一种新的判断高分子相容性的粘度判据

依据最近提出的高分子稀溶液粘度的浓度 依赖性的团簇理论 ,对高分子‘理想混合物’的定义进行了更新的理论分析 .在此基础上提出了一个新的判定高分子相容性的粘度判据 .从现有的大量实验数据看 ,该判据是和事实相符合的     

Preparation and mechanical properties of thermal energy storage microcapsules

A series of heat energy storage microcapsules was prepared using melamine-formaldehyde resin as the shell material and the mechanical properties of the shell were investigated. A phase change material whose melting point was 24 °C was used as core and the quantity of heat involved in phase transition was 225.5 J/g. Average diameter of the microcapsules varied from 5 to 10 μm, and the globular surface was smooth and compact. The mechanical properties of the shell were evaluated by observing the surface morphological structure change after application of pressure by means of scanning electron microscopy. When the mass ratio of the core and shell material is 3:1, a yield point of about 1.1×10⁵ Pa was found and when the compression was increased beyond this point the microcapsules showed plastic behavior. This has been attributed to the cross-link density and to the high degree of reaction of the shell material. Different yield points subsequently reflected differences in the mechanical behavior. It was also found that the mechanical intensity of double-shell microcapsules was better than that of single shelled ones.     

高效液相色谱手性流动相添加剂法拆分酪氨酸甲酯对映体

分别将β-环糊精、羟丙基-β-环糊精作为手性流动相添加剂，研究了酪氨酸甲酯对映体在反相HPLC系统中的拆分，考察了流动相种类、pH和手性流动相添加剂浓度对手性拆分的影响，建立了β-环糊精手性流动相添加剂法拆分酪氨酸甲酯对映体的方法。     

弹性体共混改性聚丙烯的增韧机理

阐述了以聚丙烯（ＰＰ）／高密度聚乙烯（ＨＤＰＥ）为复合基体，苯乙烯－丁二烯－苯乙烯（ＳＢＳ）为增韧剂经三元共混所得的性能优异的一类新材料．从三个层次（形貌结构转变、宏观力学响应和裂尖过程区演化）系统地探讨了其增韧机理．结果表明由形貌结构控制和对早期体膨胀变形抑制可造成裂尖平面应变区的超钝化从而达到增韧．     

用钛系载体高效催化剂进行乙烯-丙烯-1-丁烯三元共聚合的研究 Ⅰ.聚合条件对共聚合反应的影响

用多组份改性钛系载体催化剂TiCl_4,Ti(OBu)_4/MgCl_2/Ethylbenzeate(EB)/φ_2SiCl_2/AlEt_3进行了乙烯-丙烯-1-丁烯三元共聚合的研究。考察了单体进料比、聚合温度,烷基铝浓度和催化剂浓度等条件对共聚合的影响。发现本催化剂对乙丙丁三元共聚合有极高的催化效率,聚合1h达8.6×10~4g共聚物/g-Ti。共聚合速率衰减符合动力学方程:R_s=R_s+(R_0—R_s)_e~(βs)。     

微波合成铝掺杂钻酸锂材料及性能研究

以LiOH·H2O，Al2O3和Co3O4为原料，微波加热合成Li离子电池正极材料LiAlxCo（1-x）O2．通过XRD测试表征了不同Al加入量时合成产物的晶体结构，确定当x≤0．4时，产物为单一相层状结构．计算了不同x时LiAlxCo（1-x）O2的晶胞参数，随着x的增大，a值减小，c值增大．对合成LiAlxCo（1-x）O2样品进行DSC—TGA测试，结果表明，当x不同时，合成样品的热稳定性不同．SEM测试表明，合成晶体粒度较均匀，粒径在5μm左右．电化学测试表明，LiAl0.2Co0.8O2的电化学性能最好，首次循环放电容量为127mAh／g，多次循环容量损失率小于LiCoO2．     

四针状氧化锌晶须的制备及其吸波性能的研究

随着雷达探测、卫星通信、航天航空和电子对抗等高科技的发展，特别是近年来抗电磁波干扰、隐形技术、微波暗室等研究领域的兴起．对电磁波吸波材料的研究日益受到人们的重视。随着现代电子工业和信息产业的高速发展．产生电磁波的电子产品（诸如计算机、电视机、手机、微波炉及电磁炉等）的数量急剧增加，     

三异丙氧钐催化下醇的选择性乙酰化反应

本文报道了三异丙氧钐(5%)催化下，以乙酸乙酯为乙酰化试剂醇的选择性乙酰化反应。此法操作简便，产率良好。     

高分子量的枝状聚硅烷的合成与表征

根据硅氢加成反应机理设计了“顺点滴式”工艺 ,高效、低耗地合成了甲基苯乙基二氯硅烷和甲基正己基二氯硅烷 .根据Wurtz还原偶联反应原理 ,采用“预聚”和“混聚”两种工艺分别合成枝状共聚硅烷 ,发现运用“预聚”工艺可以合成分子量很高的枝状聚硅烷 .     

Cooperation of reducing species for NO reduction over Ag/Al2O3 under oxidizing conditions

Summary The cooperation effect of reducing species for selective reduction of NO over Ag/Al₂O₃ has been investigated in the presence of excess oxygen. When the combinations of propene or propane and ethanol or methanol were used as reducing agents, NO reduction took place over a wider temperature range, compared with a single hydrocarbon as reducing agent.