BEPCⅡ Control System

The BEPCⅡ project is for upgrading the Beijing Electron Positron Collider to reach a higher luminosity.BEPCⅡ is designed as micro-β plus multi-bunches with double rings and has adopted cryogenic superconducting technology. The BEPCⅡ control system is a distributed system based on EPICS. In the past few years, we went through the design stage, R&D stage, development stage and the system will be installated. The BEPCⅡ machine commissioning with beam will start in October 2006. This paper describes the BEPCⅡ~control system and the progress of its development.     

凸二次交叉规划的等价形式

利用参数规划逆问题考虑凸二次交叉规划与多目标规划的关系 ,把交叉规划转变为同变量规划组 ,再把同变量规划组变为多目标规划 ,证明了凸二次交叉规划的均衡解与多目标规划的最优解的关系。     

Effect of nitrogen surface doping on the work function and field emission of hydrogenated amorphous carbon films

The effect of nitrogen surface doping on the electron field emission characteristics of hydrogenated amorphous carbon films was studied. It was found that the emission threshold electric field decreased after nitrogen surface doping which indicated the reduction of the emission barrier at the film surface. It was demonstrated that this improvement arose from the decrease of the effective work function due to the formation of a dipole layer induced by chemical termination and chemical structural change on the film surface. PACS 52.75.Xx; 73.30 +y; 73.61.Jc     

Theoretical calculations of spin-Hamiltonian parameters and defect structures for Cu2+ in trigonally-distorted tetrahedral sites of ZnO and GaN crystals

The spin-Hamiltonian (SH) parameters (g factors g _//, g ⊥ and hyperfine structure constants ⁶³ A _//, ⁶³ A ⊥, ⁶⁵ A _//, ⁶⁵ A ⊥) for Cu²⁺ ions in the trigonally-distorted tetrahedral sites of ZnO and GaN crystals are calculated from a complete diagonalization (of energy matrix) method (CDM) based on a two spin-orbit parameter model for d ⁹ ions in trigonal symmetry. In the method, the Zeeman and hyperfine interaction terms are added to the Hamiltonian in the conventional CDM. The calculated results are in good agreement with the experimental values. The calculated SH parameters are also compared with those using the traditional diagonalization method or perturbation method only within the ² T ₂ term. It appears that, for exact calculations of SH parameters of d ⁹ ions in trigonal tetrahedral clusters in crystals, the present CDM is preferable to the traditional diagonalization method or perturbation method within the ² T ₂ term. The local structures of Cu²⁺ centers (which differ from the corresponding structure in the host crystal) in ZnO : Cu²⁺ and GaN : Cu²⁺ are obtained from the calculations. The results are discussed.     

高温超导约瑟夫森结太赫兹混频系统

在小型脉冲管制冷机（工作温度约60 K）上搭建了高温超导约瑟夫森结太赫兹谐波混频系统,并采取了一系列措施增强结与太赫兹波的耦合。所采取的措施主要有：研究不同基片对结的影响并最终选择MgO做为双晶结基片,设计平面周期对数天线,同时使用一个超半球硅透镜和两个离轴抛物面反射镜组成准光学系统。最终成功在小型脉冲管制冷机中获得结对623 GHz太赫兹波的响应,并且成功进行24次谐波混频实验。     

由介质球构成的三维光子晶体能带结构的平面波研究

采用平面波展开方法计算由介质球构成的面心立方三维光子晶体的能带结构及透射性质.选 用合适的平面波个数研究了SiO₂蛋白石结构光子晶体的能带及透射性质，并采 用转移矩阵 方法计算了电磁波沿［111］方向的传输特性，两种方法得到的结果相符合.还研究了反蛋白 石结构光子晶体的全带隙.最后，研究了壳层介质球构成的面心立方结构光子晶体的能带特 性，发现在高介质球外面包裹适当厚度的低介电常数介质壳层所构成的光子晶体，可以增大 L点相对带隙宽度50％，并证明了其优化内外半径比值约为0．69. 关键词： 光子晶体 光子能带 平面波展开方法 Core-Shell结构     

谐振式集成光学陀螺解调特性分析

基于激光器频率谱检测技术,沿着光的传输方向分析了光波在谐振式集成光学陀螺系统中的传播,结合输入信号特征,建立频域内的数学模型,通过数值仿真和实验得到了调频检测系统下的解调曲线。按照光的传输方向：激光器、声光晶体移频器、光波导环形谐振器、探测器,利用贝塞尔函数展开和光场耦合模理论分析了谐振式集成光学陀螺解调特性,及其调频调制检测系统解调输出信号与谐振频率偏差之间的关系。通过数值计算,分析了解调曲线的变化规律,得到了施加在激光器压电陶瓷驱动器上调制波形的最佳调制系数。在实验上搭建了激光器频率调制解调技术系统,得到了解调曲线。数值仿真和实验结果表明,当调制系数M=2时,线性工作区间斜率最大,解调曲线最好。实测形状与理论分析结果相符,从解调信号得到±2×10³ rad/s的陀螺动态范围。     

常压DBD二维流体模型的FCT方法数值模拟

根据常压介质阻挡放电流体模型的物理方程,采用固定网格有限差分算法,分别用四阶和六阶相位误差FCT方法模拟求解二维流体连续方程.在均匀的初始条件下研究放电雪崩过程中电子密度的时空演化,具体分析和比较两种算法的差异.FCT方法模拟求解得出的计算结果与气体放电理论吻合较好,是一种具有较好的准确性和高精度的算法.     

Continuous tuning of cadmium sulfide and zinc sulfide nanoparticle size in a water-in-supercritical carbon dioxide microemulsion

The size and size dispersion of cadmium sulfide and zinc sulfide semiconductor nanoparticles can be continuously tuned over a wide range of values by adjusting the density of the fluid phase in water-in-supercritical CO2 microemulsions. The average size of the ZnS nanoparticles decreases linearly from approximately 9.1 to 1.9 nm with increasing fluid density from 0.86 to 0.99 g cm(-3) at a water-to-surfactant ratio (W value) of 10. At a W value of 6, the particle size can be tuned from 7.0 to 1.5 nm in the same density range. In the case of CdS nanocrystals, the size varied from 7.1 to 2.0 nm when the W value was 10 and from 4.0 to 1.3 nm when the W value employed was 6, in the same density range. Monodispersive CdS and ZnS nanoparticles were synthesized by chemical reaction of cadmium or zinc nitrate with sodium sulfide, using two water-in-supercritical CO2 microemulsions as nanoreactors followed by protection with a fluorinated-thiol stabilizer. The stabilizer is introduced at 6 and 16 minutes after the mixing of the two microemulsions where the intensity of the characteristic absorption peak due to the quantum confinement properties of the CdS and ZnS nanoparticles (280 and 360 nm) reaches a maximum, respectively. The supercritical CO2 microemulsion method represents a simple approach to use a density-tunable solvent for synthesizing size-controlled semiconductor nanoparticles over a broad range of values.     

裂纹转子振动特性分析

以具有刚性支承的水平Jefcott裂纹转子为研究对象,考虑涡动的影响,建立了裂纹转轴在固定坐标系中的刚度矩阵,推导了裂纹转子振动的运动方程,并通过数值方法分析了其动态特性。数值分析表明：裂纹转子振动响应中出现1X、2X、3X……分量,且当Ω=1/2,1/3…时,2X,3X…分量分别达到最大值;转子的中心轨迹形状随Ω变化而变化,当β=0-π逐渐增大时,响应中1X分量显著减小。考虑弯扭耦合振动时,振动响应中出现一些新的频率成分。同步激励的情况下,当ω＝ωN／n(n=2,3,4,…）时,扭转振动响应中nX分量也达到最大值。