Bridged Ferrocenes VIII. Correlation of redox potentials with structure

The redox potentials for oxidation of ferrocenes with hydrocarbon bridges and of corresponding ketoferrocenes were measured. For the reduced compound correlations were observed between the potentials and the iron to ring distances. For the ketoferrocenes, the importance of proper alignment of the carbonyl with the cyclopentadienyl rings is noted. Other possible relationships are discussed.     

Single-electron-capture cross sections for 0.4–5.0 keV He+ ions incident on alkali-vapor targets

Total cross sections for single-electron capture by He⁺ ions in vapor targets of Cs, Rb, K and Na have been determined in the energy range 0.4–5.0 keV. The energy dependence of the cross-section curves is very similar for all the targets. The cross sections for all the targets are maximum at about the same energy, 1.5 keV. Comparison is made with other reported experimental and theoretical results.     

Base promoted oxidative decarboxylation of ethyl phenylglycinate via oxaziridine

Base catalyzed decompositions of 2-(α-ethoxycarbonyl-benzyl)-3-phenyl-oxaziridines carried out in benzene in an atmosphere of oxygen yielded N-benzoyl benzamides along with ethyl phenylglyoxylate imine and benzaldehydes.     

Circumventing air bubbles in microfluidic systems and quantitative continuous-flow PCR applications

Polymerase chain reaction (PCR) is an essential part of research based on genomics or cell analysis. The development of a microfluidic device that would be suitable for high-temperature-based reactions therefore becomes an important contribution towards the integration of micro-total analysis systems (μTAS). However, problems associated with the generation of air bubbles in the microchannels before the introduction of the assay liquid, which we call the “initial start-up” in this study, made the flow irregular and unstable. In this report, we have tried to address these problems by adapting a novel liquid-flow method for high-temperature-based reactions. A PDMS-based microfluidic device was fabricated by soft-lithography techniques and placed on a cartridge heater. The generation of the air bubbles was prevented by introducing the fluorinated oil, an inert and highly viscous liquid, as the cap just before the introduction of the sample solutions into the microchannels. The technique was applied for continuous-flow PCR, which could perform PCR on-chip in a microfluidic system. For the evaluation of practical accuracy, plasmid DNA that serves as a reference molecule for the quantification of genetically modified (GM) maize was used as the template DNA for continuous-flow PCR. After PCR, the products were collected in a vial and analyzed by gel electrophoresis to confirm the accuracy of the results. Additionally, quantitative continuous-flow PCR was performed using TaqMan technology on our PCR device. A laser detection system was also used for the quantitative PCR method. We observed a linear relationship between the threshold cycle (Ct) and the initial DNA concentration. These results showed that it would be possible to quantify the initial copies of the template DNA on our microfluidic device. Accurate quantitative DNA analysis in microfluidic systems is required for the integration of PCR with μTAS, thus we anticipate that our device would have promising potential for applications in a wide range of research.     

Anomalous bumpy structures in the capture cross sections of antiprotons by helium

We investigate the state-specified capture process of antiprotons by helium. Freezing one of the two electrons, we reduce this four-body rearrangement problem into a three-body problem. The capture cross sections are calculated by solving the Chew-Goldberger-type integral equation. Differing from the capture of antiprotons by hydrogen atoms, the bumpy structures are revealed in the total angular momentum dependent capture cross sections. Further analysis shows that the bumps arise from the partial channel closing due to the removal of the energy degeneracy in the antiprotonic helium.