Gas chromatography–triple-quadrupole mass spectrometry for analysis of selected polyhalogenated pollutants in plants. Comparison of extraction methods

Different extraction methods, followed by gas chromatography coupled to triple quadrupole mass spectrometry, were evaluated for simultaneous extraction of seven polychlorinated biphenyls (PCBs) and six polybrominated diphenyl ethers (PBDEs) from common weeds. Pressurized liquid extraction (PLE) with in-cell clean-up, ultrasound-assisted extraction (UAE) with in-column clean-up, and UAE with dispersive solid-phase extraction (dSPE) clean-up were evaluated and compared. In-cell clean-up with 4 g Florisil and 0.5 g graphitized carbon black (GCB) and two extraction cycles of 10 min with n-hexane–ethyl acetate 80:20 (v/v) at 60 °C were used for the PLE procedure. UAE with in-column clean-up was conducted under conditions similar to those reported for the PLE method whereas in UAE with dSPE clean-up purification of the extract was performed after extraction using primary and secondary amine sorbent (PSA) and GCB. Recovery from 82 to 104 % was obtained for all the compounds by PLE whereas, in general, lower extraction efficiency was obtained by UAE with in-column clean-up (especially for BDE-17 and BDE-183, for which recovery was 70 and 41 %, respectively) and by UAE with dSPE clean-up, for which the main drawback is that BDE-183 cannot be extracted. Finally, PLE was used for analysis of PCBs and PBDEs in different plants (Lolium rigidum, Lactuca serriola, Malva sylvestris, and Verbascum thapsus) collected from residential and/or rural areas of Madrid (Spain). Several of the analyzed compounds were detected at low levels in these plants, but only PCB-153 could be quantified.

A paradigm shift in rate determining step from single electron transfer between phenylsulfinylacetic acids and iron(III) polypyridyl complexes to nucleophilic attack of water to the produced sulfoxide radical cation: a non‐linear Hammett

Mechanism of oxidative decarboxylation of phenylsulfinylacetic acids (PSAAs) by iron(III) polypyridyl complexes in aqueous acetonitrile medium has been investigated spectrophotometrically. An initial intermediate formation between PSAA and [Fe(NN)₃]³⁺ is confirmed from the observed Michaelis–Menten kinetics and fractional order dependence on PSAA. Significant rate retardation with concentration of [Fe(NN)₃]³⁺ is rationalized on the basis of coordination of a water molecule at the carbon atom adjacent to the ring nitrogen of the metal polypyridyl complexes by nucleophilic attack at higher concentrations. Electron‐withdrawing and electron‐releasing substituents in PSAA facilitate the reaction and Hammett correlation gives an upward ‘V’ shaped curve. The apparent upward curvature is rationalized based on the change in the rate determining step from electron transfer to nucleophilic attack, by changing the substituents from electron‐releasing to electron‐withdrawing groups. Electron‐releasing substituents in PSAA accelerate the electron transfer from PSAA to the complex and also stabilize the intermediate through resonance interaction leading to negative reaction constants (ρ). Conversely, electron‐withdrawing groups, while retarding the electron transfer exert an accelerating effect on the nucleophilic attack of H₂O which leading to low magnitude of ρ⁺ compared to high ρ^? values of electron‐releasing groups. Marcus theory is applied, and a fair agreement is seen with the experimental values. Copyright © 2016 John Wiley & Sons, Ltd.     

Molecular Recognition of Nucleotides in Water by Scorpiand‐Type Receptors Based on Nucleobase Discrimination

The detection of nucleotides is of crucial importance because they are the basic building blocks of nucleic acids. Scorpiand‐based polyamine receptors functionalized with pyridine or anthracene units are able to form stable complexes with nucleotides in water, based on coulombic, π–π stacking, and hydrogen‐bonding interactions. This behavior has been rationalized by means of an exploration with NMR spectroscopy and DFT calculations. Binding constants were determined by potentiometry. Fluorescence spectroscopy studies have revealed the potential of these receptors as sensors to effectively and selectively distinguish guanosine‐5′‐triphosphate (GTP) from adenosine‐5′‐triphosphate (ATP).     

Enhanced photocatalytic activity of zeolite-encapsulated TiO2 clusters by complexation with organic additives and N-doping.

In the literature it was found that titanium oxide clusters of a few metal atoms encapsulated inside the micropores of zeolite Y exhibit large blue shifts in the Ti-O ligand-to-metal charge-transfer band as compared to non-encapsulated bulk titanium dioxide particles. This blue shift of the Ti-O absorption band is believed to have a negative effect on the photocatalytic activity of zeolite-encapsulated TiO2. We report here on circumventing this problem and increasing visible-light absorption by means of a red shift of the absorption band caused by addition of some organic molecular modifiers containing acidic OH groups that can strongly bind with titanol groups TiOH. In the studied series of zeolite-encapsulated TiO2 samples, the red shift of the optical spectrum follows the order: catechol > 4-aminobenzoic acid > benzoic acid. Also N-doping of zeolite-encapsulated TiO2 clusters by thermal treatment with urea leads to a red shift of the TiO2 absorption band that depends on the annealing and hydration conditions. By comparison to the degradation of phenol in aqueous solution, we have demonstrated that these changes in the absorption spectrum on addition of the organic modifier are also reflected in the photocatalytic activity of the samples; a greater increase in photocatalytic activity (about 30%) was observed for the additive catechol.     

Molecularly imprinted capillary electrochromatography for selective determination of thiabendazole in citrus samples

In this work, the suitability of the combination of molecular imprinting and capillary electrochromatography (MIP-CEC) to be used as powerful tool in environmental or food analysis has been for the first time studied and successfully demonstrated. A molecularly imprinted monolith (MIM) has been synthesised and evaluated as stationary phase for the selective determination of the fungicide thiabendazole (TBZ) in citrus samples by non-aqueous capillary electrochromatography. The influence of the mobile phase composition, the voltage of the power supply and the separation temperature on the recognition of TBZ by the imprinted polymer has been evaluated, and the imprint effect in the MIM was clearly demonstrated. Once optimum recognition conditions were established, other variables affecting mechanical properties and chromatographic performance of MIM were adjusted using computational approach. The high selectivity achieved by the MIP-CEC developed procedure allowed unambiguous detection and quantification of TBZ in citrus samples by direct injection of the crude sample extracts, without any previous clean-up, in less than 6 min. The developed method was properly validated and the calculated detection limits were below the established maximum residue limits (MRLs), clearly demonstrating the suitability of the method to be used for the control of the selected fungicide.     

PAH metabolism in the earthworm Eisenia fetida – identification of phase II metabolites of phenanthrene and pyrene

Polycyclic aromatic hydrocarbons (PAHs) are soil contaminants. Because of their high lipophilicity, PAHs are associated with the organic matter in the soil. Transformation of PAHs generates polar metabolites and the interaction with organic matter in the soil changes. The polar PAH metabolites are persistent, highly water-soluble and potentially leachable from the soil; the understanding of transformation of PAHs to polar metabolites in the responsible organisms is of great importance. Here, we present a study of transformation of the PAHs pyrene and phenanthrene, by the common earthworm Eisenia fetida. The study showed that E. fetida in hydroponic culture was able to transform PAHs to conjugated phase II metabolites. We detected phenanthrene and pyrene metabolites with single- and multiple-phase II-conjugated groups. Sulphate conjugates were excreted to experiment water, and glucuronide and glucoside conjugates and metabolites with several hydroxylations and multiple conjugations were detected in worm tissue. The results demonstrate that earthworms are able to transform PAHs to water-soluble phase II metabolites, which can be excreted to the surrounding environment.     

Mechanical reinforcement of granular hydrogels

Granular hydrogels are composed of hydrogel-based microparticles, so-called microgels, that are densely packed to form an ink that can be 3D printed, injected or cast into macroscopic structures. They are frequently used as tissue engineering scaffolds because microgels can be made biocompatible and the porosity of the granular hydrogels enables a fast exchange of reagents, waste products, and if properly designed even the infiltration of cells. Most of these granular hydrogels can be shaped into appropriate macroscopic structures, yet, these structures are mechanically rather weak. The poor mechanical properties prevent the use of these structures as load-bearing materials and hence, limit their field of applications. The mechanical properties of granular hydrogels depend on the composition of microgels and the interparticle interactions. In this review, we discuss different strategies to assemble microparticles into granular hydrogels and highlight the influence of inter-particle connections on the stiffness and toughness of the resulting materials. Mechanically strong and tough granular hydrogels have the potential to open up new fields of their use and thereby to contribute to fast advances in these fields. In particular, we envisage them to be well-suited as soft actuators and robots, tissue replacements, and adaptive sensors.

The mechanical properties of granular hydrogels are strongly influenced by interparticle interactions. In this review, we compare the storage, compressive and tensile moduli of granular hydrogels cured using various interparticle interactions.     

The snowblower problem

We introduce the snowblower problem (SBP), a new optimization problem that is closely related to milling problems and to some material-handling problems. The objective in the SBP is to compute a short tour for the snowblower to follow to remove all the snow from a domain (driveway, sidewalk, etc.). When a snowblower passes over each region along the tour, it displaces snow into a nearby region. The constraint is that if the snow is piled too high, then the snowblower cannot clear the pile.We give an algorithmic study of the SBP. We show that in general, the problem is NP-complete, and we present polynomial-time approximation algorithms for removing snow under various assumptions about the operation of the snowblower. Most commercially available snowblowers allow the user to control the direction in which the snow is thrown. We differentiate between the cases in which the snow can be thrown in any direction, in any direction except backwards, and only to the right. For all cases, we give constant-factor approximation algorithms; the constants increase as the throw direction becomes more restricted. Our results are also applicable to robotic vacuuming (or lawnmowing) with bounded-capacity dust bin.