Synthesis and characterization of a new gemini surfactant derived from 3alpha,12alpha-dihydroxy-5beta-cholan-24-amine (steroid residue) and ethylenediamintetraacetic acid (spacer)

A new gemini steroid surfactant derived from 3alpha,12alpha-dihydroxy-5beta-cholan-24-amine (steroid residue) and ethylenediamintetraacetic acid (spacer) was synthesized and characterized in aqueous solution by surface tension, fluorescence intensity of pyrene, and light scattering (static and dynamic) measurements. These techniques evidence the existence of a threshold concentration (cac), below which a three layers film is formed at the air-water interface. Above the cac, two types of aggregates--micelles and vesicle-like aggregates--coexist in a metastable state. Filtration of a solution with a starting concentration of 2.6 mM (buffer 150 mM, pH 10) allows isolation of the micelles, which have an average aggregation number of 12, their density being 0.28 g cm(-3). Under conditions where only the vesicle-like aggregates are detected by dynamic light scattering, a value of 5.5 x 10(4) was obtained for their aggregation number at 30 microM, their density being 6.8 x 10(-4) g cm(-3). At high concentrations, the intensity ratio of the vibronic peaks of pyrene, I1/I3, (=0.68) is very close to published values for deoxycholate micelles, indicating that the probe is located in a region with a very low polarity and far from water. A hypothesis to explain the observed aggregation behavior (small aggregates are favored with increasing gemini concentration) is outlined.     

A Racemic and Enantiopure Unsymmetric Diiron(III) Complex with a Chiral o‐Carborane‐Based Pyridylalcohol Ligand: Combined Chiroptical,Magnetic, and Nonlinear Optical Properties

The design of molecule‐based systems combining magnetic, chiroptical and second‐order optical nonlinear properties is still very rare. We report an unusually unsymmetric diiron(III) complex 1 , in which three bulky chiral carboranylpyridinealkoxide ligands ( o CB hmp^?) bridge both metal ions and the complex shows the above‐mentioned properties. The introduction of o‐carborane into the 2‐(hydroxymethyl)pyridine (hmpH) architecture significantly alters the coordination of the simple or aryl‐substituted 2‐hmpH. The unusual architecture observed in 1 seems to be triggered by the poor nucleophilicity of our alkoxide ligand ( o CB hmp^?). A very rare case of spontaneous resolution takes place on precipitation or exposure to solvent vapor for the bulk compound, as confirmed by a combination of single‐crystal and powder X‐ray diffraction, second‐harmonic generation, and circular dichroism. The corresponding enantiopure complexes (+) 1 and (?) 1 have also been synthesized and fully characterized. This research provides a new building block with unique geometry and electronics to construct coordination complexes with multifunctional properties.     

Influence of the quantum dot shape on the determination of the electronic structure and electron decoherence

Theoretical calculations of electron–phonon scattering rates in AlGaN/GaN quantum dots (QDs) have been performed by means of effective mass approximation in the frame of finite element method. The influence of a symmetry breaking of the carrier's wave function on the electron dephasing time is investigated for various QDs shapes. In a QD system the electron energy increases when the QD shape changes from a spherical to a non-spherical form. In addition, the influence of the QD shape upon the electronic structure can be modulated by external magnetic fields. We also show that the electron–acoustic phonon scattering rates strongly depend upon both the QD shape and the applied magnetic field. As an additional parameter, the QD shape can be used to modify the electron–acoustic phonon interaction in a wide range. Moreover, the scattering rate of different transitions, such as Δm=0(1), presents distinct magnetic field dependency.     

Peroxygenase‐Catalyzed Oxyfunctionalization Reactions Promoted by the Complete Oxidation of Methanol

Peroxygenases catalyze a broad range of (stereo)selective oxyfunctionalization reactions. However, to access their full catalytic potential, peroxygenases need a balanced provision of hydrogen peroxide to achieve high catalytic activity while minimizing oxidative inactivation. Herein, we report an enzymatic cascade process that employs methanol as a sacrificial electron donor for the reductive activation of molecular oxygen. Full oxidation of methanol is achieved, generating three equivalents of hydrogen peroxide that can be used completely for the stereoselective hydroxylation of ethylbenzene as a model reaction. Overall we propose and demonstrate an atom‐efficient and easily applicable alternative to established hydrogen peroxide generation methods, which enables the efficient use of peroxygenases for oxyfunctionalization reactions.     

Regioselectivity in the ligand-assisted addition of vinylmagnesium bromide: an experimental and theoretical study on the gamma-alkoxycyclobutenone model

Compounds 2 (M = Mg) obtained in the mono addition of vinylmagnesium bromide to squarates are attractive structural models to determine the influence of complexation between magnesium(II) and the alkoxide group on the regioselectivity of the 1,2- versus 1,4-addition of organomagnesium by complex induced proximity effects (CIPE). The 1,4-addition is observed almost exclusively in the case of vinylmagnesium in THF solution with formation of hydroxyketones type 5, which are always side or minor products in the known reaction of alkenyllithium derivatives. A comparative study on the reactivity of alkenyllithium and magnesiun derivatives is reported. The high regioselectivitity observed in the 1,4-addition of vinylmagnesium bromide is fully understood by computational studies of compounds 2 (M = Mg) at the DFT level with the density functional B3LYP.     

Indene-based scaffolds. Design and synthesis of novel serotonin 5-HT6 receptor ligands

A series of novel indene derivatives designed by a scaffold selection gave access to several examples of (Z)-arylmethylideneindenes and indenylsulfonamides that acted as serotonin 5-HT(6) receptor ligands. Different synthetic multistep routes could be applied to these target compounds, each with their own complexity and limitations. A reasonable route involved the (3-indenyl)acetic acids as the key intermediates, and two alternatives were also examined. The first protocol used was a two-step sequence employing a modified Horner-Wadsworth-Emmons reaction, but better results were obtained with a procedure based on the condensation of indanones with the lithium salt of ethyl acetate, followed immediately by dehydration with acid and hydrolysis/isomerization under basic catalysis. (3-Indenyl)acetic acids were transformed to the corresponding acetamides, which were effectively reduced to indenylsulfonamides using an optimized procedure with AlH(3)-NMe(2)Et. The binding at the 5-HT(6) receptor was with moderate affinity (K(i) = 216.5 nM) for the (Z)-benzylideneindenylsulfonamide and enhanced affinity for the simple indenylsulfonamide counterpart (K(i) = 50.6 nM). Selected indenylsulfonamides were then tested, showing K(i) values as low as 20.2 nM.     

Structure-composition relationships in ternary solvents containing methylbenzoate

Thermophysical properties of the hexane+1-chlorohexane (or hexanoic acid or diisopropylether)+methylbenzoate ternary systems and their binary constituents are reported at 298.15 K and 0.1 MPa over the whole composition range. The properties and the optimized geometry of the gas-phase components were appraised from the density functional theory. To find out the causal link between the thermophysical measurements and the molecular level features, the derived mixing and excess functions of the ternary systems were looked into according to the scaled particle and Kirkwood-Buff analyses. The hydrogen bonding and dipole interactions along with the geometry effects brought about by the very different size and shape of the components give rise to complex mixed structures. Application of semiempirical models and use of simple cubic equations of state combined with a one-parameter van der Waals mixing rule has led to prediction of the ternary properties with variable degree of precision.     

On the properties of methylbenzoate/n-hexane mixed solvents: a theoretical and experimental study

This paper reports on an experimental and theoretical study of methylbenzoate/n-hexane mixed solvents as a function of pressure and temperature in the whole composition range. We have measured the pressure-volume-temperature (PVT) behavior of these fluids over wide temperature and pressure ranges; from the experimental data, relevant derived coefficients required for the fluid's characterization were calculated. The structure of mixed fluids was analyzed from macroscopic data according to excess and mixing properties. The statistical associating fluid theory (SAFT) and perturbed chain (PC)-SAFT molecularly based equations of state were used to predict the PVT behavior with model parameters for pure fluids fitted from correlation of available saturation literature data. The results provided by the PC-SAFT equation of state were clearly superior. Using the fitted PC-SAFT parameters, the global phase behavior of the mixture was predicted, and a type I pattern was inferred according to the van Konynenburg systematic. The molecular level structure was studied through classical molecular dynamics simulations in the NPT ensemble using the optimized potential for liquid simulations (all atom version) (OPLS-AA) force field. Molecular dynamics provides, on one hand, theoretical values of thermophysical properties, which are compared with the experimental ones to check the quality of simulations, and, on the other hand, valuable molecular level structural and dynamic information. Based on both macroscopic and microscopic studies, fluid structure was inferred.     

Size‐exclusion chromatographic NMR of polymer mixtures

The use of chromatographic stationary phases or solvent modifiers to modulate diffusion properties in NMR experiments is now well established. Their use can be to improve resolution in the diffusion domain or to provide an insight into analyte–modifier interactions and, hence, the chromatography process. Here, we extend previous work using size‐exclusion chromatographic stationary phases to the investigation of polymer mixtures. We demonstrate that similar diffusion modulation behaviour is observed with a size‐exclusion chromatographic stationary phase that can be understood in terms of size‐exclusion behaviour. Copyright © 2014 John Wiley & Sons, Ltd.