OADM环网的实验研究

研究了光分插复用器(OADM)的关键技术,重点分析了相关的实现技术,完成了利用OADM构建全光环网的实验研究,给出了重要的实验数据,包括眼图、光谱图、光信噪比、保护与恢复等,并对这些实验数据进行了分析,为光传送网的设计与构建提供了重要的参考依据.     

Investigation of the mean free path of projectile fragments produced in 16O－Em collision at 60 A GeV

Results are presented for an investigation of the mean free path of projectile fragments with charge 3≤Z≤8, produced by 60 A GeV {}^{16}O in nuclear emulsion. No dependence of mean free path on the distance from the point of the fragment emission is observed and our result is consistent with the nonexistence of anomalons.     

CFD在燃煤细粒子凝聚过程中的应用

燃煤产生的细粒子富集了大量的有毒痕量元素,对大气环境和人类健康造成严重危害。本文针对燃煤细粒子的形成过程,在计算流体力学(CFD)的基础上,结合气溶胶动力学理论,模拟了烟气中细粒子在圆柱形流场中由于碰撞而凝聚的过程,并通过计算结果分析细粒子颗粒特征参量(速度、质量、直径和颗粒数目)随流场的变化趋势,为深入研究燃煤细粒子的形成演化机理提供理论基础。     

System Identification Models of the Equivalent Permittivity for Rain Medium

The dielectric constant for rain medium is investigated by utilizing the system identification method. The rain rate model and frequency model of permittivity in millimeter waves band for rain medium are presented. The results obtained with models are in very good agreement with references in calculating the attenuation of electromagnetic waves induced by rain, which Shows that the obtained models are valid and practicable. The cross-polar discrimination gotten with rain rate model is in agreement with references.     

Resistivity－temperature characteristics of sol gel YBa2Cu3Oy samples synthesized in flowing oxygen atmosphere

The relationship of resistivity versus synthesizing temperature of sol gel YBa_2Cu_3O_y samples was studied when prepared under flowing oxygen conditions. A set of high-temperature ρ－T curves was obtained for the whole process. After the sample finished the test measuring, its resistivity was ρ_{300}=9.83×10^{-3 }Ω·cm at room temperature. The ρ－T curve also showed that the orthorhombic－tetragonal phase transformation of sol-gel YBa_2Cu_3O_y sample occurred at 581℃ for the sample in the rising temperature process, but at 613℃ in the cooling process, lower than that of the samples made by using the conventional powder metallurgy methods.     

Analysis on Shack–Hartmann wave-front sensor with Fourier optics

In Shack–Hartmann wavefront sensor (SHWS), the behavior of the irradiance pattern produced by the micro-lens array is important for an accurate centroid estimation. In this paper, the behavior of a micro-lens array in SHWS is analyzed using Fourier optics, and reveals that in addition to the main, expected spots, secondary spots with smaller intensities also appeared as a result of diffraction by the small dimensions of the micro-lens and interference from the different micro-lenses. This result is confirmed by comparing with a irradiance pattern taken from an actual SHWS. The additional error in centroid estimation caused by these secondary spots is discussed and relationship to the parameters of the micro-lens of SHWS is analyzed.     

WEIGHTED APPROXIMATION ON SZASZ—TYPE OPERATORS

In this paper, we use weighted modules ω(?)(f,t)w to study the pointwise approximation on Szasz-type operators, and obtain the direct and converse theorem, as well as characterizations of the pointwise approximation of Jacobi-weighted Szasz-type operators.     

Multi-layer thin films/substrate system subjected to non-uniform misfit strains

Current methodologies used for the inference of thin film stress through curvature measurement are strictly restricted to stress and curvature states that are assumed to remain uniform over the entire film/substrate system. These methodologies have recently been extended to a single layer of thin film deposited on a substrate subjected to the non-uniform misfit strain in the thin film. Such methodologies are further extended to multi-layer thin films deposited on a substrate in the present study. Each thin film may have its own non-uniform misfit strain. We derive relations between the stresses in each thin film and the change of system curvatures due to the deposition of each thin film. The interface shear stresses between the adjacent films and between the thin film and the substrate are also obtained from the system curvatures. This provides the basis for the experimental determination of thin film stresses in multi-layer thin films on a substrate.     

An Additive Problem with Primes in Arithmetic Progressions

In this paper, we extend a classical result of Hua to arithmetic progressions with large moduli. The result implies the Linnik Theorem on the least prime in an arithmetic progression.     

Entanglement Evolution of a 2-Qutrit System Interacting with a Fermionic Bath

Based on the algebraic entanglement measure proposed [G. Vidal et al., Phys. Rev. A 65 (2002) 032314],we study the entanglement evolution of both pure quantum states and mixed ones of 2-qutrit system in a symmetrybroken environment consisting of a fermionic bath. Entanglement of states will decrease or remain constant under the influence of environment, and the class of states which remain unchanged has been found out.