o-Trityl phenoxy-imino vanadium (III) complexes: synthesis,characterization, and catalysis on ethylene (co)polymerization

Several phenoxy-imine ligands bearing o-trityl group in phenoxy moiety RN=CHArOH (Ar = C₆H₂(CPh₃)^tBu, R = 2,6-Me₂C₆H₃ ( L ₁ H ); 2,6-ⁱPr₂C₆H₃ ( L ₂ H ); 3,5-(CF₃)₂C₆H₃ ( L ₃ H ); 3,5-(OMe)₂C₆H₃ ( L ₄ H ); CHPh₂ ( L ₅ H ); CPh₃ ( L ₆ H )) were synthesized and characterized by¹H NMR and ¹³C NMR spectroscopy. The vanadium complexes based on these ligands LVCl₂(THF)₂ ( 1–6 ) were synthesized via conventional transmetalation reaction in moderate to high yields. Complexes 1–6 were fully characterized by FT-IR, elemental analyses and the molecular structures of 1 , 2 ·H₂O, (2 ·H₂O ) ₂ (μ-Cl) ₂ , 4 , and 5 were confirmed by X-ray crystallographic analysis in which the six-coordinated vanadium centers are in a typical octahedral geometry. Upon activation with Et₂AlCl in toluene, complexes 1–6 showed high activities in ethylene polymerization affording polymers with moderate molecular weight (5.9–11.8 × 10⁴ Da). Moreover, in hexane or CH₂Cl₂, 1–6 /Et₂AlCl exhibited enhanced activities. When activated with MAO or MMAO in toluene, these complexes showed relatively low activities but afforded polymers with ultra-high molecular weight (up to 3.30 × 10⁶ Da). 1–6 /Et₂AlCl also showed high activities in ethylene/1-hexene copolymerization at room temperature giving moderate molecular-weight polymers (6.5–11.4 × 10⁴ Da) with co-monomer incorporation being of 6.0 ~ 7.8%.     

The visible and ultraviolet organic light-emitting diodes with germanium dioxide as facile solution-processed anode buffer layer

Germanium dioxide (GeO₂) aqueous solutions are facilely prepared and the corresponding anode buffer layers (ABLs) with solution process are demonstrated. Atomic force microscopy, X-ray photoelectron spectroscopy and ultraviolet photoelectron spectroscopy measurements show that solution-processed GeO₂ behaves superior film morphology and enhanced work function. Using GeO₂ as ABL of organic light-emitting diodes (OLEDs), the visible device with tris(8-hydroxy-quinolinato)aluminium as emitter gives maximum luminous efficiency of 6.5 cd/A and power efficiency of 3.5 lm/W, the ultraviolet device with 3-(4-biphenyl)-4-phenyl-5-tert-butylphenyl-1,2,4-triazole as emitter exhibits short-wavelength emission with peak of 376 nm, full-width at half-maximum of 42 nm, maximum radiance of 3.36 mW/cm² and external quantum efficiency of 1.5%. The performances are almost comparable to the counterparts with poly (3,4-ethylenedioxythiophene):poly (styrenesulfonate) as ABL. The current, impedance, phase and capacitance as a function of voltage characteristics elucidate that the GeO₂ ABL formed from appropriate concentration of GeO₂ aqueous solution favors hole injection enhancement and accordingly promoting device performance.     

双掺(Tm3+,Tb3+)LiYF4激光器1.5 μm波长激光阈值分析

由速率方程推出了双掺（Tm^3 ,Tb^3 ）离子准四能级系统的激光阈值解析式，讨论了Tm^3 和Tb^3 离子之间的相互作用。分析了1.5μm波长附近的激光阈值和Tm^3 、Tb^3 离子的掺杂原子数分数及晶体长度的关系。结果表明，对于对应Tm^3 离子^3H4→^3F4跃迁的约1.5μm波长的激光，激活离子Tm^3 的掺杂原子数分数过大时，交叉弛豫作用将使系统阈值迅速增加。Tb^3 离子的加入，一方面能抽空激光下能级，起到降低阈值的作用；另一方面亦减少了激光上能级的寿命，使阈值升高。故Tb^3 离子有最佳掺杂原子数分数。对于Tm原子数分数为y=0.01的Tm:LiYF4晶体，Tb^3 离子的最佳掺杂原子数分数为0.002左右，同时表明，激光阈值与晶体长度有关。最佳晶体长度与Tm^3 、Tb^3 离子的掺杂原子数分数以及晶体的衍射损耗和吸收损耗有关。     

有势场逆问题的边界元法

本文给出了位势方程逆问题的一种最小二乘边界元解法。控制方程为Ｌａｐｌａｃｅ方程，但一部分边界上未给出任何边值，而只在某些内点上给出了势函值。这一问题在数学上属不适定问题，但在一定条件下存在唯一解。本文同时给出了一种估计解的可靠性的方法。数值试验表明，这类逆问题采用边界元法是非常有效的。     

TZT/AC/PMMA体系光谱烧孔及激光诱导的填孔效应的研究

报道四苯并卟啉锌/芳晴/有机玻璃TZT/AC/PMMA体系光化学烧孔的光谱稳定性、多重烧孔及激光诱导的填孔效应。 关键词：     

新疆玛纳斯湖水蒸发过程研究

本文依据Na^ ,K^ ,Mg^2 //Cl^-,SO4^2--H2O五元水盐体系相图，对新疆玛纳斯盐湖水进行原料分析、理论研究、25℃等温蒸发实验和自然蒸发实验，研究了该湖水蒸发过程中盐类的析出规律及湖水中各组分浓度变化的规律，为进行工艺实验及将来的综合开发利用提供了可靠依据。