Manifestation of diamagnetic chemical shifts of proton NMR signals by an anisotropic shielding effect of nitrate anions

A remarkable upfield shift of the py_α protons of complexed 2,2′-bipyridine in [cis-Pd(bpy)(NO₃)₂] is observed which is considered to originate from the anisotropic influence of suitably positioned coordinated nitrate anions around the Pd(II) centre of the molecule. A typical complexation-induced downfield shift is observed for the NH₂ protons in [cis-Pd(en)(NO₃)₂] where ‘en’ stands for ethylenediamine.     

Development of an optical fibre Al(III) sensor based on immobilised chrome azurol S

Chrome azurol S immobilised on XAD-2 has been used in this study as a reagent phase for the development of an optical fibre Al(III) sensor. Using a kinetic approach, this sensor was able to give a linear response in the Al(III) concentration range of 1.3 x 10(-5)-2.0 x 10(-4) M with a limit of detection of 1.0 x 10(-4) M. The optimum responses were obtained at pH 6.0 and when the solution was stirred. The sensor response was found to have a repeatability and reproducibility of 1.6% and 5.8%, respectively. The results obtained for Al(III) determination in aqueous sample were in good agreement with those obtained using graphite furnace-atomic absorption spectrometry.     

Organic–inorganic nanocomposites prepared from fluoro-aramid and silica

Fluoro-aramid-based sol/gel-derived nanocomposites were synthesized by condensing a mixture of 4,4′-(hexafluoro-isopropylidene)dianiline and 1,3-phenylenediamine with terephthaloylchloride (TPC) in dimethylacetamide. TPC was added in slight excess to produce amide chains with carbonyl chloride end groups and then replaced with alkoxy groups using aminophenyltrimethoxysilane to develop bonding with the silica network. Mechanical, dynamic mechanical thermal, water absorption and morphological measurements were carried out on the thin hybrid films. Increase in the tensile strength and modulus was observed as compared to pristine polyamide. The thermal decomposition temperature was found in the range of 400–500 °C. The water absorption was found to be reduced with higher silica content. The glass transition temperature and the storage moduli increased with increasing silica concentration. The maximum increase in the T _g value (345 °C) was observed with 20 wt% silica. Scanning electron microscopy revealed the uniform distribution of silica in the matrix with an average particle size ranging from 8 to 50 nm.     

Negative ion FAB mass spectroscopy of some ribose alkylated 5'-UMP derivatives

Characteristic fragment ions obtained in Fast atom bombardment (FAB) mass spectroscopy of ribose alkylated Uridine 5'-monophosphate (5'-UMP) derivatives in negative ion mode are described. All the compounds examined exhibited either [M]- or quasimolecular ion [M - H]- the fragmentations can be used to characterize these nucleotides.     

Dynamics of molecular oxygen in micellar solutions

Fluorescence quenching by molecular oxygen has been employed to estimate dynamic parameters and solubility characteristics of molecular oxygen in micelle forming detergent solutions. A kinetic model which assumes that oxygen quenching occurs only in the micellar phase is employed to analyze the data.     

A study of simultaneous photolysis and photoaddition reactions of riboflavin in aqueous solution

The photodegradation reactions of riboflavin (RF) in the presence of 0.05-2.00 M phosphate (pH 7.0) have been studied using a specific multicomponent spectrophotometric method. The reactions involve simultaneous photolysis (intramolecular photoreduction) and photoaddition (intramolecular photoaddition) leading to lumichrome (LC) and cyclodehydroriboflavin (CDRF), respectively, as major products. The contribution of each reaction in the overall photodegradation depends upon the phosphate concentration, i.e., higher the phosphate concentration higher the extent of photoaddition. The apparent first-order rate constants for the photodegradation of RF and for the formation of LC and CDRF at 0.25-2.00 M phosphate concentration range from 0.65 to 3.03 x 10(-2), and from 0.41 to 0.99 x 10(-2) and 0.12 to 1.63 x 10(-2) min(-1), respectively. The second-order rate constants for the phosphate catalysed photodegradation of RF and for the formation of LC and CDRF are 2.12 x 10(-4) and 0.61 x 10(-4) and 1.41 x 10(-4) M(-1)s (-1), respectively. Since the formation of CDRF by photoaddition is catalysed by HPO(4)(2-) ions, it is suggested that H(2)PO(4)(-) ions may be involved in the formation of LC by photolysis. Thus, both H(2)PO(4)(-) and HPO(4)(2-) ions may catalyse the two major reaction pathways of riboflavin photodegradation, respectively.     

Reaction of Cα,O-dilithiooximes with functionalized carbonyl compounds. Part 2 . Reaction with α-chloroketones and α,β-unsaturated aldehydes and ketones

The reaction of Cα,O-Dilithiooximes 2 and α-chloroketones afforded 5-(hydroxymethyl)-Δ²-soxazolines 4 . α,β-Unsaturated aldehydes and ketones reacted with 2 to give the corresponding acyclic 1,2-addition products 5 . The latter were cyclized with phosphorus pentoxide to 5-vinyl-Δ²-isoxazolines 6 .     

Effects of humidity and temperature during irradiation on the response of blue PMMA dosimeter

Effects of relative humidity conditions in the irradiation chamber and of temperature of the chamber on the response of 3 mm thick light blue poly (methyl methacrylate) sheets have been studied. The response was measured spectrophotometrically at 402, 450, 596 and 612 nm. The response of the dosimeter is independent of the relative humidity (12–97%) during irradiation if the response is measured within 24 h of irradiation. If the response is measured after longer storage time, the absorbance at 402 and 450 nm increases significantly. At these two wavelengths the response of the dosimeter is also independent of the temperature of the irradiation chamber in the range of 0 to 40 °C. However, at higher temperatures (60, 80 °C), the response is not uniform.     

Enhancement of distillate selectivity in Fischer-Tropsch synthesis by using iron and cobalt catalysts in a novel dual-bed reactor ?

Summary An integrated process for producing liquid fuels from synthesis gas via a two-stage Fischer-Tropsch (FT) reaction is disclosed. An iron catalyst was used in the first bed of a fixed-bed reactor followed by a ruthenium promoted cobalt catalyst in the second bed. The activity and selectivity of the dual-bed system were assessed and compared with those using catalysts in a single bed system, separately. The methane selectivity in the dual-bed reactor was about 11% less compared to that of the single-bed system. The C₅⁺ selectivity for the dual-bed reactor was 19.7% higher than that of the single-bed system.