Concentration and clean-up of trace hydrocarbons from atmospheric particulate matter

Summary The aim of this work is to establish the best conditions for concentration and purification steps in the trace analysis of aliphatic and polycyclic aromatic hydrocarbons (PAH) from atmospheric particulate matter by gas chromatography-flame ionisation detection (GC-FID) and high performance liquid chromatography with ultraviolet and fluorescence detection (HPLC-UV-FL). The best results for the more volatile compound were obtained with a combination of rotary evaporation and a stream of nitrogen (near to 100% for aliphatic hydrocarbons and from 70 to 105% for PAH). Two types of solid phase extraction (SPE)cartridges (Supelclean ^tm LC-Silica SPE tubes and Sep-Pak^? Plus silica cartridges) and glass column were examined for the purification and fractionation step. Blank chromatograms of both types of cartridges analysed by GC-FID made this study difficult, because a PSS (programmed split-splitless) injector was employed thereby increasing the sensitivity. This problem was not observed in the HPLC-UV-FL blank chromatograms of these cartridges. Glass columns filled with silica and alumina were chosen because no interference was found in the GC-FID blank chromatograms and the best recoveries in the fractionation of both aliphatic hydrocarbons and PAH were achieved. This is especially important when aliphatic hydrocarbons concentrations are lower than 1 μg mL⁻¹. Finally, the selected conditions were applied to the analysis of hydrocarbons in real atmospheric particulate samples.     

Structural study of copper-nickel aluminate (CuxNi1−xAl2O4) spinels

CuAl₂O₄, NiAl₂O₄, and three ternary spinels Cu_xNi_1?xAl₂O₃ have been prepared, in polycrystalline form, by solid-state reaction of mixtures of CuO, NiO, and Al₂O₃ at 1223 K. X-Ray powder diffractometry, coupled with adequate computational methods, allowed determination of the unit-cell length, oxygen positional parameter, and cation distribution for each compound. Interdependence of these structural parameters is closely analyzed on the ternary oxide spinels. The one-electron difference between the Cu²⁺ and Ni²⁺ ions was found to be enough to render them distinguishable by X-ray powder diffraction.     

Filiation structurale des phases de´rive´es de BaFeF5

Au sein d'un re´seau de type BaFeF₅ des chai?nes d'octae`dres fluore´sa`sommets communs peuvent disparai?tre en donnant naissance a des canaux dont l'occupation partielle ou totale par des files de cations Sr²⁺ et de couples d'anions F^?, conduit respectivement aux phases Sr₃(FeF₆)₂ ou Sr₅T₃F₁₉ (T = Cr, Co, Ga). Une discussion cristallochimique permet d'expliquer l'existence d'un domaine de solutions solides au sein du diagramme ternaire SrF₂BaF₂FeF₃.     

Application of a mercuric iodide detector for the exploration and exploitation of niobium deposits in remote areas

The comparison of an ambient temperature mercuric iodide spectrometer (HgI₂) with a conventional cooled Si(Li) spectrometer is presented for the determination of niobium in Venezuelan laterites in the laboratory. The energy resolution of the HgI₂ spectrometer was only about 590 eV (FWHM) at 5.9 keV compared to about 150 eV for the conventional Si(Li) spectrometer. The efficiency was about 5 times lower in the region of the Nb_K peak as compared to the Si(Li) detector. Even though its energy resolution and efficiency is much poorer than the conventional Si(Li), the results it produced for the determination of niobium were acceptable for use in the exploration and exploitation of a niobium-rich deposit such as Cerro Impacto, Estado Bolívar, Venezuela.     

Development and Validation of a High-Performance Thin-Layer Chromatographic Method,with Densitometry,for Quantitative Analysis of Tizoxanide (a Metabolite of Nitazoxanide) in Human Plasma

JPC – Journal of Planar Chromatography – Modern TLC - A new simple, rapid, and selective high-performance thin-layer chromatographic (HPTLC) method with metronidazole as the internal...     

Use of SPE—TLC for Quality Control of Rhodiola rosea Extracts

SPE and TLC have been used for qualitative and quantitative analysis of salidroside, rosavin, rosarin, and rosin in commercially available dry extracts from Rhodiola rosea roots. The best separation of all the compounds was achieved on silica gel TLC plates with ethyl acetate—methanol—water, 77 + 13 + 10 (v/v), as mobile phase. UV detection was performed at λ = 215 nm for salidroside and at λ= 245 nm for the rosavins (rosavin, rosarin, and rosin). Detection limits for salidroside and the rosavins were 90 ng and 60 ng per spot, respectively. Results from quantitative analysis confirmed the manufacturer’s declaration of the amounts of salidroside and the rosavins in the extracts.

     

Defect concentration in Ti-substituted YIG from TG curves

The article discusses theory and experiment about the measurement of defect concentration in Ti-substituted yttrium iron garnet by means of thermogravimetry techniques. The two possible cases arising from oxygen interchange with atmosphere, oxygen vacancies and interstitial cations, may be analyzed quantitatively from the derived expressions. The possibility of another type of defects being present in the samples, not associated to oxygen evolution, is not excluded. Measurements were carried out in air and CO₂ for different Ti contents. The substitution tends to increase slightly the defect parameter θ in YIG, while a CO₂ reducing atmosphere is much more effective than the Ti substitution for increasing θ. Calculations for a given single-phased sample sintered in air show two possibilities: a deficit of one oxygen atom for every 2.5 unit cells of 96 atoms, or one excess cation for every 3.5 cells. Other samples show very similar results. The accuracy involved in the measurements is about 2–3%.