Reply to “nonequivalence of ether theories and special relativity. comment on recent interpretation of Lorentz' Ether theory”

The role played by coordinates in the formulation of an absolute spacetime theory is assessed. It is shown that recent criticism on previous work of ours is wrong.     

Determination of volatile corrosion inhibitors by capillary electrophoresis

In this work, a capillary electrophoresis (CE) method using indirect UV detection (214nm) for the simultaneous determination of monoethanolamine (MEA), diethanolamine (DEA), triethanolamine (TEA), diethylethanolamine (DEEA), monocyclohexylamine (MCHA) and dicyclohexylamine (DCHA) in water/ethanol extracts of wrapping materials containing volatile corrosion inhibitors (VCIs) was described. A running buffer consisting of 0.010 molL(-1) imidazole, 0.010 molL(-1) 2-hydroxyisobutyric acid (HIBA) and 0.010 molL(-1) 18-crown-6 ether enabled separation of the analytes in less than 7 min. A few method validation parameters were determined revealing good migration time repeatability (<0.7% RSD) and area repeatability (< 1.8% RSD). Limits of detection were in the range of 0.52-1.54 mg L(-1). Recovery values were in the range of 94.8-100.9%. The methodology was successfully applied to the analysis of three commercial products (VCI treated paper, foam and plastic). The concentration of amines in these materials varied from 0.050 to 22.3% (w/w).     

Influence of the tannin structure on the disruption effect of carbohydrates on protein-tannin aggregates

The disrupting effect of three different ionic carbohydrates (xanthan, pectin and gum arabic) on the formation of tannin-protein insoluble aggregates was assessed by nephelometry using bovine serum albumin (BSA) and several procyanidin fractions previously extracted from grape seeds. The presence in solution of any of the carbohydrates studied was found to restrain the formation of insoluble protein-tannin aggregates for every procyanidin fraction used. Xanthan was the most effective carbohydrate, whereas gum arabic was the least effective. The present work has revealed that the disrupting effect of carbohydrates is quite different depending on the procyanidin structure complexity. In general, the three carbohydrates studied revealed a similar trend in that their disrupting effect on tannin-BSA aggregate formation decreased with increase of the procyanidin degree of polymerization.     

Methylation of Chitosan with Iodomethane: Effect of Reaction Conditions on Chemoselectivity and Degree of Substitution

N,N,N‐trimethylchitosan (TMC) was prepared by reacting purified chitosan with iodomethane, in the presence of sodium hydroxide, water and sodium iodide, at room temperature. The reaction medium was N‐methyl‐2‐pyrrolidone. Different samples of TMC were obtained by adding to the reaction medium a fixed volume (5.5 mL) of aqueous NaOH solutions at different concentrations (15, 20, 30 and 40 wt.‐%) and carrying out the reactions for 9 or 24 h. The features observed in the ¹H and ¹³C NMR spectra of these chitosan derivatives, in respect of the chemical shift, number and relative intensity of the signals, depended strongly on the excess of NaOH and H₃CI added to the reaction medium, but when the lowest excess was employed, the characteristics of the derivative were not affected by the reaction time to the same extent. The average degree of quaternization of these N‐methylated derivatives of chitosan ranged from 10.5% to 44.8%, according to the reaction conditions. Increasing the excess of NaOH, in reactions carried out for 9 h, resulted in TMC samples with progressively higher content of trimethylated sites however, the reaction yields were correspondingly lower and O‐alkylation was favored in these cases.

¹H NMR spectrum of sample [A_X]^24h dissolved in D₂O (C_p = 10 g/L).     

EPR and 1H and 13C dynamic nuclear polarization studies of a molecularly doped polymer: bisphenol A polycarbonate doped with trianisylamine and trianisylaminium perchlorate.

We have investigated the EPR and DNP behavior of a molecularly doped polymer modeling those used to transport electronic charge in electrophotography. The EPR spectra show no evidence of the superexchange reported for a closely related system based on tri-p-tolylamine. The difference may be due to larger charge-transfer matrix elements in the latter system. An unambiguous interpretation of the observed 1H DNP was rendered difficult by the unanticipated asymmetry of the EPR spectra. We report extensive data on the "three-spin" effect evident in the DNP-enhanced 13C NMR spectra, and comment on its potential for characterizing polymer interfaces.     

Enhancement of luminescence efficiency of f–f transitions from Tb due to energy transfer from Ce in Al2O3 crystalline ceramic powders prepared by low temperature direct combustion synthesis

In this Letter, we report the structural and luminescent properties of Tb:Ce:Al₂O₃ crystalline ceramic powders prepared through combustion synthesis at low temperature (280 °C). The presence of Ce³⁺ (1.0 mol%) in the sample resulted in an enhancement of Tb³⁺ (1.0 mol%) overall emission intensity by a factor of 50. The analysis of the luminescence dynamics for the ⁵D₄ → ⁷F₆ transition (545 nm) of Tb³⁺ demonstrated that the mechanism responsible for the large enhancement of luminescence observed is efficient energy transfer from Ce³⁺ to Tb³⁺.     

A higher resolution edge‐based finite volume method for the simulation of the oil–water displacement in heterogeneous and anisotropic porous media using a modified IMPES method

In this article, we present a higher‐order finite volume method with a ‘Modified Implicit Pressure Explicit Saturation’ (MIMPES) formulation to model the 2D incompressible and immiscible two‐phase flow of oil and water in heterogeneous and anisotropic porous media. We used a median‐dual vertex‐centered finite volume method with an edge‐based data structure to discretize both, the elliptic pressure and the hyperbolic saturation equations. In the classical IMPES approach, first, the pressure equation is solved implicitly from an initial saturation distribution; then, the velocity field is computed explicitly from the pressure field, and finally, the saturation equation is solved explicitly. This saturation field is then used to re‐compute the pressure field, and the process follows until the end of the simulation is reached. Because of the explicit solution of the saturation equation, severe time restrictions are imposed on the simulation. In order to circumvent this problem, an edge‐based implementation of the MIMPES method of Hurtado and co‐workers was developed. In the MIMPES approach, the pressure equation is solved, and the velocity field is computed less frequently than the saturation field, using the fact that, usually, the velocity field varies slowly throughout the simulation. The solution of the pressure equation is performed using a modification of Crumpton's two‐step approach, which was designed to handle material discontinuity properly. The saturation equation is solved explicitly using an edge‐based implementation of a modified second‐order monotonic upstream scheme for conservation laws type method. Some examples are presented in order to validate the proposed formulation. Our results match quite well with others found in literature. Copyright © 2016 John Wiley & Sons, Ltd.