Micromachining of circular ring microstructure by femtosecond laser pulses

In this paper, integration of interference phenomenon into femtosecond laser micromachining was reported as the femtosecond laser pulses were reshaped spatially to perform ablation. The generation of circular interference pattern was demonstrated by overlapping infrared femtosecond laser pulses. The interference pattern was subsequently focused on a copper substrate to ablate microstructures of concentric circular rings. The present technique is expected to open up new applications in the areas of rapid fabrication of micro-Fresnel lenses, hybrid microlenses and lens arrays.     

Character of the thermal motion of water molecules according to the data on quasielastic incoherent scattering of slow neutrons

The paper discusses the applicability of quasi-crystalline approximation to describing the thermal motion of water molecules in their normal and supercooled states. The problem is subjected to the critical analysis of experimental data on incoherent scattering of slow neutrons based on theories developed by Singwi-Sjolander [1] and Oskotsky [2] modified to duly take into account the limited applicability range of diffusion approximation. The applicability conditions of quasi-crystalline approximation are shown to be consistently satisfied only when water is in supercooled state and within a narrow temperature range above the melting temperature.     

Investigation of hypersonic nozzle flow uniformity using NO fluorescence

Planar laser-induced fluorescence visualisation is used to investigate nonuniformities in the flow of a hypersonic conical nozzle. Possible causes for the nonuniformity are outlined and investigated, and the problem is shown to be due to a small step at the nozzle throat. Entrainment of cold boundary layer gas is postulated as the cause of the signal nonuniformity. PACS 47.80.Jk, 47.40.Ki, 47.60.+i     

Approximate inverse computation using Frobenius inner product

Parallel preconditioners are presented for the solution of general linear systems of equations. The computation of these preconditioners is achieved by orthogonal projections related to the Frobenius inner product. So, min_M∈??∥AM?I∥ _F and matrix M₀∈?? corresponding to this minimum (?? being any vectorial subspace of ??_n(?)) are explicitly computed using accumulative formulae in order to reduce computational cost when subspace ?? is extended to another one containing it. Every step, the computation is carried out taking advantage of the previous one, what considerably reduces the amount of work. These general results are illustrated with the subspace of matrices M such that AM is symmetric. The main application is developed for the subspace of matrices with a given sparsity pattern which may be constructed iteratively by augmenting the set of non‐zero entries in each column. Finally, the effectiveness of the sparse preconditioners is illustrated with some numerical experiments. Copyright © 2002 John Wiley & Sons, Ltd.     

Pulse radiolysis study of the initial steps of the polymerization of cyclohexyl acrylate and cyclohexyl methacrylate

Pulse radiolysis with kinetic spectroscopic detection was applied to study the kinetics of the first steps of radiation induced polymerization of cyclohexyl acrylate and cyclohexyl methacrylate in cyclohexane solvent. The reactions were initiated by cyclohexyl radicals produced in the radiolysis of the solvent. The transient absorption spectra of the -carboxyalkyl type radicals produced in addition reaction show maxima around 300 nm. This shifts to longer wavelength with time after the pulse. This phenomenon was explained by the oligomerization reaction. From the kinetic curves average rate coefficients of termination for the oligomer radicals (2k_t) were determined as a function of time elapsed after the electron pulse. The values obtained were compared with those calculated for other (acrylate and methacrylate type) monomers.     

Phase separation in blends of two homopolymers and a diblock copolymer during film casting

Demixing during film casting of blends of polystyrene, polymethylmethacrylate, and a symmetric diblock copolymer of styrene and methylmethacrylate is discussed. The concentration fluctuations in the homogeneous solutions were calculated in mean field approximation. The structures in the homogeneous and demixed solutions and in the dry films were measured by small-angle x-ray scattering, and the morphologies of the dry films were characterized by transmission electron microscopy. The structure of the dry blends is evidently already pre-formed in solution.