Phase behavior of (CO2 + methanol + lauric acid) system

In this study the phase equilibrium behaviors of the binary system (CO₂ + lauric acid) and the ternary system (CO₂ + methanol + lauric acid) were determined. The static synthetic method, using a variable-volume view cell, was employed to obtain the experimental data in the temperature range of (293 to 343) K and pressures up to 24 MPa. The mole fractions of carbon dioxide were varied according to the systems as follows: (0.7524 to 0.9955) for the binary system (CO₂ + lauric acid); (0.4616 to 0.9895) for the ternary system (CO₂ + methanol + lauric acid) with a methanol to lauric acid molar ratio of (2:1); and (0.3414 to 0.9182) for the system (CO₂ + methanol + lauric acid) with a methanol to lauric acid molar ratio of (6:1). For these systems (vapor + liquid), (liquid + liquid), (vapor + liquid + liquid), and (solid + fluid) transitions were observed. The phase equilibrium data obtained for the systems were modeled using the Peng–Robinson equation of state with the classical van der Waals mixing rule with a satisfactory correlation between experimental and calculated values.     

Validation of a digestion system using a digester block/cold finger system for the determination of lead in vegetable foods by electrothermal atomic absorption spectrometry

This paper presents the validation of a system for sample digestion using a digester block/cold finger to determine the lead content in vegetables by electrothermal atomic absorption spectrometry (ETAAS). After mineralization, lead contents were determined by ETAAS using a calibration curve based on aqueous standards prepared in 2.60 M nitric acid solutions containing 5 microg ammonium phosphate as chemical modifier. A pyrolysis temperature of 900 degrees C and atomization temperature of 2000 degrees C were used. This method allowed the determination of lead with a characteristic mass of 35 pg; LOD and LOQ of 0.6 and 2 nglg, respectively, were found. The precision was investigated in terms of reproducibility and repeatability. Reproducibility was estimated by analysis of nine different portions of a certified reference material (CRM) of spinach leaves, and the repeatability was determined through the analysis of nine aliquots of the same solution. The reproducibility and repeatability were found to be 4.27 and 2.94% RSD, respectively. The accuracy was confirmed by analysis of whole meal flour, spinach leaves, and orchard leaves CRMs, all furnished by the National Institute of Standards and Technology. Lead contents were measured using the newly developed technique in 11 different potato samples. The lead contents ranged from 12.80 to 69.27 ng/g, with an average value of 28.59 ng/g. These values were in agreement with data reported in the literature.     

Photophysical study of bis(naphthalimide)-amine conjugates: toward molecular design of excimer emission switching

The fluorescence properties of two bis(1,8-naphthalimides) with amino-containing spacers are investigated, giving special emphasis to the observation of excimer emission. It is found that a minor elongation of the spacer by two methylene units gives rise to a quantitative shut-down of the broad and red-shifted excimer emission. Furthermore, a switching of this emission is established through manipulation of a photoinduced electron transfer process, which involves the amino spacer. Protons as well as protic solvents lead to substantial excimer emission with lifetimes of 12 to 27 ns. The excimer quantum yield takes a maximum value of Φ(f) = 0.07 (acetonitrile with 1 equiv trifluoroacetic acid). The increased virtual Stokes shifts (ca. 150 nm) as compared to the fluorescence of monomeric 1,8-naphthalimides are an alternative approach to obtain colored, significant, and long-lived fluorescence from these chromophores. As an additional excited state pathway, the occurrence of homo-Fo?rster resonance energy transfer (homo-FRET) is established by fluorescence polarization measurements and calculation of the corresponding critical Fo?rster radius (R(0) ca. 13 ?). The average interchromophore distance between the naphthalimides is estimated as 7.5 ? and 9.5 ? for the dyad with the shorter and the longer spacer, respectively. These observations and the absence of a rise time component for excimer emission are in agreement with the formation of a "loose" ground state dimer, which upon excitation undergoes a fast geometrical adjustment to the excimer structure where the chromophores are at contact distance.     

Comparative properties of Amazonian oils obtained by different extraction methods

Pequi (Caryocar brasiliense Camb.), baba?u (Orbignya phalerata Mart.), buriti (Mauritia flexuosa), and passion fruit (Passiflora edulis) oils were studied to determine their antibacterial, antioxidant and cytotoxic activities, as well as their total phenol and carotenoid contents. The fatty acid contents were determined by GC-MS. The three types of passion fruit oils studied were refined, cold pressed or extracted from seeds in a Soxhlet apparatus. The oils thus obtained showed differences in antioxidant activity and carotenoid content, but were similar in regard to total phenols. Buriti and pequi had the highest carotenoid contents, while refined and cold pressed passion fruit oil displayed the highest antioxidant activity. Pequi oil was the only oil to display antibacterial and cytotoxic activity.     

Identification of volatiles from pineapple (Ananas comosus L.) pulp by comprehensive two-dimensional gas chromatography and gas chromatography/mass spectrometry

Combining qualitative data from the chromatographic structure of 2-D gas chromatography with flame ionization detection (GC×GC-FID) and that from gas chromatography-mass spectrometry (GC/MS) should result in a more accurate assignment of the peak identities than the simple analysis by GC/MS, where coelution of analytes is unavoidable in highly complex samples (rendering spectra unsuitable for qualitative purposes) or for compounds in very low concentrations. Using data from GC×GC-FID combined with GC/MS can reveal coelutions that were not detected by mass spectra deconvolution software. In addition, some compounds can be identified according to the structure of the GC×GC-FID chromatogram. In this article, the volatile fractions of fresh and dehydrated pineapple pulp were evaluated. The extraction of the volatiles was performed by dynamic headspace extraction coupled to solid-phase microextraction (DHS-SPME), a technique appropriate for slurries or solid matrices. Extracted analytes were then analyzed by GC×GC-FID and GC/MS. The results obtained using both techniques were combined to improve compound identifications.     

On the Solution of Generalized Multiplicative Extremum Problems

The paper addresses the problem of maximizing a sum of products of positive and concave real-valued functions over a convex feasible set. A reformulation based on the image of the feasible set through the vector-valued function which describes the problem, combined with an adequate application of convex analysis results, lead to an equivalent indefinite quadratic extremum problem with infinitely many linear constraints. Special properties of this later problem allow to solve it by an efficient relaxation algorithm. Some numerical tests illustrate the approach proposed.     

Adding value to bank branch performance evaluation using cognitive maps and MCDA: a case study

Bank branch performance evaluation is a difficult endeavour. Some of the main reasons for this difficulty are the complexity inherent in the variety of aspects considered in the evaluation, and the multiple and conflicting interests of the different stakeholders involved. In this paper, we show how cognitive mapping and measuring attractiveness by a categorical-based evaluation technique can be used to support the evaluation of bank branches through the development of multidimensional performance evaluation systems, and to deal explicitly with the trade-offs between the different dimensions of performance and interests of different stakeholders. A case study is discussed where these techniques are used in a constructive way, making the learning activity easier and introducing transparency in the decision-making process. The strengths and weaknesses of the integrated use of these two operational research techniques in this context are also discussed.     

Insertion of Continuous Real Functions on Spaces,Bispaces, Ordered Spaces and Pointfree Spaces—A Common Root

We characterize normal and extremally disconnected biframes in terms of the insertion of a continuous real function in between given lower and upper semicontinuous real functions and show this to be the common root of several classical and new insertion results concerning topological spaces, bitopological spaces, ordered topological spaces and locales.     

Stir bar sorptive extraction of parabens, triclosan and methyl triclosan from soil, sediment and sludge with in situ derivatization and determination by gas chromatography-mass spectrometry

The aim of this research work was the evaluation of stir-bar sorptive extraction (SBSE) in combination with an in situ derivatization to determine parabens (methylparaben, isopropylparaben, n-propylparaben, butylparaben and benzylparaben), triclosan and methyltriclosan in soil samples. This is the first time that this approach has been applied to the determination of these compounds in soil samples, providing important advantages over conventional extraction techniques, such as minimization of sampling handling, complete elimination of the use of organic solvents and simplification of the analytical procedure with reduced time consumption. The enriched target analytes were desorbed thermally using a thermodesorption system coupled to a gas chromatograph and a mass spectrometer. The optimized derivatization and SBSE extraction conditions, as well as the analytical characteristics of the method were obtained using spiked soil samples. The proposed methodology proved to be easy to use and sensitive, with limits of detection between 80 ng/kg and 1.06 μg/kg, and reproducibility values below 13%. The accuracy of the method was evaluated at two concentration levels, obtaining apparent recoveries between 91% and 110%. The matrix composition significantly influenced the extraction procedure, and a need to adopt a standard additions protocol is apparent. The analytes assayed were determined successfully in different environmental soil samples.