Conformational effects on the performance and selectivity of a polymeric pseudostationary phase in electrokinetic chromatography

The effect of the conformation of a polymeric pseudostationary phase on performance and selectivity in electrokinetic chromatography was studied using an amphiphilic pH-responsive polymer that forms compact intramolecular aggregates (unimer micelles) at low pH and a more open conformation at high pH. The change in conformation was found to affect the electrophoretic mobility, retention, selectivity, and separation efficiency. The low-pH conformer has higher electrophoretic mobility and greater affinity for most solutes. The unimer micelle conformation was also found to provide a solvation environment more like that of micelles and other amphiphilic self-associative polymers studied previously. It was not possible to fully characterize the effect of conformation on efficiency, but very hydrophobic solutes with long alkyl chains appeared to migrate with better efficiency when the unimer micelle conformation was employed. The results imply that polymers with a carefully optimized lipophilic-hydrophilic balance that allow self-association will perform better as pseudostationary phases. In addition, the results show that electrokinetic chromatography is a useful method for determining the changes in solvation environment provided by stimuli-responsive polymers with changes in the conditions.     

Acrolein polymerization: Monodisperse,homo, and hybrido microspheres,synthesis, mechanism,and reactions

Monodisperse polyacrolien (PA) microspheres were obtained by a single step process via two mechanisms: (a) aqueous polymerization of acrolein under alkaline conditions and (b) aqueous radical polymerization of acrolein by irradiation with a cobalt source. The diameter of the former microspheres can be varied from 0.04 up to 8 μm. The monodispersity of the system is also discussed. The diameter of the latter microspheres can be varied up to 0.2 μm. Hybrido PA microspheres were formed by grafting PA microspheres of average diameter of 0.1 μm obtained by irradiation onto the surface of PA microspheres produced by the alkaline mechanism. The aldehyde content of the microspheres prepared by irradiation is much higher than those of the microspheres formed under alkaline conditions. The aldehyde groups were used for the covalent binding of ligands containing primary amino groups, such as proteins and drugs, in a single step under physiological pH.     

4H-Chromenone Glycosides from Eranthis hyemalis (L.) SALISBURY

Investigation of the tubers of Eranthis hyemalis (Ranunculaceae) afforded six chromenone glycosides. Their structures have been elucidated mainly by spectroscopic (FAB-MS, 2D-NMR techniques) and chemical methods (acidic and enzymatic hydrolysis) as 9-{[(β-D -glucopyranosyl)oxy]methyl}-8,11-dihydro-5-hydroxy-2-methyl-4H-pyrano[2,3-g][1]benzoxepin-4-one ( 1 ), 9-{[(β-D -gentiobiosyl)oxy]methyl}-8,11-dihydro-5-hydroxy-2-methyl-4H-pyrano[2,3-g][1]benzoxepin-4-one( 2 ), 9-{[(β-D -glucopyranosvl)oxy]melhyl}-8,11-dihydro-5-hydroxy-2-(hydroxy-methyl)-4H-pyrano[2,3-g][1]benzoxepin-4-one( 3 ), 8-{(2E)-4-[(β-D -glucopyranosyl)oxy]-3-methylbut-2-enyl}-5,7-dihydroxy-2-methyl-4H-1-benzopyran-4-one ( 4 ), 8-{(2E)-4-[(β-D -glucopyranosyi)oxy]-3-methylbut-2-enyl}-5,7-dihydroxy-2-(hydroxymethyl)-4H-1-benzopyran-4-one ( 5 ), and 7-{[(β-D -glucopyranosy1)oxy]methyl}-2,3-dihydro-2-(l-hydroxy-1-methylethyl)-4-methoxy-5H-furo[3,2-g][1]benzopyran-5-one ( 6 ). Compound 2 exhibited negative inotropic activity.     

Stripping Analysis of Trace Metals at a Flow-Through Reticulated Vitreous Carbon Electrode after the Preconcentration by Supported Liquid Membrane Technique

Abstract

The performance of a flow-through mercury coated reticulated vitreous carbon (RVC) electrode in the potentiometric stripping analysis (PSA) of trace metals has been examined. A wall-jet glassy carbon cell was used for the comparative experiments. Experimental parameters influencing the stripping signals have been optimised in order to use the stripping analysis after the preconcentration and matrix isolation by supported liquid membrane (SLM) technique. The SLM with di-2-ethylhexyl-phosphoric acid (DEHPA) as the extractant in the membrane liquid for proton driven transport of trace metals across the membrane has been chosen. Results presented for lead determination in river water demonstrate the analytical advantages of coupled technique SLM-PSA.     

Effects of structural properties of silicon carbide-derived carbons on their electrochemical double-layer capacitance in aqueous and organic electrolytes

High surface area silicon carbide-derived carbons (Si-CDCs) synthesized by chlorination of beta silicon carbide (βSiC) with two different particle sizes (6 μm and 50 nm) show different porosities with graphitic structure. Transmission electron microscopy, Raman spectroscopy and argon (Ar) and carbon dioxide (CO₂) sorption analyses are used to examine the textural properties of the Si-CDCs. The results show that the particle size of the precursor affects the surface area and porosity of carbons. Furthermore, an additional heat treatment of the Si-CDC with 50-nm particle size for 24 h at 1,000 °C results in a collapse of the pore structure and reduces the surface area. The capacitive behaviours are investigated in H₂SO₄ and in tetraethyl ammonium tetrafluoroborate (TEABF₄)/acetonitrile (AN). The electrochemical performance of the Si-CDCs is influenced by the particle size, surface area, pore volume and pore size distribution. The Si-CDCs exhibit capacitances in 1 M H₂SO₄ of up to 179 F g^?1 and very stable charge–discharge performance over 5,000 cycles. This study shows the crucial importance of ultramicropores less than 1 nm combined with nanosized particles for achieving high capacitance in aqueous electrolyte. Moreover, the graphitic degree at the surface of the Si-CDCs enhances considerably the rate capability and stability in both electrolytes.     

Electrochemical Approach for the Production of Layered Double Hydroxides with a Well-Defined Co/MeIII Ratio

Layered double hydroxides (LDHs) have been widely studied for their plethora of fascinating features and applications. The potentiostatic electrodeposition of LDHs has been extensively applied in the literature as a fast and direct method to substitute classical chemical routes. However, the electrochemical approach does not usually allow for a fine control of the M^II/M^III ratio in the synthesized material. By employing a recently proposed potentiodynamic method, LDH films of controlled composition are herein prepared with good reproducibility, using different ratios of the trivalent (Fe or Al) to bivalent (Co) cations in the electrolytic solution. All the obtained materials are shown to be effective oxygen evolution reaction (OER) catalysts, and are thoroughly characterized by a multi-technique approach, including FE-SEM, XRD, Raman, AES and a wide range of electrochemical procedures.     

Thermochemistry of Surfactant-Templating of USY Zeolite

With the aim of understanding the thermochemistry of the introduction of mesoporosity in zeolites by using surfactants, high temperature oxide melt solution calorimetry was used to determine the change in the enthalpy of formation of USY zeolite before and after the introduction of mesoporosity. Our results confirm that this process only slightly destabilizes the zeolite by the additional surface area. However, this can be overcome by the stabilizing effect of the interactions between the surfactant and the zeolite framework.     

Characterization of nanochannel delivery membrane systems for the sustained release of resveratrol and atorvastatin: new perspectives on promoting heart health

Novel drug delivery systems capable of continuous sustained release of therapeutics have been studied extensively for use in the prevention and management of chronic diseases. The use of these systems holds promise as a means to achieve higher patient compliance while improving therapeutic index and reducing systemic toxicity. In this work, an implantable nanochannel drug delivery system (nDS) is characterized and evaluated for the long-term sustained release of atorvastatin (ATS) and trans-resveratrol (t-RES), compounds with a proven role in managing atherogenic dyslipidemia and promoting cardioprotection. The primary mediators of drug release in the nDS are nanofluidic membranes with hundreds of thousands of nanochannels (up to 100,000/mm²) that attain zero-order release kinetics by exploiting nanoconfinement and molecule-to-surface interactions that dominate diffusive transport at the nanoscale. These membranes were characterized using gas flow analysis, acetone diffusion, and scanning and transmission electron microscopy (SEM, TEM). The surface properties of the dielectric materials lining the nanochannels, SiO₂ and low-stress silicon nitride, were further investigated using surface charge analysis. Continuous, sustained in vitro release for both ATS and t-RES was established for durations exceeding 1 month. Finally, the influence of the membranes on cell viability was assessed using human microvascular endothelial cells. Morphology changes and adhesion to the surface were analyzed using SEM, while an MTT proliferation assay was used to determine the cell viability. The nanochannel delivery approach, here demonstrated in vitro, not only possesses all requirements for large-scale high-yield industrial fabrication, but also presents the key components for a rapid clinical translation as an implantable delivery system for the sustained administration of cardioprotectants.     

Scaffold Effects on Osteogenic Differentiation of Equine Mesenchymal Stem Cells: An In Vitro Comparative Study

The in vitro viability, osteogenic differentiation, and mineralization of four different equine mesenchymal stem cells (MSCs) from bone marrow, periosteum, muscle, and adipose tissue are compared, when they are cultured with different collagen‐based scaffolds or with fibrin glue. The results indicate that bone marrow cells are the best source of MSCs for osteogenic differentiation, and that an electrochemically aggregated collagen gives the highest cell viability and best osteogenic differentiation among the four kinds of scaffolds studied.

     

Layered-double-hydroxide-modified electrodes: electroanalytical applications

Two-dimensional inorganic solids, such as layered double hydroxides (LDHs), also defined as anionic clays, have open structures and unique anion-exchange properties which make them very appropriate materials for the immobilization of anions and biomolecules that often bear an overall negative charge. This review aims to describe the important aspects and new developments of electrochemical sensors and biosensors based on LDHs, evidencing the research from our own laboratory and other groups. It is intended to provide an overview of the various types of chemically modified electrodes that have been developed with these 2D layered materials, along with the significant advances made over the last several years. In particular, we report the main methods used for the deposition of LDH films on different substrates, the conductive properties of these materials, the possibility to use them in the development of membranes for potentiometric anion analysis, the early analytical applications of chemically modified electrodes based on the ability of LDHs to preconcentrate redox-active anions and finally the most recent applications exploiting their electrocatalytic properties. Another promising application field of LDHs, when they are employed as host structures for enzymes, is biosensing, which is described considering glucose as an example.