Microstructure of miscible polymer blends

The purpose of this work is to describe the application of new electron microscopy techniques to the study of polymer blends with very fine dispersion of phases (miscible blends). Blends of PVC with PMMA, PCL, POM and SAN were prepared by high temperature mixing on a two roll mill, or by solvent casting. Thin sections (or cast films) were investigated in the scanning transmission electron microscope and small phases were identified in most blends. The contrast was enhanced by electronic combination of bright and dark field signals, by an irradiation and staining technique and by differential mass loss. The specimens were further characterized by measurement of mass loss, resulting from electron beam damage. The non linear changes in the mass loss rate with concentration were interpreted as being influenced by partial solubility and molecular interactions.     

Small visible energy scalar top iterative discriminant analysis

Light scalar top quarks with a small mass difference with respect to the neutralino mass are of particular cosmological interest. This study uses an iterative discriminant analysis method to optimize the expected selection efficiency at the international linear collider (ILC).      

Gamma gamma technology group

The results presented at this conference in the γγ technology group are described.      

Investigation of the quantitative properties of the quadrupole orthogonal acceleration time-of-flight mass spectrometer with electrospray ionisation using 3,4-methylenedioxymethamphetamine

This paper describes the investigation of the potential of a quadrupole orthogonal acceleration time-of-flight mass spectrometer (Q-TOF) equipped with an atmospheric pressure ionisation interface for quantitative measurements of small molecules separated by reversed phase liquid chromatography. To this end, the detection limits and linear dynamic range in particular were studied in an LC/MS/MS experiment using 3,4-methylenedioxymethamphetamine standards and 3,4-methylenedioxyethylamphetamine for internal standardisation. In a second phase, the experiment was repeated with real biological extracts (whole blood, serum, and vitreous humour). A calibration for 3,4-methylenedioxymethamphetamine and its metabolite 3,4-methylenedioxyamphetamine was prepared in each of these matrices again using 3,4-methylenedioxyethylamphetamine as internal standard. The resulting quantitative data were compared with those obtained by liquid chromatography with fluorescence detection for the same extracts. The Q-TOF results revealed excellent sensitivity and a linear dynamic range of nearly four decades (2-10 000 pg on-column, r(2) = 0.9998, 1/x weighting). Furthermore, all the calibration curves prepared in biological material were superimposable, LC/MS/MS and LC-fluorescence, and the quantitative results for actual samples compared very favourably. It was concluded that the Q-TOF achieves a linear dynamic range for quantitative LC/MS/MS work exceeding that of fluorescence detection and at much better absolute sensitivity. Copyright 1999 John Wiley & Sons, Ltd.     

Routine analysis by high precision gas chromatography/mass selective detector/isotope ratio mass spectrometry to 0.1 parts per mil

Stable isotope methods are potentially quite useful for validating natural or enhanced mineral degradation of contaminants. For this reason, a continuous flow gas chromatograph (GC), isotope ratio mass spectrometer (IRMS) has been coupled with a quadrupole mass selective detector (MSD) to allow simultaneous mass spectral and stable carbon isotope ratio data to be obtained from a single chromatographic analysis. This allows the target contaminant and any extra-cellular degradation intermediates to be both qualified and quantified. Previously acceptable limits of precision (0.3 parts per mil) are undesirable given the small fractionation observed during aerobic degradation. To further understand the fate of organic contaminants and to gain information about the metabolic degradative pathway employed by a microorganism, routine isotopic analyses on a range of analytes have been performed. Quantities of sample producing mass-44 ion beam signal (I(44)) of 2 x 10(-10) to 1 x 10(-8) A were analysed. When the IRMS was tuned for high sensitivity, ion source nonlinearities were overcome by peak height correction from an algorithm that was produced using known isotopic standards of varying concentrations. This led to sample accuracy of <0.01 per thousand and sample precision of 0.1 per thousand. Copyright 1999 John Wiley & Sons, Ltd.     

Measurement of flow visualized on surface of bubble blown in air

Bubbles blown in surfactant (frother) solution reveal surface flows attributed to gravity drainage and opposing Marangoni Effect. A technique is introduced to visualize the flows and estimate trajectory velocity. The flow pattern and velocity depend on frother type (pentanol vs. a polyglycol) and concentration but no correlation with surface tension was found. The relevance of the observations to the action of frother in flotation is briefly discussed.     

A differential scanning calorimetric study of cysteine hydrochloride monohydrate

An irreversible phase change, ΔH (transition) = 5.44 ± 0.11 kcal mol^?1 at 337.1 ± 0.3 K has been confirmed in L-(+)-cysteine hydrochloride monohydrate. Phase transitions resulting from thermal pretreatment are also reported and discussed.     

Ultrasonic flaw detection in model railway wheels

Rayleigh and Lamb waves have been excited in $\text{1}\text{4}$ scale model railway wheels by an ultrasonic source located on the wheel tread. Simulated flaws in treads and plates have been located.