In Situ Amperometric Detection of Vesicles and Microgel Phases in an Aggregating System: Calcium Alginate

In situ amperometric characterization of an aggregating system in terms of molecular adsorption and single microparticle interactions at the electrode interface is demonstrated using a model system: alginate/Ca(II) in an aqueous electrolyte solution. Recording of chronoamperometric curves of oxygen reduction at the dropping mercury electrode is designed for detection of dip‐shaped signals of individual gel microparticles. By addition of Ca(II) decrease of alginate adsorption is accompanied by appearance of signals indicating vesicle type association of alginate molecules and microparticles of gel phase. AFM imaging provided evidence of initial stage in calcium alginate gel formation.     

Investigation of the Flavonoids in Croatian Propolis by Thin-Layer Chromatography

JPC – Journal of Planar Chromatography – Modern TLC - Flavonoids and phenolic acids with a variety of biological activity are considered to be the main compounds in propolis–a...     

Comparison of quantitative methods for analysis of polyphasic pharmaceuticals

Adequate very sensitive quantification methods are needed for the development and are also now required for the monitoring of undesirable solid form(s) as routine tests. The pre-requisite for quantitation are selectivity, sensitivity and most important the purity of standards and their proper storage, what is a challenge for metastable forms. Several analytical techniques are available such as X-ray diffraction, spectroscopy, thermal analysis and microcalorimetry. The different steps of the validation of the analytical methods and problems to be solved are discussed. Examples illustrate the different techniques and compare their possible advantages and limits. The relative standard deviation of measurements should allow for checking the homogenization procedure of mixtures for calibration. The validation should be carried out following ICH guidelines for validation of analytical methods. Comparison of different techniques in adequate concentration range add confidence in the analytical results.     

Temperature influence on hydrogen sorption in palladium limited-volume electrodes (Pd-LVE)

The effect of temperature on hydrogen and deuterium electrosorption into a palladium LVE (limited-volume electrode) has been investigated. A decrease in hydrogen capacity (H/Pd ratio) with increasing temperature has been observed. Temperature strongly influences the plots of measured H(D)/Pd values vs. potential scan rate. In addition, hydrogen absorption was found to be dependent on the composition of the surrounding electrolyte solution. These results have confirmed the hypothesis that two different mechanisms of hydrogen desorption from the palladium electrode take place, namely electrochemical oxidation and non-electrochemical recombination. Further, the ratio between the rate constants for these two processes has been found to change with temperature. Electronic Publication     

Kinetics of thermal decomposition of alkaline phosphates

Summary The thermal behavior of KH₂PO₄, NaH₂PO₄ and Na₂HPO₄ under non-isothermal conditions using TG method with different heating rates was studied. The values of the reaction rate were processed by means of Friedmans differential-isoconversional method. A dependence of the activation energy vs. conversion was observed. Therefore a procedure based on the compensation effect (suggested by Budrugeac and Segal) was applied. A less speculative data processing protocol was offered by the non-parametric kinetics method suggested by Serra, Nomen and Sempere. Three steps were observed by non-isothermal heating: a dehydration, a dimerization and a polycondensation. The differences in the intimate reaction mechanism are determined by the initial number of water molecules.     

Interaction of gas phase atomic hydrogen with Pt(111):Direct evidence for the formation of bulk hydrogen species

Employing hot tungsten filament to thermal dissociate molecular hydrogen,we generated gas phase atomic hydrogen under ultra-high vacuum(UHV)conditions and investigated its interaction with Pt(111) surface.Thermal desorption spectroscopy(TDS)results demonstrate that adsorption of molecular hy- drogen on Pt(111)forms surface Had species whereas adsorption of atomic hydrogen forms not only surface Had species but also bulk Had species.Bulk Had species is more thermal-unstable than surface Had species on Pt(111),suggesting that bulk Had species is more energetic.This kind of weakly- adsorbed bulk Had species might be the active hydrogen species in the Pt-catalyzed hydrogenation reactions.     

Statistical investigations of some element distributions in healthy and pathologically altered human colon mucosa

In this paper data are presented concerning the distribution of Cr, Sb, Sc, Fe, Co, and Zn in HCM, of patients with histopathologically and clinically verified findings: Healthy—N; Colitis Chronica-CCh; Colitis Ulcerosa-CU; Adenoma Tubulare-AT; Adenocarcinoma-ACa. The data are presented on the basis of the contents of elements (C_E parameter expressed in nkg/g of lyophilized HCM) obtained by INAA and calculated by computer programs, with statistical parameters (n, XBAR, XMIN-XMAX, R, V, SE and SDEV). The values of C_E parameters of elements found in all diagnostic groups (decreasing order) are also presented. The minimal \(\bar C_E \) parameters for all elements except Zn are found in diagnostic groups AT and ACa. The maximal differences of \(\bar C_E \) parameters in DS-decreasing orders are found for Sb (78.89%) and the minimal for Zn (18.89%).     

An Easy One-Pot Procedure for the Synthesis of <Emphasis Type="Italic">N</Emphasis>-Sulfonyl Phosphorous Ylides and Sulfonyl Iminophosphoranes

Summary. Reaction of triphenylphosphine and an electron deficient acetylenic ester in the presence of strong N–H acid such as alkyl and aryl sulfamides or acetamide produces phosphorous ylides at room temperature in CH₂Cl₂. The aryl sulfamide phosphoranes undergo a smooth transformation reaction in boiling toluene and produce iminophosphoranes.     

Algebraic Kekulé structures of benzenoid hydrocarbons

An algebraic Kekulé structure of a benzenoid hydrocarbon is obtained from an ordinary Kekulé structure by inscribing into each hexagon the number of pi-electrons which (according to this Kekulé structure) belong to this hexagon. We show that in the case of catafusenes, there is a one-to-one correspondence between ordinary and algebraic Kekulé structures. On the other hand, in the case of perifusenes, one algebraic Kekulé structure may correspond to several ordinary Kekulé structures.