A computational modeling approach of the jet-like acoustic streaming and heat generation induced by low frequency high power ultrasonic horn reactors

High power ultrasound reactors have gained a lot of interest in the food industry given the effects that can arise from ultrasonic-induced cavitation in liquid foods. However, most of the new food processing developments have been based on empirical approaches. Thus, there is a need for mathematical models which help to understand, optimize, and scale up ultrasonic reactors. In this work, a computational fluid dynamics (CFD) model was developed to predict the acoustic streaming and induced heat generated by an ultrasonic horn reactor. In the model it is assumed that the horn tip is a fluid inlet, where a turbulent jet flow is injected into the vessel. The hydrodynamic momentum rate of the incoming jet is assumed to be equal to the total acoustic momentum rate emitted by the acoustic power source. CFD velocity predictions show excellent agreement with the experimental data for power densities higher than W(0)/V ≥ 25kWm(-3). This model successfully describes hydrodynamic fields (streaming) generated by low-frequency-high-power ultrasound.     

DTI at 7 and 3 T: systematic comparison of SNR and its influence on quantitative metrics

Diffusion tensor imaging (DTI) and advanced related methods such as diffusion spectrum and kurtosis imaging are limited by low signal-to-noise ratio (SNR) at conventional field strengths. DTI at 7 T can provide increased SNR; however, B0 and B1 inhomogeneity and shorter T2? still pose formidable challenges. The purpose of this study was to quantify and compare SNR at 7 and 3 T for different parallel imaging reduction factors, R, and TE, and to evaluate SNRs influences on fractional anisotropy (FA) and apparent diffusion coefficient (ADC). We found that R>4 at 7 T and R≥2 at 3 T were needed to reduce geometric distortions due to B0 inhomogeneity. For these R at 7 T, SNR was 70-90 for b=0 s/mm² and 22-28 for b=1000s/mm² in central brain regions. SNR was lower at 3 T (40 for b=0 s/mm² and 15 for b=1000 s/mm²) and in lateral brain regions at 7 T due to B1 inhomogeneity. FA and ADC did not change with MRI field strength, SENSE factor or TE in the tested range. However, the coefficient of variation for FA increased for SNR <15 and for SNR <10 in ADC, consistent with published theoretical studies. Our study demonstrates that 7 T is advantageous for DTI and lays the groundwork for further development. Foremost, future work should further address challenges with B0 and B1 inhomogeneity to take full advantage for the increased SNR at 7 T.     

Investigation of the possible origins of sulfur in 19th century salted paper photographs by x‐ray fluorescence spectroscopy

An X‐ray fluorescence method to determine whether sulfur is present in 19th century photographs due to intentional toning or to environmental deterioration is proposed. In the 19th century salted paper print photographic process, AgCl formed on the surface of a sheet of paper was exposed to sunlight in contact with a negative, leading to the printing out of a Ag image that was fixed by immersing it in a sodium thiosulfate solution or hypo. The improper execution of the fixing in these photographs may result in the presence of sulfur, mostly manifested in image fading, irregular staining, and discoloration. Also, 19th century artists produced salted paper prints with a variety of image tonalities, for example, by using an artificially aged thiosulfate bath. The presence of sulfur in photographs may also be due to sulfur‐containing environmental pollutants. Therefore, knowledge about the location and amounts of sulfur is important to understand the artistic technique and/or the deterioration processes. In this study, the amounts of sulfur and the silver to sulfur signal ratios were determined for a salted paper print made in the laboratory following a 19th century procedure and for two artistic salted paper photographs using X‐ray fluorescence and standards prepared with different amounts of retained hypo and quantified by inductively coupled plasma atomic emission spectroscopy. The amounts of sulfur and the normalized silver to sulfur ratios for the artistic photographs were evaluated based on the results obtained in the samples prepared in the laboratory and in the context of the 19th century practices. Copyright © 2016 John Wiley & Sons, Ltd.     

Linear polarization degree for detecting magnetic properties of small particles

Motivated by the recent advances with magnetic nanoparticles, in this research we propose a new technique for their characterization based on the measurement of certain polarimetric parameters of the scattered light, such as the linear polarization degree when it is determined at a "right-angle" scattering configuration. We will show the sensitivity of its spectral evolution with the magnetic properties of the particle.     

The effect of metal dispersion on the resonance of antennas at infrared frequencies

In this paper the optical parameters at infrared frequencies of metallic thin films were obtained experimentally using a variable angle spectroscopic ellipsometer and used to simulate numerically the frequency response of antennas and antenna-coupled detectors at infrared frequencies (5–15 μm). The simulation results agree with previously published data and practical guidelines are presented for the design and fabrication of dipole and bowtie antennas at infrared frequencies.     

Growth and characterization of Nd-doped SBN single crystal fibers

The growth from ceramic pedestals of single crystal fibers of strontium barium niobate (SBN), doped with different Nd concentrations, was studied. High-quality fibers were grown for Nd doping levels of up to 4.2 at.%, and doping levels as high as 9.9 at.% were reached. No signs of core effects were observed, even for the highest concentration samples. The emission spectra of Nd³⁺ ions in the fibers did not differ from those obtained from bulk SBN crystals, showing very broad bands due to the typical disorder of the crystallographic tungsten-bronze structure. Fluorescence quenching was clearly observed for Nd doping levels above 2 at.%. PACS 81.10.Fq; 78.55.-m     

Control of spontaneous emission by complex nanostructures

Spontaneous emission in the presence of complex nanostructures is discussed by use of a calculational scheme that permits us to deal with interfaces of arbitrary shape. Control over the field associated with the emission is shown to be attainable. In particular, decay rates are offered for geometries that lead to focusing and collimation of near- and far-field distributions. Emission from axially symmetric gratings is shown to lead to narrow angular distributions of emission, and focusing at the foci of dielectric ellipsoids is achieved for dimensions comparable with the wavelength. In the latter case the total emission rate for two atoms in an ellipsoidal cavity is shown to be enhanced in a way that deviates from the predictions of the Dicke effect by means of intermediate- and far-field contributions.     

Impurities in noncubic crystals: stabilization mechanisms for Jahn-Teller ions in layered perovskites

Mechanisms responsible for the local geometry around Jahn-Teller impurities in K2NiF4 type lattices are shown to be different from those generating the warping in cubic crystals. The present density functional theory calculations reveal that the elastic anisotropy of the host lattice (visible for closed shell impurities) and the electric field created by the rest of lattice ions upon active electrons make it possible to have d(9) ions in an elongated geometry but with a A(1g) ground state. The puzzling difference between equilibrium geometries for Cu2+ and Ni+ in layered perovskites can reasonably be understood.     

Surface reconstruction and decahedral structure of bimetallic nanoparticles

We report on energetic surface reconstruction phenomena observed on bimetallic nanoparticle systems of AuPd and AuCu, similar to a resolidification effect observed during the cooling process in lead clusters. These binary alloy nanoparticles show the fivefold edges truncated, resulting in [100] facets on decahedral structures, an effect largely envisioned and reported theoretically, with no experimental evidence so far. We demonstrate experimentally as well as by computational simulations that this new eutectic structure is favored in such nanoalloy systems.