银微电极微分电位溶出分析法研究

本文首次报道了银微电极微分电位溶出分析法。用化学刻蚀法方便地制作了银微电极，用于ＤＰＳＡ具有背景值低，分辨率好、精密度及灵敏度高，在不搅拌，仅需一定酸度而酸度而无其它介质的条件下就能测试等优点，对人工试样及自来水样分析，结果令人满意。     

One-Pot Formation of Carbonates from the Reactions of Carbonyl Compounds with Samarium Diiodide and Methyl Chloroformate

Treatment of carbonyl compounds with SmI₂ and methyl chloroformate in the presence of molecular sieves provides the cyclic carbonates or biscarbonates of pinacols. This one-pot reaction proceeds rapidly even with aliphatic ketones. The stereochemistry obtained by this procedure is different from that of conventional pinacolic couplings.     

Evaluation of Eigenvalues by Successive Variations

A successive variation method was studied and tested on the hydrogen molecular ion H₂⁺. Results show that it takes less computational time than conventional method. It was also found that ground state wavefunction of H₂⁺ can be well approximated by the linear combination of the simplest Gaussian orbitals e^?I(T-a)3     

Degradation of ferric EDTA by Burkhol cepacia

EDTA, the target compound of this study from the effluent of secondary biotreatment units, can be biodegraded by special microorganisms. So far, there are three species of microorganisms—Agrobacterium, Gram-negative BNCI, and DSM9103—that can degrade EDTA and are published in the literature. We have successfully isolated a bacterial strain that can degrade EDTA. It was identified as Burkhol cepacia, an aerobic species, elliptically shaped with a length of 5–15 μm. The growth medium contains 1000 mg/L of ferric-EDTA as carbon source, 750 mg/L of (NH₄)₂SO₄+(NH₂)₂CO as nitrogen source, and 1000 mg/L of KH₂PO₄ as phosphorus source, and mineral factors such as Fe and Mg. Incubated at pH, 7.0, 30°C, and 150 rpm on a shaker for 15 d, the average specific growth rate of this microbe is 0.135 d⁻¹, which shows that the respective degradation efficiency of Fe-EDTA and Cu-EDTA is 90 and 75% individually.     

Infrared and electronic spectra of copper (II) complex of maleonitriledithiolate and 4,4'-dimethyl-2, 2'-bipyridine and their theoretical studies

The molecular structure and binding, as well as infrared and electronic spectroscopic properties for the title complex Cu(mnt)(dmbpy)(mnt(2-)=maleonitriledithiolate, dmbpy=4,4'-dimethyl-2,2'-bipyridine) were studied in this paper. With semi-empirical PM3 and non-empirical DFT (B3LYP/6-311G*) methods, the molecular geometry of the complex was optimized and corresponding vibrational spectra in the gaseous state were obtained. The calculated results derived from DFT were more reasonable than those from PM3. The point group of Cu(mnt)(dmbpy) in isolated gaseous state was C(2), in which Cu(II) adopted a distorted tetrahedral geometry and the dihedral angle between the N(2)Cu and S(2)Cu planes was about 29.814 degrees. And a complete assignment to the IR spectra of such a complicated molecule was exhibited. With ZINDO/S method an electronic spectrum was calculated. The results showed that the calculated values generally agreed with the observed ones. And a detailed explain was made on its electronic spectra.     

Carbon anode materials from polysiloxanes for lithium ion batteries

Three kinds of silicon-containing disordered carbons have been prepared by pyrolysis of polysiloxanes with different amounts of phenyl side groups. X-ray powder diffraction, X-ray photoelectron spectroscopy and electrochemical capacity measurements were performed to study their behaviors. Graphite crystallites, micropores, and silicon species affect their electrochemical performances. All of them present high reversible capacities, >372 mAh/g. Since the graphite crystallites are very small, they contribute very little to reversible capacity. The number of micropores produced by gas emission during the heat-treatment process decides whether they exhibit reversible capacity. Si mainly exists in the form C–Si–O and influences the irreversible capacity. There is no evident capacity fading in the first ten cycles, indicating promising properties for these disordered carbons.     

用θ-2θ型衍射仪测定溶液结构的新方法

叙述了用θ－２θ型Ｘ射线衍射仪精确测定电解质溶液结构的新实验技术。设计制作了具有恒温功能的超厚液体样品池，并建立了样品池窗口强度的校正方法。优化了液体Ｘ射线衍射数据和结构参数精细化的计算机程序，获得了非常令人满意的实验结果。由θ－２θ型Ｘ射线衍射仪精确测定的径向分布函数与θ－θ型衍射仪自由散射比较，表明ＤＲＦ分辨率有所提高。     

The Neutral Part of the Bark of Pinus Luchuensis Mayer

The neutral part of the acetone extract from the bark of Pinus luchuensis Mayer has been investigated and found to consist of alkanes (C₂₂–C₃₄) and triterpenes of serratene type. The triterpenes are 3β–methoxyserrat–14–en–21–one, serrat–14–en–3, 21–dione, 3β–hydroxyserrat–14–en–21–one, 3β–21α–dimethoxyserrat–l4–ene and 3β–methoxyserrat–14–en–21α–ol.     

Application of Functionalized Ag Nanoparticles for the Determination of Proteins at Nanogram Levels Using the Resonance Light Scattering Method

A novel method for the determination of proteins in aqueous solutions has been developed based on the enhancement of resonance light scattering (RLS) of Ag nanoparticles in the presence of proteins. Factors including acidity of the media, concentration of Ag hydrosol, reaction time, temperature, and interference of non-protein substances were investigated. Under the optimal conditions, with the enhanced RLS signals at 452nm, the linear ranges of calibration curves were 0–0.8µgmL^–1 for bovine serum albumin (BSA), 0–1.2µgmL^–1 for human serum albumin (HSA), and 0–2.5µgmL^–1 for human -IgG (-IgG), respectively. The detection limits were 1.3ngmL^–1 for BSA, 10ngmL^–1 for HAS, and 5.7ngmL^–1 for -IgG.This method has been applied to the analysis of synthetic samples and real human serum samples, and the results were in good agreement with those reported by the hospital, indicating that the method presented here is not only sensitive and simple, but also reliable and suitable for practical applications.     

The determination of trace amounts of tin by flow-injection hydride generation atomic-absorption spectrometry with on-line ion-exchange separation and preconcentration

A hydride generation atomic-absorption spectrometric (AAS) method with flow-injection (FI), aimed at developing a practical routine assay for the determination of tin in food digests, is described. In order to modify the sample matrix and to achieve optimized and reproducible conditions for the hydride generation reaction, the analyte is initially converted into its chlorostannate-complex thereby allowing it to be separated and preconcentrated on-line on an incorporated micro-column packed with a strongly basic anion exchanger and subsequently to be eluted by diluted nitric acid under strictly controlled conditions. Optimum acidic conditions for the FI hydride generation AAS system was found to be 0.01-0.05M nitric acid. At a consumption of 2.7-ml sample volume, aspirated by time-based injection, the procedure resulted in an enrichment factor of 3.5 and yielded a detection limit of 0.08 microg/l. (3sigma) at a sampling frequency of 72/hr. The precision was 2.5% rsd at the 10 microg/l. level. Potential interferents, such as Ni(II), Co(II), Zn(II) and Fe(III) could, at a Sn level of 10 microg/l., be tolerated at an excess of 1000 times without impairing the assay, while a 100-1000-fold excess of Cu(II) decreased the signal by 10-15%. Recoveries in the range 94-102% were obtained for canned food sample digests spiked with 10 microg/l. Sn.