A new and reliable model for predicting methane viscosity at high pressures and high temperatures

In recent years, there has been an increase of interest in the flow of gases at relatively high pressures and high temperatures. Hydrodynamic calculation of the energy losses in the flow of gases in conduits, as well as through the porous media constituting natural petroleum reservoirs, requires knowledge of the viscosity of the fluid at the pressure and temperature involved. Although there are numerous publications concerning the viscosity of methane at atmospheric pressure, there appears to be little information available relating to the effect of pressure and temperature upon the viscosity. A survey of the literature reveals that the disagreements between published data on the viscosity of methane are common and that most investigations have been conducted over restricted temperature and pressure ranges. Experimental viscosity data for methane are presented for temperatures from 320 to 400 K and pressures from 3000 to 140000 kPa by using falling body viscometer. A summary is given to evaluate the available data for methane, and a comparison is presented for that data common to the experimental range reported in this paper. A new and reliable correlation for methane gas viscosity is presented. Predicted values are given for temperatures up to 400 K and pressures up to 140000 kPa with Average Absolute Percent Relative Error (EABS) of 0.794.     

Preparation and characterization of a composite PDMS membrane on CA support

Polydimethylsiloxane (PDMS) is the most commonly used membrane material for the separation of condensable vapors from lighter gases. In this study, a composite PDMS membrane was prepared and its gas permeation properties were investigated at various upstream pressures. A microporous cellulose acetate (CA) support was initially prepared and characterized. Then, PDMS solution, containing crosslinker and catalyst, was cast over the support. Sorption and permeation of C₃H₈, CO₂, CH₄, and H₂ in the prepared composite membrane were measured. Using sorption and permeation data of gases, diffusion coefficients were calculated based on solution‐diffusion mechanism. Similar to other rubbery membranes, the prepared PDMS membrane advantageously exhibited less resistance to permeation of heavier gases, such as C₃H₈, compared to the lighter ones, such as CO₂, CH₄, and H₂. This result was attributed to the very high solubility of larger gas molecules in the hydrocarbon‐based PDMS membrane in spite of their lower diffusion coefficients relative to smaller molecules. Increasing feed pressure increased permeability, solubility, and diffusion coefficients of the heavier gases while decreased those of the lighter ones. At constant temperature (25°C), empirical linear relations were proposed for permeability, solubility, and diffusion coefficients as a function of transmembrane pressure. C₃H₈/gas solubility, diffusivity, and overall selectivities were found to increase with increasing feed pressure. Ideal selectivity values of 9, 30, and 82 for C₃H₈ over CO₂, CH₄, and H₂, respectively, at an upstream pressure of 8 atm, confirmed the outstanding separation performance of the prepared membrane. Copyright © 2009 John Wiley & Sons, Ltd.     

Tribological properties of multilayer nanostructure TiO2 thin film doped by SiO2

Multilayer of TiO₂ and TiO₂:SiO₂ thin films were grown on a glass substrate by sol?Cgel processes, followed by high temperature treatment at 500?°C. The fine grained TiO₂ films controlled by SiO₂ dopant showed very good wear resistance and endurance life. Energy dispersive X-ray spectroscopy was used to indicate the elements in the films. X-ray diffraction analyses indicated that TiO₂ and TiO₂:SiO₂ film contain only anatase phase. The morphologies of the original and worn surfaces of the samples were analyzed by means of scanning tunneling microscope and scanning electron microscopy. The tribological properties of TiO₂ and TiO₂:SiO₂ thin films sliding against AISI52100 steel pin were evaluated on a pin on disk friction and wear tester. The results showed that 25-layer TiO₂:SiO₂ films are superior in reducing friction and resisting wear compared with the glass substrate.     

Merging tribenzotriquinacene with hexa-peri-hexabenzocoronene: a cycloheptatriene unit generated by Scholl reaction

The single-wing extension of the bowl-shaped tribenzotriquinacene (TBTQ) framework with polycondensed aromatic hydrocarbon units has been reported. In the course of a Scholl reaction, one of the three-dimensional bays of the TBTQ core has been bridged by a PAH unit to generate a seven-membered ring within the merged TBTQ-(hexa-peri-hexabenzocoronene) scaffold.     

Evaluation of the Electrophilicites and Band Gaps of Conductive Polymers: A New Model

It is shown that the obtained hardness and electrophilicity values of the short length oligomers for a heterocyclic conductive polymer from density functional theory method are quadraticly correlated to those obtained from semiempirical method. Therefore these quantities for all oligomers (up to 15 repeating units) are predicted using the obtained quadratic relations. Both of these predicted quantities for different oligomers are fitted to a new exponential model (Y = Y_∞ e^d/n) to estimate the electronic properties for the considered conjugated polymers. The calculated band gaps from this model show better agreement with the reported experimental data than those predicted by the previous models. Because of a wide range of variations, the electrophilicity could be a better index for investigating the doping effect in polymers than the hardness.

     

Numerical simulation of cavitation around a two-dimensional hydrofoil using VOF method and LES turbulence model

In this paper simulation of cavitating flow over the Clark-Y hydrofoil is reported using the large eddy simulation (LES) turbulence model and volume of fluid (VOF) technique. We applied an incompressible LES modelling approach based on an implicit method for the subgrid terms. To apply the cavitation model, the flow has been considered as a single fluid, two-phase mixture. A transport equation model for the local volume fraction of vapour is solved and a finite rate mass transfer model is used for the vapourization and condensation processes. A compressive volume of fluid (VOF) method is applied to track the interface of liquid and vapour phases. This simulation is performed using a finite volume, two phase solver available in the framework of the OpenFOAM (Open Field Operation and Manipulation) software package. Simulation is performed for the cloud and super-cavitation regimes, i.e., σ = 0.8, 0.4, 0.28. We compared the results of two different mass transfer models, namely Kunz and Sauer models. The results of our simulation are compared for cavitation dynamics, starting point of cavitation, cavity’s diameter and force coefficients with the experimental data, where available. For both of steady state and transient conditions, suitable accuracy has been observed for cavitation dynamics and force coefficients.     

A Theoretical Study of NBO,NICS, and 14N NQR Parameters of Adenine Tautomers in the Gas Phase via DFT

The natural bond orbital (NBO) analysis, nucleus independent chemical shift (NICS), and ¹⁴N NQR parameters of the most stable tautomers of adenine in the gas phase were predicted using density functional theory method. The NBO analysis revealed that the resonance interaction between lone pair of the nitrogen atom and empty non‐Lewis NBO increases with increasing the p character of the nitrogen lone pair. The present investigation indicated the π clouds in both the considered heterocyclic rings containing six electrons, and these tautomers has the aromatic character. The NICS study utilizing the gauge‐invariant atomic orbital method showed that there are diatropic currents in the heterocyclic rings of the tautomers, so we determined the order of overall aromaticity of these tautomers. The results of NQR parameter calculations showed three parameters are effective on nuclear quadrupole coupling constant; the p character value of lone pair electrons of nitrogens, and the related occupancies and whenever, the lone pair electrons of nitrogens participate in the formation of chemical bond and/or π system of the ring, the q_zz and consequently its χ decreases.     

Microwave-assisted reaction between 2-aminobenzoic acids, 2-hydroxybenzaldehydes,and arylboronic acids: a one-pot three-component synthesis of bridgehead bicyclo[4.4.0]boron heterocycles

A one-pot three-component synthesis of 6-aryl-8H-dibenzo[d,h][1,3,7,2]dioxazaborecin-8-ones is described. A mixture of 2-aminobenzoic acid, 2-hydroxybenzaldehyde, and arylboronic acid undergo a 1:1:1 addition reaction in CCl₄ under microwave irradiation to produce bridgehead bicyclo[4.4.0]boron heterocycles in excellent yields.     

Solvent-free and three-component synthesis of 1H,6H-6λ5-[1,2]benzoxaphospholo[2,3-b][1,2]benzoxaphosphol-1-ones

A concise and facile synthesis of a new class of P,O-heterocycles is described. Knoevenagel condensation reaction of a salicylaldehyde and a cyclohexane-1,3-dione forms an α,β-unsaturated intermediate, which undergoes nucleophilic addition of a trialkyl phosphite under solvent-free conditions to afford the title compounds in good to excellent yields.     

Synthesis of diarylmethanes via a Friedel-Crafts benzylation using arenes and benzyl alcohols in the presence of triphenylphosphine ditriflate

Triphenylphosphine ditriflate (TPPD) was found to be an efficient promoter for the Friedel-Crafts benzylation of arenes with benzyl alcohols in CH₂Cl₂ at room temperature. The good yields, the 1:1 molar ratio of arene and benzyl alcohol, the benzylation of chlorobenzene as a nonactivated aromatic compound at room temperature, and no by-product formation are the main advantages of this procedure.