Effect of time on the interfacial and foaming properties of beta-lactoglobulin/acacia gum electrostatic complexes and coacervates at pH 4.2

The electrostatic complexation between beta-lactoglobulin and acacia gum was investigated at pH 4.2 and 25 degrees C. The binding isotherm revealed a spontaneous exothermic reaction, leading to a DeltaHobs = -2108 kJ mol(-1) and a saturation protein to polysaccharide weight mixing ratio of 2:1. Soluble electrostatic complexes formed in these conditions were characterized by a hydrodynamic diameter of 119 +/- 0.6 nm and a polydispersity index of 0.097. The effect of time on the interfacial and foaming properties of these soluble complexes was investigated at a concentration of 0.1 wt % at two different times after mixing (4 min, referred as t approximately 0 h and t = 24 h). At t approximately 0 h, the mixture is mainly made of aggregating soluble electrostatic complexes, whereas after 24 h these complexes have already insolubilize to form liquid coacervates. The surface elasticity, viscosity and phase angle obtained at low frequency (0.01 Hz) using oscillating bubble tensiometry revealed higher fluidity and less rigidity in the film formed at t approximately 0 h. This observation was confirmed by diminishing bubble experiments coupled with microscopy of the thin film. It was thicker, more homogeneous and contained more water at t approximately 0 h as compared to t = 24 h (thinner film, less water). This led to very different gas permeability's of Kt approximately 0 h = 0.021 cm s(-1) and Kt=24 h) = 0.449 cm s(-1), respectively. Aqueous foams produced with the beta-lactoglobulin/acacia gum electrostatic complexes or coacervates exhibited very different stability. The former (t approximately 0 h) had a stable volume, combining low drainage rate and mainly air bubble disproportionation as the destabilization mechanism. By contrast, using coacervates aged for 24 h, the foam was significantly less stable, combining fast liquid drainage and air bubble destabilization though fast gas diffusion followed by film rupture and bubble coalescence. The strong effect of time on the air/water interfacial properties of the beta-lactoglobulin/acacia gum electrostatic complexes can be understood by their reorganization at the interface to form a coacervate phase that is more fluid/viscous at t approximately 0 h vs rigid/elastic at t = 24 h.     

Phase separation of p53 precedes aggregation and is affected by oncogenic mutations and ligands

Mutant p53 tends to form aggregates with amyloid properties, especially amyloid oligomers inside the nucleus, which are believed to cause oncogenic gain-of-function (GoF). The mechanism of the formation of the aggregates in the nucleus remains uncertain. The present study demonstrated that the DNA-binding domain of p53 (p53C) underwent phase separation (PS) on the pathway to aggregation under various conditions. p53C phase separated in the presence of the crowding agent polyethylene glycol (PEG). Similarly, mutant p53C (M237I and R249S) underwent PS; however, the process evolved to a solid-like phase transition faster than that in the case of wild-type p53C. The data obtained by microscopy of live cells indicated that transfection of mutant full-length p53 into the cells tended to result in PS and phase transition (PT) in the nuclear compartments, which are likely the cause of the GoF effects. Fluorescence recovery after photobleaching (FRAP) experiments revealed liquid characteristics of the condensates in the nucleus. Mutant p53 tended to undergo gel- and solid-like phase transitions in the nucleus and in nuclear bodies demonstrated by slow and incomplete recovery of fluorescence after photobleaching. Polyanions, such as heparin and RNA, were able to modulate PS and PT in vitro. Heparin apparently stabilized the condensates in a gel-like state, and RNA apparently induced a solid-like state of the protein even in the absence of PEG. Conditions that destabilize p53C into a molten globule conformation also produced liquid droplets in the absence of crowding. The disordered transactivation domain (TAD) modulated both phase separation and amyloid aggregation. In summary, our data provide mechanistic insight into the formation of p53 condensates and conditions that may result in the formation of aggregated structures, such as mutant amyloid oligomers, in cancer. The pathway of mutant p53 from liquid droplets to gel-like and solid-like (amyloid) species may be a suitable target for anticancer therapy.

Mutant p53 tends to form aggregates with amyloid properties, especially amyloid oligomers inside the nucleus, which are believed to cause oncogenic gain-of-function (GoF).     

Influence of structure and solubility of chain transfer agents on the RAFT control of dispersion polymerisation in scCO2

Reversible addition–fragmentation chain transfer (RAFT) dispersion polymerisation of methyl methacrylate (MMA) is performed in supercritical carbon dioxide (scCO₂) with 2-(dodecylthiocarbonothioylthio)-2-methylpropionic acid (DDMAT) present as chain transfer agent (CTA) and surprisingly shows good control over PMMA molecular weight. Kinetic studies of the polymerisation in scCO₂ also confirm these data. By contrast, only poor control of MMA polymerisation is obtained in toluene solution, as would be expected for this CTA which is better suited for acrylates. In this regard, we select a range of CTAs and use them to determine the parameters that must be considered for good control in dispersion polymerisation in scCO₂. A thorough investigation of the nucleation stage during the dispersion polymerisation reveals an unexpected “in situ two-stage” mechanism that strongly determines how the CTA works. Finally, using a novel computational solvation model, we identify a correlation between polymerisation control and degree of solubility of the CTAs. All of this ultimately gives rise to a simple, elegant and counterintuitive guideline to select the best CTA for RAFT dispersion polymerisation in scCO₂.

RAFT dispersion polymerisation of methyl methacrylate is performed in scCO₂ with 2-(dodecylthiocarbonothioylthio)-2-methylpropionic acid (DDMAT) present as chain transfer agent (CTA) and surprisingly shows good control over PMMA molecular weight.     

Synthesis of non-agglomerated Ba<Subscript>0.77</Subscript>Ca<Subscript>0.23</Subscript>TiO<Subscript>3</Subscript> nanopowders by a modified polymeric precursor method

In this work, we have studied the influence of the pH on the synthesis and structural properties of the Ba_0.77Ca_0.23TiO₃ nanopowders synthesized by a modified polymeric precursor method, in order to achieve non-agglomerated powders. Synthesis, morphology, thermal reactions, crystallite and average particle size of the synthesized powders were investigated through thermal analysis (DTA/TG), X-ray diffraction (XRD), field emission scanning electron microscope (FE-SEM) and Infrared spectroscopy. In summary, Ba_0.77Ca_0.23TiO₃ nanopowders were synthesized for the first time at a relative low temperature (500 °C). It was also found that the alkalinity and acidity of the solution presented a great influence on the powder properties. The best results were obtained from solutions with pH = 8.5 and 11 whose nanopowders presented weakly agglomerate, with homogeneous particle size and a narrow size distribution (30–40 nm). This behavior could be explained based on the FT-IR results in which it was possible to see the increased of the chelation in higher pHs.     

Protection against photoaging in the hairless mouse by the isoflavone equol

Topical application of the isoflavone equol immediately following solar-simulated UV (SSUV) radiation exposure has previously been demonstrated to have significant photoprotective effects. Equol reduced both the inflammatory edema and the systemic suppression of the contact hypersensitivity reaction in hairless mice. Furthermore, daily topical equol application immediately following irradiation during a 10-week chronic SSUV exposure regime also reduced photocarcinogenesis severity in the mouse. This study examines the potential for topical equol to prevent photoaging in response to chronic SSUV irradiation for up to 30 weeks. We did not find consistent expression of the characteristic markers of photoaging until 30 weeks, although moderate epidermal hyperplasia and a transient increase in dermal mast cell numbers were evident after 1 week. Daily application of 10 muM equol lotion significantly reduced these early changes. However after 30 weeks of SSUV exposure, photoaging was well developed, as shown histologically by markedly increased epidermal hyperplasia, increased dermal mast cell number, pronounced focal elastotic deposits, degraded dermal collagen and deposition of glycosaminoglycans in the lower dermis. Topical equol treatment protected significantly from each of these impairments, as demonstrated histologically and quantitatively. Additionally, equol was found to have strong antioxidant action against acute UVA (320-400 nm)-induced lipid peroxidation of mouse skin, this property accounting for its antiphotoaging mechanism. The evidence for equol's antiphotoaging activity, taken together with its anti-inflammatory, immunoprotective and anticarcinogenic efficacy against SSUV irradiation in the mouse, suggests that equol could be developed as a helpful topical photoprotective agent for daily use by humans.     

Transport properties of alkyltrimethylammonium bromide surfactants in aqueous solutions

Differential mutual diffusion coefficients of n-alkyltrimethylammonium bromides [CH₃(CH₂)_n–1N(CH₃)₃Br, C_nTAB] (n=10, 12, 14, 16) have been measured in aqueous solutions at 298.15 K using a conductimetric cell and an automatic apparatus to follow diffusion. The cell is based on an open-ended capillary, and the technique follows the diffusion process by measuring the resistance of a solution inside the capillaries at various times. The electrical conductances of those solutions have also been measured to calculate the critical micellar concentration (cmc). Thermodynamic analysis of the data suggests that the free ion concentration decreases at concentrations above the cmc, in agreement with theoretical predictions. The obtained values of the micellization parameters were used to model the mutual diffusion coefficients of C_nTAB aqueous solutions.     

Thermochemical studies of phthalimide and two N-alkylsubstituted phthalimides (ALKYL=ETHYL AND n-PROPYL)

The standard (p⁰=0.1 MPa) molar enthalpies of formation, Δ_fH_m⁰, for crystalline phthalimides: phthalimide, N-ethylphthalimide and N-propylphthalimide were derived from the standard molar enthalpies of combustion, in oxygen, at the temperature 298.15 K, measured by static bomb-combustion calorimetry, as, respectively, – (318.0±1.7), – (350.1±2.7) and – (377.3±2.2) kJ mol^–1. The standard molar enthalpies of sublimation, Δ_cr^gH_m⁰, at T=298.15 K were derived by the Clausius-Clapeyron equation, from the temperature dependence of the vapour pressures for phthalimide, as (106.9±1.2) kJ mol^–1 and from high temperature Calvet microcalorimetry for phthalimide, N-ethylphthalimide and N-propylphthalimide as, respectively, (106.3±1.3), (91.0±1.2) and (98.2±1.4) kJ mol^–1. The derived standard molar enthalpies of formation, in the gaseous state, are analysed in terms of enthalpic increments and interpreted in terms of molecular structure.     

Direct determination of gallium on polyurethane foam by X-ray fluorescence

Gallium chloride is easily extracted from 6M HCl by comminuted polyether-type polyurethane foam. After the extraction step, the gallium absorbed by the PU foam can be quantitatively determined by X-ray fluorescence. A procedure for the direct determination of gallium absorbed by PU foam by XRFS is thus described. Gallium is determined at levels as low as 60 ng/ml (C(L)), with a calibration sensitivity of 424 cps ml/mug, within a linear range 0.1-2.30 mug/ml. The procedure investigated was successfully applied to determination of gallium in aluminum alloys, bauxite and industrial residue samples.     

Chemometric interpretation of pesticide occurence in soil samples from an intensive horticulture area in north Portugal

An extensive monitoring programme of pesticides was carried out in soil samples from an intensive horticulture area in north of Portugal, putting into practice the needs for increased control of soil quality as far as organic pollution is concerned. The area under investigation was additionally defined as vulnerable to nitrates due to local soil and aquifer characteristics, which might be extended to pesticides contamination. Five sampling sites were selected and soils analysed at three depths in eight sampling campaigns, for the period of 2 years. A stepwise multivariate statistical approach was selected to uncover most relevant patterns inside a complex environmental data matrix. Cluster analysis was applied both to group pesticides and samples, giving a primary and unsupervised overlook of privileged relationships. Clusters of persistent pesticides and selected herbicides were identified, whereas sample classes were also formed and disposed geographically. Thirty eight percent of analysed soils samples fell into one class characterized by low contamination (class 1 in cluster analysis), which is entirely representative of the sampling site no. 1. Afterwards, linear discriminant analysis was applied to identify those pesticides, which had a higher impact in the definition of classes. Finally, factor analysis using a five component model was implemented in order to bring to light the constitution and data variance explained by each of the five main principal components, as well as, their relation to pest management practices. A factor was identified (PC1 – 22% variance) composed of chlorinated pesticides, which was representative of one of the investigated sites indicating its high contamination status. Qualitative main findings and class average concentration values were obtained through this multivariate statistical approach.