Comparison of the acidity of residual silanol groups in several liquid chromatography columns

The silanol acidity of Waters Resolve C18, Waters Resolve silica, Waters Symmetry C18, Waters Symmetry silica, Waters XTerra MS C18 and underivatized XTerra columns has been measured from the retention of LiNO3 with a methanol/water (60:40) mobile phase buffered to different pH values. The Li+ cation is retained by cationic exchange with the background cation of the mobile phase (Na+) through the ionized silanols. The number of active silanols increases in the order: XTerra MS C18 < Symmetry C18 < underivatized XTerra < Resolve C18 < Resolve silica approximately equal to Symmetry silica. XTerra MS C18 does not present any residual silanol acidity up to s(s)pH 10.0 (pH in 60% methanol) as measured by LiNO3. The underivatized XTerra packing and Symmetry C18 present active silanols only at s(s)pH values higher than 7.0. For the other three columns, two different types of silanols with different acidity (s(s)pKa values about 3.5-4.6 and 6.2-6.8, respectively) have been observed. Symmetry C18 shows evidence of the presence of active basic sites that retain NO3- by anionic exchange.     

Yellowing and IR-changes of spruce wood as result of UV-irradiation

The yellowing and IR-changes of spruce wood as a result of UV-irradiation were studied using two different types of xenon lamps (lambda>300 nm; I(o)=50 mW cm(-2) and lambda>280 nm; I(o)=17.5 mW cm(-2)). Changes in the IR spectra as well as the yellowing of the irradiated wood surfaces show the influence of UV light on the wood modules. The UV-irradiation (72 h; lambda>300 nm; I(o)=50 mW cm(-2)) decreased the lignin content on the surface by up to 20% of the original values. The colour difference of yellowing (deltaE) exhibited a systematic trend to higher values with increasing irradiation time. Our results show that the photoyellowing (UV-Vis detection) correlates very well with lignin degradation (IR detection). This result is in agreement with the quinone formation as the chromophoric reaction product of lignin decay. The degradation, yellowing, and oxidation kinetics differed only little using different light sources. The absorbed light intensity, which depends on wavelength, the intensity distribution of the light source and the absorption spectrum of lignin, influenced the degradation rate. Under the current experimental conditions, the absorption spectrum of lignin was the most important factor. Therefore, irradiation with lambda>280 nm is useful for rapidly monitoring the UV-degradation of wood     

Metal- and ligand-directed one-pot syntheses,crystal structures,and properties of novel oxo-centered tetra- and hexametallic clusters

Starting from closely related metal-ligand combinations, completely different oligomeric metal clusters are synthesized. Whereas, picoline-tetrazolylamide HL(1) (1) and zinc or nickel acetate afforded [2x2] grids [M(4)(L(1))(8)] (2), slightly different N-(2-methylthiazole-5-yl)-thiazole-2-carboxamide HL(2) (5 a) and nickel acetate yielded the monometallic complex [Ni(L(2))(2)(OH(2))(2)] (6). In contrast, reaction of 5 a with zinc acetate produced the tetrametallic zinc cluster [Zn(4)O(L(2))(4)(OAc)(2)] (7). Even more surprising, when 3-methyl-substituted HL(3) (5 b) instead of 2-methyl-substituted HL(2) (5 a) was allowed to react under identical conditions with zinc acetate, the cluster [Zn(4)O(L(3))(4)Cl(2)] (8) crystallized from dichloromethane. Clusters 7 and 8 are isostructural. As for 7, in 8 two of the edges of the tetrahedron of zinc ions are doubly bridged, two are singly bridged, and the other two are nonbridged. On the other hand, when iron(II) acetate under aerobic conditions was allowed to react with 5 a, the unprecedented complex [[Fe(3)O(L(2))(2)(OAc)(4)](2)O] (9) was isolated. Cluster 9 is composed of two trimetallic, triangular mu(3)-O(2-)-centered [Fe(3)O(L(2))(2)(OAc)(4)](+) modules, linked by an almost linear mu(2)-O(2-) bridge. The M?ssbauer spectrum together with cyclic voltammetric and square-wave voltammetric measurements of 9 are reported, and 6-9 were characterized unequivocally by single-crystal X-ray structure analyses.     

Structural control of surface layer proteins at electrified interfaces investigated by in situ Fourier transform infrared spectroscopy

In situ Fourier Transform Infrared (FTIR) Spectroscopy complemented by Electrochemical Quartz Microbalance (EQMB) investigations allowed a detailed insight into the influence of the electrode potential on competing adsorption processes and bonding mechanisms of buffer ions and S-layer protein molecules of Lysinibacillus sphaericus CCM2177 at an electrified liquid/gold interface. The S-layer proteins adsorb on gold polarized positively of the point of zero charge by displacing perchlorate anions in the Helmholtz plane by their carboxylate groups. This is indicated by an increase of the peptide and carboxylate infrared absorption signals accompanied by a decrease of the perchlorate signal. S-layers interlinked laterally with Ca(2+) ions, positive of the point of zero charge, resulted in the formation of a crystalline layer participating in the Helmholtz layer. In contrast to the absence of the Ca(2+)-linkers, S-layers remain structurally intact also in the negative polarization domain where the Helmholtz layer is solely sustained by mainly solvated cations without participation of the negatively charged protein carboxylate functions.     

Bromo­di­methyl(N‐methyl­pyrrolidin‐2‐one‐O)­tin(IV)‐di‐μ‐bromo‐bromo­di­methyl­tin(IV)

The preparation and X‐ray analysis of the title compound, [Sn₂Br₄(CH₃)₄(C₅H₉NO)], are described. The compound contains two Sn atoms in the asymmetric unit, that complexed by N‐methyl­pyrrolidin‐2‐one being hexacoordinated (a), the other exhibiting pentacoordination (b). The most important features are three different Sn—Br bond lengths at both Sn atoms with the following values: (a) 2.5060 (9), 2.7152 (10) and 3.7118 (10) Å; (b) 2.5084 (10), 2.5279 (9) and 3.5841 (10) Å.     

Phosphine-Catalyzed [4+1] Cycloadditions of Allenes with Methyl Ketimines,Enamines, and a Primary Amine

Unprecedented phosphine-catalyzed [4+1] cycloadditions of allenyl imides have been discovered using various N-based substrates including methyl ketimines, enamines, and a primary amine. These transformations provide a one-pot access to cyclopentenoyl enamines and imines, or (chiral) γ-lactams through two geminal C−C bond or two C−N bond formations, respectively. Several P-based key intermediates including a 1,4-(bis)electrophilic α,β-unsaturated ketenyl phosphonium species have been detected by ³¹P NMR and HRMS analyses, which shed light on the postulated catalytic cycle. The synthetic utility of this new chemistry has been demonstrated through a gram-scaling up of the catalytic reaction as well as regioselective hydrogenation and double condensation to form cyclopentanoyl enamines and fused pyrazole building blocks, respectively.     

The Diammoniates of dipotassiumtetraethinylozincate and -cadmate: K2M(C2H)4.2NH3 (M = Zn, Cd)

By reaction of KC(2)H and K(2)Zn(CN)(4) in liquid ammonia, the diammoniate K(2)Zn(C(2)H)(4).2NH(3) was obtained. K(2)Cd(C(2)H)(4).2NH(3) was synthesized by reacting KC(2)H, Cd(NH(2))(2), and acetylene in liquid ammonia. The crystal structures of the air and temperature sensitive compounds were determined by X-ray single crystal diffraction at low temperatures (T = 170 K). Both compounds crystallize in the monoclinic space group I2/a (No. 15) with Z = 4. K(2)Zn(C(2)H)(4).2NH(3): a = 7.289(1) A, b = 12.765(2) A, c = 14.066(2) A, beta = 98.11(2) degrees. K(2)Cd(C(2)H)(4).2NH(3): a = 7.444(1) A, b = 12.619(3) A, c = 14.304(2) A, beta = 98.94(1) degrees. Characteristic structural motifs are tetrahedral [M(C(2)H)(4)](2-) fragments (M = Zn, Cd) and zigzag chains of edge sharing distorted (C(2)H)(6) octahedra centered by potassium ions. These zigzag chains are connected by a second type of crystallographically distinct potassium ions that also bind to two ammonia molecules.