Conformational effects on the performance and selectivity of a polymeric pseudostationary phase in electrokinetic chromatography

The effect of the conformation of a polymeric pseudostationary phase on performance and selectivity in electrokinetic chromatography was studied using an amphiphilic pH-responsive polymer that forms compact intramolecular aggregates (unimer micelles) at low pH and a more open conformation at high pH. The change in conformation was found to affect the electrophoretic mobility, retention, selectivity, and separation efficiency. The low-pH conformer has higher electrophoretic mobility and greater affinity for most solutes. The unimer micelle conformation was also found to provide a solvation environment more like that of micelles and other amphiphilic self-associative polymers studied previously. It was not possible to fully characterize the effect of conformation on efficiency, but very hydrophobic solutes with long alkyl chains appeared to migrate with better efficiency when the unimer micelle conformation was employed. The results imply that polymers with a carefully optimized lipophilic-hydrophilic balance that allow self-association will perform better as pseudostationary phases. In addition, the results show that electrokinetic chromatography is a useful method for determining the changes in solvation environment provided by stimuli-responsive polymers with changes in the conditions.     

Determination of trace elements and radioactive materials by substoichiometric isotope dilution analysis

Substoichiometric isotope dilution analysis has been applied for the determination of trace elements in liquid samples, of carrier content in radioisotope solution and of concentration of organic reagent. Cu in mineral acids and in ZnSe single crystal was determined by the substoichiometric extraction with dithizone. The values of 1.8 and 0.018 ppm in nitric acid and distilled one and of 1.4 and 0.44 ppm in ZnSe were obtained. Cu and P carrier contents in⁶⁴Cu and³²P solutions were determined by the substoichiometric extractions with dithizone in CCl₄ and with molybdic acid into MIBK in the series of the solutions adding various amounts of Cu or P carrier. An analogous method has been applied for the determination of dithizone and diethyldithiocarbamate solutions. The method was also applied for the determination of⁶⁰Co radioactivity in environmental samples. The analytical result of water samples is described.     

Solvent extraction of permanganates (Na, K) by 18-crown-6 ether from water into 1,2-dichloroethane: elucidation of an extraction equilibrium based on component equilibria

Ion-pair formation constants (K_MLA mol⁻¹ dm³) of Na⁺– and K⁺–18-crown-6 ether (18C6) complexes with MnO₄⁻ in water (w) were determined potentiometrically at 25 °C. Simultaneously, extraction constants (K_ex mol⁻² dm⁶) of the permanganates with 18C6 from w into 1,2-dichloroethane at 25 °C were obtained from the spectrophotometric determination of distribution ratios of the permanganates. These K_ex values were divided into K_MLA and other three component equilibrium constants and thereby extraction-selectivity and -ability were discussed in comparison with corresponding metal picrate–18C6 extraction systems reported before.     

Acrolein polymerization: Monodisperse,homo, and hybrido microspheres,synthesis, mechanism,and reactions

Monodisperse polyacrolien (PA) microspheres were obtained by a single step process via two mechanisms: (a) aqueous polymerization of acrolein under alkaline conditions and (b) aqueous radical polymerization of acrolein by irradiation with a cobalt source. The diameter of the former microspheres can be varied from 0.04 up to 8 μm. The monodispersity of the system is also discussed. The diameter of the latter microspheres can be varied up to 0.2 μm. Hybrido PA microspheres were formed by grafting PA microspheres of average diameter of 0.1 μm obtained by irradiation onto the surface of PA microspheres produced by the alkaline mechanism. The aldehyde content of the microspheres prepared by irradiation is much higher than those of the microspheres formed under alkaline conditions. The aldehyde groups were used for the covalent binding of ligands containing primary amino groups, such as proteins and drugs, in a single step under physiological pH.     

Determination of radioactive nuclides of uranium and thorium series and estimation of α-flux in LSI constituent materials

Gamma-rays of nuclides of uranium and thorium series in silicone resin and ceramics were measured with a Ge(Li) detector. The state of radioactive equilibrium was determined by comparing the concentrations of uranium and thorium with the radioactive concentrations of²¹⁴Pb and²¹²Pb. The radioactive equilibrium was attained in silicone resin but not in ceramics. The -flux was calculated from the concentrations of uranium and thorium and their daughter nuclides. The calculated values of -flux agreed with that of -flux measured.     

De novo design, synthesis, and function of semiartificial myoglobin conjugated with coiled-coil two-alpha-helix peptides

The introduction of a flavin chromophore on the myoglobin (Mb) surface and an effective electron-transfer (ET) reaction through the flavin were successfully achieved by utilizing the self-assembly of heterostranded coiled-coil peptides. We have prepared a semiartificial Mb, named Mb-1alphaK, in which an amphiphilic and cationic alpha-helix peptide is conjugated at the heme propionate (Heme-1alphaK). Heme-1alphaK has a covalently bound iron-protoporphyrin IX (heme) at the N terminus of a 1alphaK peptide sequence. This sequence was designed to form a heterostranded coiled-coil in the presence of a counterpart amphiphilic and anionic 1alphaE peptide sequence in a parallel orientation. Two peptides, Fla(1)-1alphaE and Fla(31)-1alphaE, both incorporating a 10-methylisoalloxazine moiety as an artificial flavin molecule, were also prepared (Fla=2-[7-(10-methyl)isoalloxazinyl]-2-oxoethyl). Heme-1alphaK was successfully inserted into apomyoglobin to give Mb-1alphaK. Mb-1alphaK recognized the flavin-modified peptides and a two-alpha-helix structure was formed. In addition, an efficient ET from reduced nicotinamide adenine dinucleotide to the heme center through the flavin unit was observed. The ET rate was faster in the presence of Fla(1)-1alphaE than in the presence of Fla(31)-1alphaE or the equivalent molecule that has no peptide chain. These results demonstrate that the introduction of a functional chromophore on the Mb surface can be achieved by using specific peptide-peptide interactions. Moreover, the dependence of the ET rate on the position of the flavin indicated that the distance between the heme active site and the flavin chromophore was regulated by the three-dimensional structure of the designed polypeptide.     

Substoichiometric precipitation of fluoride with lanthanum

The substoichiometric precipitation of fluoride with lanthanum was studied by using¹⁸F and¹⁴⁰La tracers and it was found that fluoride could be precipitated substoichiometrically with lanthanum and the reaction ratio between fluoride and lanthanum was 3∶1. The pH range at which fluoride can be separated substoichiometrically with lanthanum is between 2 and 8. Barium and indium interfere in the precipitation of fluoride, sodium, copper and manganese, however, not. Fluorosilicate can also be precipitated substoichiometrically by using lanthanum as a precipitant and the reaction ratio between fluorosilicate and lanthanum was 1∶2. This separation was applied for the determination of oxygen in silicon crystals. The concentration of oxygen measured in some silicon crystals was between 5 and 27 ppm and in good agreement with those by non-destructive method and infrared spectrophotometry.     

Tetraalkylammonium Picrates in the Dichloromethane–Water System: Ion-Pair Formation and Liquid–Liquid Distribution of Free Ions and Ion Pairs

Equilibria concerning picrates of tetraalkylammonium ions (Me₄N⁺, Et₄N⁺, Pr₄N⁺, Bu₄N⁺, Bu₃MeN⁺) in a dichloromethane−water system have been investigated at 25 ^∘C. The 1:1 ion-pair formation constants (K _IP,o ^o) in dichloromethane at infinite dilution were conductometrically determined. The distribution constants (K _D ^o) of the ion pairs and the free cations between the solvents were determined by a batch-extraction method. The K _IP,o ^o value varies in the cation sequence, Bu₄N⁺ ≈ Pr₄N⁺ ≈ Et₄N⁺ < Bu₃MeN⁺ < < Me₄N⁺; this trend is explained by the electrostatic cation−anion interaction taking into account the structures of the ion pairs determined by density functional theory calculations. For the ion pairs of the symmetric R₄N⁺ cations, there is a linear positive relationship between log₁₀ K _D ^o and the number of methylene groups in the cation (N _{CH 2}). The ion pair of asymmetric Bu₃MeN⁺ has a higher distribution constant than that expected from the above log₁₀ K _D ^o versus N _{CH 2} relationship. These cation dependencies of log₁₀ K _D ^o for the ion pairs are explained theoretically by using the Hildebrand-Scatchard equation. For all the cations, the log₁₀ K _D ^o value of the free cation increases linearly with N _{CH 2}; the variation of log₁₀ K _D ^o is discussed by decomposing the distribution constant into the Born-type electrostatic contribution and the non-Born one, and attributed to the latter that is governed by the differences in the molar volumes of the cations. The cation dependencies of the ion-pair extractability and ion pairing in water are also discussed. An erratum to this article can be found at     

Intramolecular catalytic Friedel-Crafts reactions with allenyl cations for the synthesis of quinolines and their analogues

[reaction: see text] This paper describes a novel method to synthesize a quinoline backbone by incorporating allenyl cations into a catalytic intramolecular Friedel-Crafts reaction. The initial products were isomerized and aromatized upon treatment with acid and base, respectively, to give quinolines. The basic concept also proved to be promising for 1-benzazepine, 1-benzazocine, or isoquinoline synthesis.     

DTA study of the chlorination of fly ash and bauxite in the presence of carbon

The chlorination processes of fly ash and bauxite in the presence of carbon were studied by means of a gas-flow type DTA, X-ray analysis and SEM observation, and the reactivity of Al-compounds as their constituents was compared. In the case of fly ash, the exothermic peak due to the formation of AlCl₃ (mainly) and FeCl₃ appeared at about 790–920°C. The reactivity of Al estimated from the DTA peak temperature depended on the particle size, carbon content and preparation temperature of fly ash, and was much lower than that of bauxite. Fractional conversion of Al was about 60–70%, when fly ash (?300 mesh) was heated up to 900°C in Cl₂ at 5°C min^?1 of heating rate. In the case of bauxite, two exothermic peaks due to the chlorination of Fe and Al appeared at about 270 and 490°C, respectively. The chlorination of Al was completed at 550°C under the above conditions.