Cosmological Models with Variable “Constants”

The behavior of the constants, G, c, , a, e, m _i, and , considering them asvariable, in the framework of a flat cosmological model with FRW symmetriesdescribed by a bulk viscous fluid and considering mechanisms of adiabatic mattercreation are investigated. Two cases are studied; one with radiationpredominance and another of matter predominance. It is found that with the solution obtainedour model verifies these basic principles: Lorentz invariance and generalcovariance, Mach, Equivalence and causality. Finally, to emphasize that the envisaged modelsare free from the main problem: Planck's, horizon and entropy. With regard tothat model with matter predominance it is seen that mechanisms of creation ofmatter cannot be considered since if these are taken into account thetemperature would increase instead of remaining constant while the universe expands.     

Diode laser extended cavity for broad-range fast ramping

A novel design for an extended-cavity diode laser is presented. The cavity contains an electro-optic prism for synchronous tuning of the cavity length and the grating's incident angle. A simple analysis of the cavity is presented. Experimental results are reported that show mode-hop-free tuning over more than 10 GHz with high linearity and reproducibility. To the authors' knowledge, this is the first demonstration of mode-hop-free tuning of an extended cavity over several free spectral intervals with an electro-optic crystal.     

Energetic and structural characterization of 2‐R‐3‐methylquinoxaline‐1,4‐dioxides (R = benzoyl or tert‐butoxycarbonyl): experimental and computational studies

The gaseous standard molar enthalpies of formation of two 2‐R‐3‐methylquinoxaline‐1,4‐dioxides (R = benzoyl or tert‐butoxycarbonyl), at T = 298.15 K, were derived using the values for the enthalpies of formation of the compounds in the condensed phase, measured by static bomb combustion calorimetry, and for the enthalpies of sublimation, measured by Knudsen effusion, using a quartz crystal oscillator. The three dimensional structure of 2‐tert‐butoxycarbonyl‐3‐methylquinoxaline‐1,4‐dioxide has been obtained by X‐ray crystallography showing that the two N? O bond lengths in this compound are identical. The experimentally determined geometry in the crystal is similar to that obtained in the gas‐phase after computations performed at the B3LYP/6‐311 + G(2d,2p) level of theory. The experimental and computational results reported allow to extend the discussion about the influence of the molecular structure on the dissociation enthalpy of the N? O bonds for quinoxaline 1,4‐dioxide derivatives. As found previously, similar N? O bond lengths in quinoxaline‐1,4‐dioxide compounds are not linked with N? O bonds having the same strength. Copyright © 2007 John Wiley & Sons, Ltd.     

Transmission of HIV in sexual networks in sub-Saharan Africa and Europe

We are reviewing the literature regarding sexual networks and HIV transmission in sub-Saharan Africa and Europe. On Likoma Island in Malawi, a sexual network was reconstructed using a sociometric survey in which individuals named their sexual partners. The sexual network identified one giant component including half of all sexually active individuals. More than 25% of respondents were linked through independent chains of sexual relations. HIV was more common in the sparser regions of the network due to over-representation of groups with higher HIV prevalence. A study from KwaZulu-Natal in South-Africa collected egocentric data about sexual partners and found that new infections in women in a particular area was associated with the number of life-time partners in men. Data about sexual networks and HIV transmission are not reported in Europe. It is, however, found that the annual number of sexual partners follows a scale-free network. Phylogenetic studies that determine genetic relatedness between HIV isolates obtained from infected individuals, found that patients in the early stages of infections explain a high number of new infections. In conclusion, the limited information that is available suggest that sexual networks play a role in spread of HIV. Obtaining more information about sexual networks can be of benefit for modeling studies on HIV transmission and prevention.     

Custom‐Fit Ruthenium(II) Metallopeptides: A New Twist to DNA Binding With Coordination Compounds

A new bipyridine building block has been used for the solid‐phase synthesis of dinuclear DNA‐binding ruthenium(II) metallopeptides. Detailed spectroscopic studies suggest that these compounds bind to the DNA by insertion into the DNA minor groove. Moreover, the potential of the solid‐phase peptide synthesis approach is demonstrated by the straightforward synthesis of an octaarginine derivative that shows effective cellular internalization and cytotoxicity linked with strong DNA interaction, as evidenced by steady‐state fluorescence spectroscopy and AFM studies.     

Phase Transfer Catalyzed Anomeric Nucleophilic Substitutions with D-Xylopyranosyl Halides

Abstract

Anomeric pairs of per-O-acetylated-D-xylopyranosyl halides were individually treated with a wide variety of nucleophiles under mild PTC conditions. Thus, 2,3,4-tri-O-acetyl-α-D-xylopyranosyl bromide 1 provided exclusively the β-D-xylopyranosyl anomers 2-11 in good to excellent yields (65-95%). Alternatively, under the same PTC conditions, 2,3,4-tri-O-acetyl-β-D-xylopyranosyl chloride 13 afforded solely the inverted α-D-anomers 15 (82%) and 16 (67%) upon treatment with thiophenol and sodium azide, respectively. Similarly, 2,3,4,6-tetra-O-acetyl-β-D-glucopyranosyl chloride 19 provided the analogous products 20 (63%) and 21 (31%) upon treatment with thiophenol and sodium azide. In the presence of tetrabutylammonium chloride as PTC catalyst, β-xylopyranosyl chloride 13 was shown to slowly equilibrate to the α-chloride 14. Therefore, care must be taken to avoid PTC catalyst for which counter anions can cause anomerization of the starting glycosyl halides.     

1H AND 31P NMR Spectroscopy of Agrocinopine

The ¹H NMR data of agrocinopine in D₂O solution as extracted from standard 2D NMR experiments, along with 1D ³¹P and ¹³C NMR experiments allow to support the trisaccharide structure originally proposed on basis of comparative ¹³C NMR measurements.     

Effect of pH and ligand charge state on BACE-1 fragment docking performance

In this work we propose a protocol for estimating the effect of pH on the docking performance to BACE-1, which affords the charge state of the inhibitor as well as the protonation state of all ionisable residues in the protein at a given pH value. To the best of our knowledge, this is the first report of a protocol predicting the BACE-1 ligand docking poses not only at the neutral pH at which most crystallographic structures were obtained, but also at the optimal pH of the enzyme (in the acidic range), at which most of the BACE-1 binding affinity assays are performed. We have applied this protocol to a set of 23 fragment-like BACE-1 ligands that span four orders of magnitude in their binding affinities. The pK _a values of the BACE-1 acidic residues deviate substantially from the estimates for model compounds in solution and display a ligand dependent variability, especially in the case of the catalytic Asp dyad residues. This outcome should have a strong bearing on the design of protocols for docking based BACE-1 screening campaigns. Finally, we were able to find an explanation for the poor docking success rate of some fragments based on the availability of anchoring points, a rationale that could help to improve hit rates in BACE-1 screening campaigns.     

Polyamide 6‐polycaprolactone multiblock copolymers: Synthesis,characterization, and degradation

This work describes the synthesis and characterization of polyamide 6 (PA 6)‐polycaprolactone (PCL) multiblock copolymers. Low molar mass, fully amine end‐capped PA 6 was prepared by the addition of a diamine monomer during ε‐caprolactam polymerization. A low molar mass PCL was selected to be incorporated as the biodegradable block and was fully end‐capped with toluene 2,4‐diisocyanate. End group analysis and molecular weight characterizations were performed for both end‐functionalized polymers by SEC, NMR and titration analysis. Incorporation of PCL into PA 6 was mainly achieved by solution mixing of the two end‐functional blocks and, was continued after the removal of the solvent with solid state polymerization (SSP) by gradual heating until about 40 °C below the melting temperature of the PA 6. Molecular weights started to grow immediately during solution mixing and only increased marginally during the SSP treatment. FTIR and SEC studies confirmed the reaction between the two components. DSC data, in combination with the enhanced molar mass during solution mixing pointed to a blocky microstructure, for which distinct melting and crystallization temperatures were observed for the PCL and the PA 6 blocks. Hydrolytic and enzymatic degradation studies were performed at 25 °C where the degree of degradation was followed by weight loss analysis, SEM and SEC. © 2011 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem, 2011