Validation of a confirmatory method for lipophilic marine toxins in shellfish using UHPLC-HR-Orbitrap MS

Lipophilic marine toxins are produced by harmful microalgae and can accumulate in edible filter feeders such as shellfish, leading to an introduction of toxins into the human food chain, causing different poisoning effects. During the last years, analytical methods, based on liquid chromatography coupled to tandem mass spectrometry (LC-MS/MS), have been consolidated by interlaboratory validations. However, the main drawback of LC-MS/MS methods remains the limited number of compounds that can be analyzed in a single run. Due to the targeted nature of these methods, only known toxins, previously considered during method optimization, will be detected. Therefore in this study, a method based on ultra-high-performance liquid chromatography coupled to high-resolution Orbitrap mass spectrometry (UHPLC-HR-Orbitrap MS) was developed. Its quantitative performance was evaluated for confirmatory analysis of regulated lipophilic marine toxins in shellfish flesh according to Commission Decision 2002/657/EC. Okadaic acid (OA), dinophysistoxin-1 (DTX-1), pectenotoxin-2 (PTX-2), azaspiracid-1 (AZA-1), yessotoxin (YTX), and 13-desmethyl spirolide C (SPX-1) were quantified using matrix-matched calibration curves (MMS). For all compounds, the reproducibility ranged from 2.9 to 4.9 %, repeatability from 2.9 to 4.9 %, and recoveries from 82.9 to 113 % at the three different spiked levels. In addition, confirmatory identification of the compounds was effectively performed by the presence of a second diagnostic ion (¹³C). In conclusion, UHPLC-HR-Orbitrap MS permitted more accurate and faster detection of the target toxins than previously described LC-MS/MS methods. Furthermore, HRMS allows to retrospectively screen for many analogues and metabolites using its full-scan capabilities but also untargeted screening through the use of metabolomics software. Figure

?     

Selective Extraction of Metal Ions from Aqueous Phase to Ionic Liquids: A Novel Thermodynamic Approach to Separations

The selective extraction of metals from aqueous mixtures has generally relied on the use of selective ionophores. We present an alternative strategy that exploits a recently developed approach to extraction into an ionic liquid phase, and show that a high degree of control over selectivity can be obtained by tuning the relative concentrations of extraction agents. A thermodynamic model for the approach is presented, and an experimental separation of strontium and potassium ions is performed. It is shown that tuning the concentrations of the species involved can shift the ratio of potassium to strontium in the ionic liquid phase from 4:1 to 3:4. This extraction is performed under mild conditions with relatively common reagents. The result is a proof‐of‐concept for a novel separations scheme that could have great importance in a wide range of technological applications.     

The Effect of α-Branched Side Chains on the Structural and Opto-Electronic Properties of Poly(Diketopyrrolopyrrole-alt-Terthiophene)

Introducing solubilizing α-branched alkyl chains on a poly(diketopyrrolopyrrole-alt-terthiophene) results in a dramatic change of the structural, optical, and electronic properties compared to the isomeric polymer carrying β-branched alkyl side chains. When branched at the α-position the alkyl substituent creates a steric hindrance that reduces the tendency of the polymer to π–π stack and endows the material with a much higher solubility in common organic solvents. The wider π–π stacking and reduced tendency to crystallize, evidenced from grazing-incidence wide-angle X-ray scattering, result in a wider optical band gap in the solid state. In solar cells with a fullerene acceptor, the α-branched isomer affords a higher open-circuit voltage, but an overall lower power conversion efficiency as a result of a too well-mixed nanomorphology. Due its reduced π–π stacking, the α-branched isomer fluoresces and affords near-infrared light-emitting diodes emitting at 820 nm.     

Controlling the Microstructure of Conjugated Polymers in High‐Mobility Monolayer Transistors via the Dissolution Temperature

It remains a challenge to precisely tailor the morphology of polymer monolayers to control charge transport. Herein, the effect of the dissolution temperature (T_dis) is investigated as a powerful strategy for morphology control. Low T_dis values cause extended polymer aggregation in solution and induce larger nanofibrils in a monolayer network with more pronounced π–π stacking. The field‐effect mobility of the corresponding monolayer transistors is significantly enhanced by a factor of four compared to devices obtained from high T_dis with a value approaching 1 cm² V^?1 s^?1. Besides that, the solution kinetics reveal a higher growth rate of aggregates at low T_dis, and filtration experiments further confirm that the dependence of the fibril width in monolayers on T_dis is consistent with the aggregate size in solution. The generalizability of the T_dis effect on polymer aggregation is demonstrated using three other conjugated polymer systems. These results open new avenues for the precise control of polymer aggregation for high‐mobility monolayer transistors.     

Pressure drop effects on selectivity and resolution in packed column supercritical fluid chromatography

The influence of pressure drop on retention, selectivity, plate height and resolution was investigated systematically in packed supercritical fluid chromatography (SFC) using pure carbon dioxide as the mobile phase. Numerical methods developed previously which enabled the prediction of pressure gradients, diffusivities, capacity factors, plate heights and resolutions along the length of the column were used for the model calculations. The effects of inlet pressure and supercritical fluid flow rate on selectivity and resolution are studied. In packed column SFC with pure carbon dioxide as the mobile phase, the pressure drop can have a significant effect on resolution. The flow rate is shown to have a larger effect than generally realized. The calculated data are shown to be in good agreement with the experimental results. Finally, the variation of the chromatographic parameters along a 5.5 meter long model SFC column is illustrated. The possibilities and limitations of using long packed columns in SFC are discussed. It is demonstrated that long columns with large plate numbers do not necessarily yield better separations.     

Biased Diffusion with Correlated Noise

The diffusion of hard-core particles subject to a global bias is described by a nonlinear, anisotropic generalization of the diffusion equation with conserved, local noise. Using renormalization group techniques, we analyze the effect of an additional noise term, with spatially long-ranged correlations, on the long-time, long-wavelength behavior of this model. Above an upper critical dimension d _LR, the long-ranged noise is always relevant. In contrast, for d<d _LR, we find a weak noise regime dominated by short-range noise. As the range of the noise correlations increases, an intricate sequence of stability exchanges between different fixed points of the renormalization group occurs. Both smooth and discontinuous crossovers between the associated universality classes are observed, reflected in the scaling exponents. We discuss the necessary techniques in some detail since they are applicable to a much wider range of problems.     

PtII-Catalyzed Hydroxylation of Terminal Aliphatic C(sp3)−H Bonds with Molecular Oxygen

The practical application of Shilov-type Pt catalysis to the selective hydroxylation of terminal aliphatic C−H bonds remains a formidable challenge, due to difficulties in replacing Pt^IV with a more economically viable oxidant, particularly O₂. We report the potential of employing FeCl₂ as a suitable redox mediator to overcome the kinetic hurdles related to the direct use of O₂ in the Pt reoxidation. For the selective conversion of butyric acid to γ-hydroxybutyric acid (GHB), a significantly enhanced catalyst activity and stability (turnover numbers (TON)>30) were achieved under 20 bar O₂ in comparison to current state-of-the-art systems (TON<10). In this regard, essential reaction parameters affecting the overall activity were identified, along with specific additives to attain catalyst stability at longer reaction times. Notably, deactivation by reduction to Pt⁰ was prevented by the addition of monodentate pyridine derivatives, such as 2-fluoropyridine, but also by introducing varying partial pressures of N₂ in the gaseous atmosphere. Finally, stability tests revealed the involvement of Pt^II and FeCl₂ in catalyzing the non-selective overoxidation of GHB. Accordingly, in situ esterification with boric acid proved to be a suitable strategy to maintain enhanced selectivities at much higher conversions (TON>60). Altogether, a useful catalytic system for the selective hydroxylation of primary aliphatic C−H bonds with O₂ is presented.     

Integral Representation of Invariant Functions

We characterize those positive functions which are invariant for a bounded kernel, and which have a Choquet-type integral representation. Such a representation relies on the wellknown Choquet-type integral representation of measures which are invariant for a kernel. We apply our results to convolution kernels with spread-out measures on second countable locally compact Abelian groups.