Complete 1H and 13C NMR assignments of aurasperone A and fonsecinone A, two bis-naphthopyrones produced by Aspergillus aculeatus

Complete assignments of 1H and 13C NMR chemical shifts of the polyketides aurasperone A and fonsecinone A were made by means of nuclear Overhauser enhancement and heteronuclear NMR correlation experiments. These compounds were isolated for the first time from Aspergillus aculeatus, an endophytic fungus obtained from leaves of Melia azedarach(Meliaceae).     

Experimental and computational investigation of the energetics of the three isomers of monochloroaniline

The standard (p degrees = 0.1 MPa) molar enthalpies of formation of 2-, 3-, and 4-chloroaniline were derived from the standard molar energies of combustion, in oxygen, at T = 298.15 K, measured by rotating bomb combustion calorimetry. The Calvet high-temperature vacuum sublimation technique was used to measure the enthalpies of vaporization or sublimation of the three isomers. These two thermodynamic parameters yielded the standard molar enthalpies of formation of the three isomers of chloroaniline, in the gaseous phase, at T = 298.15 K, as 53.4 +/- 3.1 kJ.mol(-1) for 2-chloroaniline, 53.0 +/- 2.8 kJ.mol(-1) for 3-chloroaniline, and 59.7 +/- 2.3 kJ.mol(-1) for 4-chloroaniline. These values, which correct previously published data, were used to test the computational methodologies used. Therewith, gas-phase acidities, proton affinities, electron donor capacities, and N-H bond dissociation enthalpies were calculated and found to compare well with available experimental data for these parameters.     

Factorial design in the optimization of preconcentration procedure for lead determination by FAAS

The present paper proposes a preconcentration procedure for lead determination using flame atomic absorption spectrometry (FAAS). It is based on lead(II) ions extraction as brilliant cresyl blue (BCB) complex and its sorption onto Diaion HP-2MG, a methacrylic ester copolymer. The optimization step was carried out using factorial design and the variables studied were pH, shaking time and reagent concentration. In the established experimental conditions, lead can be determinate with a limit of detection of 3.7 μg L⁻¹ lead (N = 20) and a relative standard deviation of 7% for a lead concentration of 100 μg L⁻¹. The accuracy was confirmed by analysis of a certified reference material, the stream sediment furnished by National Research Centre for Certified Reference Materials (NRCCRM), China (GBW 07310). Effect of other ions in the procedure proposed was also studied. The method was applied for lead determination in real samples of water, tea, soil and dust. Tests of addition/recovery in the experiments for lead determination in water samples revealed that the proposed procedure could be applied satisfactorily for analysis of these samples.     

Preliminary evaluation of the cadmium concentration in seawater of the Salvador City, Brazil

A method for preconcentration and determination of trace amounts of cadmium in high saline samples is described. It is based on the adsorption of the metal in the activated carbon as complex cadmium(II)-4-(2-pyridylazo-resorcinol) (PAR). The final determination was carried by flame atomic absorption spectrometry (FAAS). The optimization of extraction parameters such as the pH effect, PAR mass, activated carbon mass and shaking time was carried out using a two-level full factorial design (2⁴) and two Doehlert matrix designs. The results of the factorial design, considering the analysis of variance (ANOVA), demonstrate that all these factors are statistically significant, as well as the interactions (pH×PAR mass), (pH×activated carbon mass) and (activated carbon mass×shaking time). The final optimization was carried out using Doehlert matrix designs considering the results of the factorial design. The recoveries were quantitative (96.0-106.7%) for seawater samples spiked with Cd at concentrations of 0.125 and 0.625 μg l⁻¹. A preconcentration factor of 149 was obtained. The effect of diverse metallic ions on the proposed procedure was investigated too. The procedure was used for cadmium determination in surface seawater samples collected in Salvador City, Brazil. The cadmium content in the analysed samples varies from 0.035 to 0.17 μg l⁻¹. These results are agreement with other data reported in the literature.     

Highly selective solid-phase extraction and large volume injection for the robust gas chromatography-mass spectrometric analysis of TCA and TBA in wines

A reliable solid-phase extraction (SPE) method for the simultaneous determination of 2,4,6-trichloroanisole (TCA) and 2,4,6-tribromoanisole (TBA) in wines has been developed. In the proposed procedure 50 mL of wine are extracted in a 1 mL cartridge filled with 50 mg of LiChrolut EN resins. Most wine volatiles are washed up with 12.5 mL of a water:methanol solution (70%, v/v) containing 1% of NaHCO3. Analytes are further eluted with 0.6 mL of dichloromethane. A 40 microL aliquot of this extract is directly injected into a PTV injector operated in the solvent split mode, and analysed by gas chromatography (GC)-ion trap mass spectrometry using the selected ion storage mode. The solid-phase extraction, including sample volume and rinsing and elution solvents, and the large volume GC injection have been carefully evaluated and optimized. The resulting method is precise (RSD (%) < 6% at 100 ng L(-1)), sensitive (LOD were 0.2 and 0.4 ng/L for TCA and TBA, respectively), robust (the absolute recoveries of both analytes are higher than 80% and consistent wine to wine) and friendly to the GC-MS system (the extract is clean, simple and free from non-volatiles).     

Effect of Bauhinia monandra Kurz Leaf Preparations on Embryonic Stages and Adult Snails of Biomphalaria glabrata (Say, 1818), Schistosoma mansoni Cercariae and Toxicity in Artemia salina

Biomphalaria glabrata snails constitute the main vector of schistosomiasis in Brazil, and Bauhinia monandra Kurz, the leaves of which contain BmoLL lectin with biocidal action, is a plant widely found on continents in which the disease is endemic. This work describes the composition of B. monandra preparations and the effect on embryos and adult snails, their reproduction parameters and hemocytes. We also describe the results of a comet assay after B. glabrata exposure to sublethal concentrations of the preparations. Additionally, the effects of the preparations on S. mansoni cercariae and environmental monitoring with Artemia salina are described. In the chemical evaluation, cinnamic, flavonoid and saponin derivatives were detected in the two preparations assessed, namely the saline extract and the fraction. Both preparations were toxic to embryos in the blastula, gastrula, trochophore, veliger and hippo stages (LC₅₀ of 0.042 and 0.0478; 0.0417 and 0.0419; 0.0897 and 0.1582; 0.3734 and 0.0974; 0.397 and 0.0970 mg/mL, respectively) and to adult snails (LC₅₀ of 6.6 and 0.87 mg/mL, respectively), which were reproductively affected with decreased egg deposition. In blood cell analysis, characteristic cells for apoptosis, micronucleus and binucleation were detected, while for comet analysis, different degrees of nuclear damage were detected. The fraction was able to cause total mortality of the cercariae and did not present environmental toxicity. Therefore, B. monandra preparations are promising in combating schistosomiasis since they can control both the intermediate host and eliminate the infectious agent, besides being safe to the environment.     

Synthesis and characterization of new galactosylated-based N2O-donors tridentate ligands

The synthesis and characterization of three novel N₂O-donor ligands containing the group 4-[1-β-d-2,3,4,6-tetra-O-acetyl-galactosyl)]benzaldehyde are presented. The insertion of this group was designed to increase the absorption of the prodrug in tumor cells, and is part of an ongoing work in our group with tridentate ligands to develop potential cobalt(III) prodrugs. The synthetic route described here allowed the isolation of pure ligands with yields ranged 81–89%. Finally, compounds were characterized by IR, NMR and HRMS (ESI⁺).     

Al2O3/K2O-containing non-stoichiometric lithium disilicate-based glasses

The crystallisation kinetics of experimental glasses in 3 different systems: (A) Li₂O–SiO₂, (B) Li₂O–Al₂O₃–SiO₂ and (C) Li₂O–K₂O–Al₂O₃–SiO₂ were studied under non-isothermal conditions. The DTA results revealed a stronger tendency to crystallisation of binary compositions in comparison to the ternary and quaternary compositions comprising Al₂O₃ and K₂O which present the lower crystallisation, i.e. the crystallisation propensity follows the trend A > B > C. The devitrification process in the Li₂O–SiO₂ and Li₂O–Al₂O₃–SiO₂ systems began earlier and the rate was higher in comparison to that of glasses in the quaternary Li₂O–K₂O–Al₂O₃–SiO₂ system. Thus, addition of Al₂O₃ and K₂O to glasses of Li₂O–SiO₂ system was demonstrated to promote glass stability against crystallisation. However, the activation energy for crystallisation was shown to depend also on the SiO₂/Li₂O ratio with the binary system showing a decreasing trend with increasing SiO₂/Li₂O ratio, while the opposite tendency was being observed for compositions with added Al₂O₃ and K₂O.     

TG and DSC analyses of eucalyptus black liquor as alternative methods to estimate solids content

As a consequence of the continuous increase in the production rate of pulp and paper mills around the world, a great quantity of black liquor, a by-product of the wood digestion process, is produced. This by-product has a great potential as biomass, but needs to be concentrated to higher solids content to be burned as fuel in a recovery boiler. This is necessary to make the pulping process economically feasible, incinerating black liquor to produce high pressure steam, recycling inorganic chemicals to the process. The greater the solids content in black liquor, the better the combustion process in the boiler. Nevertheless, concentration of solids in black liquor above 75 mass/%, causes scaling formation on the heat transfer surfaces of evaporators and concentrators, due to the precipitation of sodium salts, reducing the overall efficiency of this equipment. The aim of this work is to evaluate the use of thermal analyses techniques, TG and DSC, as alternative methods to estimate solids content in eucalyptus black liquor samples since this information is essential to understand scaling formation process, allowing actions to reduce this industrial problem. Traditional techniques applied to determine solids content use gravimetric methods, which are simple, fine, but take a lot of time to be executed. Thermal analyses have proved to be very accurate and have the advantage to be faster than the traditional techniques. On the other hand, the cost-benefit relationship of the traditional technique is much greater and the final decision which one should be used depends on the conditions available.