Complexation of Al(III) by 8-Hydroxyquinoline and Drastic Fluorescence Enhancement in Reverse Micelles

Complexation of Al^IIIby 8-hydroxyquinoline and fluorescence behavior of the quinolinate(s) were studied in reverse micellar systems at low water content, and compared to aqueous media. Two surfactants were used: one was cationic (CTAC: cetyltrimethylammonium chloride) and the other was anionic (AOT: sodium bis(2-ethylhexyl)sulfosuccinate). The results obtained in the CTAC/dichloromethane system (W= [H₂O]/[surfactant] = 0.9) showed that complexation occurred very likely in the oil phase and no micellar effect was observed. On the contrary, in the presence of AOT, specific micellar effects were observed due to the presence of the anionic polar heads: stabilization of the positively charged 1:1 and 1:2 chelates, at the expense of the neutral water-insoluble 1:3 chelate which is formed in aqueous solutions under similar conditions;drastic fluorescence enhancement factorsof 120 and 100 in AOT/heptane (W= 1.5) and AOT/dichloromethane (W= 1.6), respectively. Such factors have never been reported so far in either hydroorganic or direct micellar systems. In return, the length of time for the production of the complex(es) is increased because of the microheterogeneity of the medium and the small sizes of the water pools.     

Synthesis,Crystal Structure Determination from X‐Ray Powder Diffractometry and Vibrational Spectroscopic Properties of Mg[N(CN)2]2 · 4 H2O

Magnesium dicyanamide tetrahydrate Mg[N(CN)₂]₂ · 4 H₂O was synthesized by aqueous ion exchange starting from Na[N(CN)₂] and Mg(NO₃)₂ · 6 H₂O. The crystal structure was solved and refined on the basis of powder X‐ray diffraction data (P2₁/c, Z = 2, a = 737.50(2), b = 732.17(1), c = 971.67(2) pm, β = 98.074(1)°, wR_p = 0.059, R_p = 0.046, R_F = 0.075). In the crystal there are neutral complexes [Mg[N(CN)₂]₂(H₂O)₄] which are only connected via hydrogen bonds. Above 40 °C the tetrahydrate decomposes into anhydrous Mg[N(CN)₂]₂.     

Ultra-trace analysis of platinum in human tissue samples

Background levels of platinum were determined in human autopsy tissues taken from five individuals. The investigated specimens were lung, liver and kidney. Sample preparation involved microwave digestion followed by an open vessel treatment. Inductively-coupled plasma sector field mass spectrometry (ICP-SFMS) was applied in combination with an ultrasonic nebulization/membrane desolvation system for sample introduction. Isotope dilution analysis was employed for accurate quantification of platinum. Excellent procedural detection limits (3 s validation) of 20, 20 and 34 pg g^–1 dry weight were obtained for lung, liver and kidney tissue, respectively. Due to the lack of appropriate biological reference material, road dust (BCR-723) was used for method validation. Platinum levels ranging between 0.03 and 1.42 ng g^–1 were determined in the investigated samples. The platinum concentrations observed in human lung tissue may reflect the increasing atmospheric background levels of platinum originating from car catalysts. The presence of platinum in kidney and liver tissue samples clearly indicates the bioavailability of the element.     

Layer by layer buildup of polysaccharide films: physical chemistry and cellular adhesion aspects

The formation ofpolysaccharide films based on the alternate deposition of chitosan (CHI) and hyaluronan (HA) was investigated by several techniques. The multilayer buildup takes place in two stages: during the first stage, the surface is covered by isolated islets that grow and coalesce as the construction goes on. After several deposition steps, a continuous film is formed and the second stage of the buildup process takes place. The whole process is characterized by an exponential increase of the mass and thickness of the film with the number of deposition steps. This exponential growth mechanism is related to the ability of the polycation to diffuse "in" and "out" of the whole film at each deposition step. Using confocal laser microscopy and fluorescently labeled CHI, we show that such a diffusion behavior, already observed with poly(L-lysine) as a polycation, is also found with CHI, a polycation presenting a large persistence length. We also analyze the effect of the molecular weight (MW) of the diffusing polyelectrolyte (CHI) on the buildup process and observe a faster growth for low MW chitosan. The influence of the salt concentration during buildup is also investigated. Whereas the CHI/HA films grow rapidly at high salt concentration (0.15 M NaCl) with the formation of a uniform film after only a few deposition steps, it is very difficult to build the film at 10(-4) M NaCl. In this latter case, the deposited mass increases linearly with the number of deposition steps and the first deposition stage, where the surface is covered by islets, lasts at least up to 50 bilayer deposition steps. However, even at these low salt concentrations and in the islet configuration, CHI chains seem to diffuse in and out of the CHI/HA complexes. The linear mass increase of the film with the number of deposition steps despite the CHI diffusion is explained by a partial redissolution of the CHI/HA complexes forming the film during different steps of the buildup process. Finally, the uniform films built at high salt concentrations were also found to be chondrocyte resistant and, more interestingly, bacterial resistant. Therefore, the (CHI/HA) films may be used as an antimicrobial coating.     

Measuring the electrophoretic mobility of concentrated suspensions in nonaqueous media

We present a new method of measuring the electrophoretic mobility of a particle in a concentrated suspension. The method is used to measure the electrophoretic mobility of PMMA particles (diameter 10 microm) suspended in a mixture of liquid hydrocarbons. The particle volume fraction of the suspension is varied from 0 up to 0.30 and the resulting variation of the electrophoretic mobility is discussed. The suspending liquid is such that its refractive index is very close to that of the particles. Thus the suspension is almost transparent and it is possible to follow through a microscope the motion of one particle. The suspension is subjected to a low-frequency electric field (0.5 Hz). The cell containing the suspension is mounted on a piezoelectric crystal. The displacement that compensates for the particle motion (when the particle image is steady) is determined.     

Hybrid fluorocarbon-hydrocarbon CO2-philic surfactants. 2. formation and properties of water-in-CO2 microemulsions

Hybrid fluorocarbon-hydrocarbon (F-H) sulfate surfactants are shown to be efficient stabilizers in water-in-CO2 (w/c) microemulsions. The chain structure and F-H ratio affect the regions of P-T phase stability and aggregation structure in these w/c phases. High-pressure near-infrared spectroscopy and small-angle neutron scattering measurements of microemulsified water provide evidence for the stabilization of w/c microemulsion droplets. The relative lengths of the two chains were found to influence the favored aggregation structure: for symmetric chain surfactants (F8H8, F7H7) spherical reverse micelles are present, but for asymmetric chain surfactants (F7H4, F8H4) extended cylinder aggregates form. These changes in aggregation are consistent with different surfactant packing parameters owing to the controlled variations in molecular structure. Furthermore, the general order of w/c phase transition pressures (F8H8 < F7H7 and F8H4 < F7H4) is in line with estimations of surfactant fractional free volume, as proposed by Johnston et al. (J. Phys. Chem. B 2004, 108, 1962-1966). Studies of adsorption at the poly(dimethylsiloxane)-water interface are shown to be valuable for assessing the CO2-philicity of new surfactants. All in all, the symmetric F8H8 and F7H7 analogues are seen to be the most efficient compounds from this class for applications in CO2.