磷脂酰胆碱与牛血清白蛋白相互作用的FT-IR研究

利用傅立叶变换红外(FT-IR)和拉曼(FT-Raman)光谱研究了高浓度磷脂酰胆碱(PC)与牛血清白蛋白(BSA)的相互作用,及Eu3＋对该作用的影响.FT-IR结果显示,PC/BSA混合体系中二者的相互作用主要发生在PC头部极性基团,且这一作用随BSA含量的增加而增强,作用后蛋白质二级结构中α螺旋的比例有所增加. FT-Raman光谱说明PC与BSA的相互作用影响磷脂CH链的排列有序程度. PC/BSA/Eu3＋体系的红外光谱显示, Eu3＋与PC的磷氧键发生了强相互作用,并使蛋白α螺旋的比例进一步增加.     

乙基乙酰胺热解反应机理的MO研究

对于烷基乙酰胺的初始热解反应机理, 通常认为与酯类的热解反应相类似。Maccoll和Nagra通过对该热解反应的动力学研究, 认为两者存在不同。差异之一, 烷基乙酰胺存在两种可能的热解途径【参见本文(129页)前述反应方程(1),(2)】。而在酯类热解反应中(2)的活化能过高, 且四元环过渡态极不稳定。差异之二, 极性溶剂(比如乙酸)对酰胺热解反应的催化作用不明显, 而对酯类等气相热解反应的催化作用是十分显著的。为此, 我们用MINDO/3分子轨道法对乙基乙酰胺的初始热解反应进行了较全面的研究。用能量梯度法对此反应的反应物、中间体和生成物的平衡几何构型进行了全优化。(如图1所示)用极小能量途径法分别寻找反应(1)和反应(2)的初始过渡态, 继而用Powell法全优化过渡态的几何构型, 计算所得的过渡态TS1、TS2和TS3分别见图2a, 图3a和图4a。为了确证这些过渡态, 进行了振动分析研究, 结果表明这些过渡态的力常数矩阵的诸本征值中均只有一个负值, 且虚振动模式展示了走向各自的反应物和生成物的趋势, (如图2b,图3b和图4b所示)。它们的总能量及反应(1)和反应(2)的活化能列于表1. 对整个热解反应(1)作了内禀反应坐标(IRC)理论分析, 反应历程见图5所示. 与IRC相应的总能偶极矩以及部分关键的键长和原子净电荷变化一并列于表2.本文研究结果表明, 在乙基乙酰胺的初始反应中主反应即反应(1)与酯类反应相类似, ...     

Oxidative coupling of methane over Sr?Ti, Sr?Sn perovskites and corresponding layered perovskites

The layered perovskites Sr₂TiO₄ and Sr₂SnO₄ are more active and selective for the oxidative coupling of methane at 1073 K than the corresponding perovskites SrTiO₃ and SrSnO₃. The role of the surface oxygen species for this reaction is discussed.     

The research on the high quality TiO2, MoO3-doped WO3 electrochromic film

The high quality TiO2, MoO3-doped WO3 electrochromic film was prepared by the sol–gel method for the first time. The sol, which has hydrogen peroxide (H2O2) and oxalic acid (H2C2O4), was very stable at room temperature and quite suitable for the deposition of films. The WO3 electrochromic film prepared from this doped sol had excellent performance, such as short response time, no cracks, good adhesion to the substrate, high coloring efficiency and longevity of service.     

Simultaneous Determination of Four Flavonoids in Pigeonpea [Cajanus cajan (L.) Millsp.] Leaves Using RP-LC-DAD

A simple and accurate RP-HPLC method using photodiode array detection (PAD) was developed for the simultaneous determination of four flavonoids, namely quercetin (QU),luteolin(LU),apigenin(AP) and isorhamnetin (IS) in pigeonpea leaves.Extract samples were separated on HIQ SIL C₁₈V column using methanol-acetonitrile-water(31:10:59, v/v/v) as mobile phase.The flavonoids were detected at 254.5 nm for QU and IS, and at 345 nm for LU and AP.Contents were determined with satisfactory repeatability (R. S. D. < 2.2%) and recovery (97.27 – 99.98%). The developed method was found to be simple and efficient.     

Effect of multi-walled carbon nanotubes on non-isothermal crystallization kinetics of polyamide 6

The non-isothermal crystallization behaviors of multi-walled carbon nanotubes (MWNTs)/polyamide 6 (PA6) composites were investigated by differential scanning calorimetry (DSC). Three methods, namely, Avrami, Ozawa and Mo, were carried out to analyze the non-isothermal crystallization data. The results showed that the MWNTs in PA6 acted as effective nucleation agents. However the crystallization rate of composites obtained was lower than that of the neat PA6. It is indicated that the presence of MWNTs influenced the mechanism of nucleation and the growth of PA6 crystallites.     

高效液相色谱荧光检测法测定瓜子中的4-氨基丁酸

在众多的氨基酸中，4-氨基丁酸是一种非蛋白质类氨基酸，它在医学上是一种抑制性神经递质，由于其自身的特点，一些常规的直接测定法灵敏度较低。尽管对其测定有较多报道，但采用柱前衍生的分离测定的报道相对较少，且测定结果不很理想。本实验采用新型荧光试剂咔唑-9-乙基氯甲酸酯(CEOC)作为衍生试剂在Hyperil C18柱上分离测定了4-氨基丁酸(GABA)。结果表明，所建立的方法简单、快速，灵敏度高。     

EFFECT OF MOLECULAR WEIGHT OF PDMS ON MORPHOLOGY AND MECHANICAL PROPERTIES OF PP/PDMS BLENDS

 A series of polydimethylsiloxane (PDMS) with varied molecular weights (Mw = 3 &#61620; 106, 1 &#61620; 106 and 0.5 &#61620; 106) were melt blended with PP to investigate the effect of PDMS molecular weight (MW) on the morphology and mechanical properties of PP/PDMS blends. Scanning electron microscopic (SEM) examination showed that the size of PDMS domains was dependent on the MW of PDMS. It was found that the lower the value of PDMS MW, the better dispersion of the PDMS domains in the PP matrix. Tensile and Izod impact tests revealed that the addition of PDMS with lower MW would lead to a more significant increase in impact strength of the blends compared with the blends with higher MW ones, while the influence of the molecular weight on tensile strengths of the blends was relatively small in the MW range studied. Differential scanning calorimetry (DSC) results also showed that the crystallization temperature of PP was increased with decreasing PDMS MW, indicating a better nucleation capability of lower MW of PDMS. Melting flow rate (MFR) measurements indicated that the processibility of PP could be enhanced by adding PDMS, and again the lower MW PDMS resulted in better data. Our work demonstrates that not only the processibility but also the mechanical properties of PP could be enhanced to a more significant degree by using low MW PDMS than the higher ones.     

HMS和NaY固载酒石酸钛配合物的研究

利用化学键合和“瓶中造船”方法,成功地将酒石酸钛配合物接枝到HMS(heragonal mesoporous silicas)上或包络合于微孔NaY内.FT-IR表征表明酒石酸钛在HMS上是通过与载体表面羟基发生交换作用而被固载的;在NaY载体上则是通过包络合被封装在载体的超笼内.UV-Vis可见漫反射表征表明两类固载型催化剂有着相似的钛配位环境.在催化肉桂醇环氧化反应中,HMS键合型催化剂的反应转化率比NaY包络型催化剂的高;但后者在环氧化选择性上要高于前者.回收样品的重复使用实验结果表明,两类固载型催化剂在重复使用过程中均存在不同程度的失活.     

Molecular and nanoscale materials and devices in electronics

Over the past several years, there have been many significant advances toward the realization of electronic computers integrated on the molecular scale and a much greater understanding of the types of materials that will be useful in molecular devices and their properties. It was demonstrated that individual molecules could serve as incomprehensibly tiny switch and wire one million times smaller than those on conventional silicon microchip. This has resulted very recently in the assembly and demonstration of tiny computer logic circuits built from such molecular scale devices. The purpose of this review is to provide a general introduction to molecular and nanoscale materials and devices in electronics.