Characterisation of aerosol particles using combined thermoanalytical techniques

Four different artificial aerosol particles as well as one standard environmental aerosol particle (NIST SRM 1649a) were investigated. While the mass loss of the aerosol particles varies from 1.5 to 32% of the entire mass, only a small part of each volatile fraction consists of organic compounds. Due to the construction of the combined thermoanalytical system, only a small part of the evolved gases is used for the mass spectrometric investigation. This results in a restricted sensitivity which does not allow an identification of individual organic components. Additional investigations like thermal desorption GC-MS reveal up to 1600 individual components (SRM 1649a). This revised version was published online in July 2006 with corrections to the Cover Date.     

Effects of poly(ethylene glycol) on the morphology and properties of biocomposites based on polylactide and cellulose nanofibers

Polylactide (PLA)/cellulose nanofiber (CNF) biocomposites were prepared via solution casting and direct melt mixing. To improve the compatibility, a masterbatch of CNFs and poly(ethylene glycol) (PEG) (1:2) was also prepared. The effects of PEG on the morphology and properties of the biocomposites were investigated. The dispersion/distribution of nanofibers in PLA was improved when the masterbatch was used and the composites were prepared in solution. Substantial effects on the rheological properties of solution-prepared PLA/CNF/PEG composites were observed compared to composites containing no PEG, whereas for melt-prepared composites no significant changes were detected. Increased crystalline content and crystallization temperature were observed for the composites prepared via the masterbatch and solvent casting. The storage modulus of PLA was increased by 42 and 553% at 25 and at 80 °C, respectively, for the solution-based PEG-compatibilized composite containing 2 wt% nanofibers. Also, a better light transmittance was measured for the PLA/CNF/PEG composites prepared in solution.     

SiC粒子非均布引起铝基复合材料的损伤分析

 根据电镜断面考察结果，以Gurson模型为本构方程的有限单元 法对包体模型及三维非均匀模型进行了详细分析. 为了评价应力-应变 关系及损伤的主要因素，考虑了基体中SiC粒子的体积率和径比的非均 匀分布. 其结果表明，用这种非均匀模型能很好地仿真铝基体在大量塑 性变形之后所发生的韧窝破坏过程. SiC粒子体积率、径比及其位置的 非均匀性，对局部和整体损伤过程与应力-应变关系的影响相当大. 当 Sic粒子径比为1.0，并在基体中均匀分布时，断裂应变会大幅度增大.     

Chemical constituents of Jordanian propolis

Seventeen compounds, including a new lanostane triterpenoid, 24(Z)-1β-3β-dihydroxyeupha-7,24-dien-26-oic acid, have been isolated from the methanolic extracts of two samples of Jordanian propolis collected from two different places with different dominant flora. The structures of the isolated compounds were elucidated by spectral methods including IR, UV, MS and 1- and 2-D NMR.     

A simple chemical model for clathrate hydrate inhibition by polyvinylcaprolactam

A dimeric model compound gives structural insight into the mode of interaction of low dosage hydrate inhibitors with water.