oligomer having an average molecular weight close to that of isomaltoheptaose. The Tg values determined by DSC were lower by 10 to 20 K than those extrapolated from the Tg values estimated by MD simulation. Fragility parameter was estimated to be 56 and 51 from MD simulation and from DSC measurement, respectively. Thus, the results suggest that MD simulation can provide approximate estimates for the Tg and fragility parameter of amorphous formulations. However, a reduction of the cooling rate, achievable by sufficiently elongating the simulation duration, is necessary for more accurate estimation.     

Structural variety of membrane permeable peptides

Peptide-mediated protein delivery into living cells has been attracting our attention. Among the peptides that have been reported to have carrier activity, the one from the human immunodeficient virus (HIV)-1 Tat has been most often used for the introduction of exogenous macromolecules into cells. We have shown that not only the Tat peptide, but also various arginine-rich peptides showed very similar characteristics in translocation, and the possible presence of ubiquitous internalization mechanisms among the arginine-rich peptides has also been suggested. These arginine-rich peptides includes ones derived from HIV-1 Rev and flock house virus coat proteins. The linear- and branched-chain peptides containing approximately 8 residues of arginine also show a similar ability. In this review, we present the structural variety of membrane permeable peptides and provide a survey of the findings on the translocation of these peptides through the cell membranes.     

DNA-bleomycin interaction: Nucleotide sequence-specific binding and cleavage of DNA by bleomycin

Biosynthetic intermediates and synthetic analogues of bleomycin (BLM) have been investigated for their metal binding, dioxygen activation, and DNA cleavage. Molecular O₂ was activated by the Fe(II) complex of a synthetic model ligand. Nucleotide sequence specificities in DNA cleavage by the BLM-Fe(II) and deglyco-BLM-Fe(II) complexes were almost identical. It has been shown that (1) the β-aminoalanine-pyrimidine-β-hydroxyhistidine portion of BLM is essential for the metal binding and dioxygen activation and (2) the bithiazole moiety contributes to the specific binding to guanine base of DNA.     

Cyclophosphamides from aminosugars and aminonucleosides

Condensation of bis-(2-chloroethyl)phosphoramidic dichloride with 3′-amino-3′-deoxy-N,N-dimethyladenosine afforded the 2′,3′-cyclicphosphorodiamidate (III). By an improved synthesis, methyl 3-amino-3-deoxy-β-D-ribofuranoside was obtained as a model compound for conversion to the analogous 2,3-cyclicphosphorodiamidate (XII). Existence of the latter as two diastereomers due to phosphorus asymmetry was shown by nmr analysis, using comparison with the 5-(O-p-nitrobenzoate) (XIII) as a basis for assignments.     

Fabrication of PbTiO3 Ceramic Fibers by Sol-Gel Processing

The sol-gel processing was applied to the fabrication of PbTiO₃ fibers. Pb(CH₃COO)₂·3H₂O and Ti(OC₃H ₇ ⁱ )₄ were refluxed with stirring in 2-methoxyethanol to form Pb-methoxyethoxide and Ti-methoxyethoxide, respectively, followed by mixing with stirring in 2-methoxyethanol to form Pb−Ti double alkoxide. The hydrolysis and polycondensation reaction of this double alkoxide gave polymerized products, and as a result the viscosity of the solution increased, suggesting that linear polymers were produced through the hydrolysis and polycondensation reaction. Homogeneous PbTiO₃ gel fibers were drawn from the spinnable viscous solutions, which were wellcrystallized into perovskite type PbTiO₃ at 650°C. The heat-treated fibers were a few centimeters long and from 10 to 100 μm in diameter. The fiber was made up of extremely uniform grains. Electron diffraction revealed a preferred growth of (101) planes along the fiber axis, which might be due to the linear molecular characteristics of the alkoxide.