The Influence of Variable Convective Velocities on Longitudinal Diffusion

Solutions are presented for the impulsively started uniformstream and simple shear flows past a point source of momentum,which can be interpreted to describe the position and the widthof the front which transmits the knowledge of the singularitythrough a slightly viscous fluid. These understandings are thengeneralized to show that the front always moves with velocityslower than that of a (strictly monotonic) convective velocity,and also that its width always grows faster than with simplediffusion. Finally, a remarkably simple, exact expression is given forvorticity due to a simple shear flow past a point vortex.     

Letters to the Editor

The Mathematical Intelligencer encourages comments about the material in this issue. Letters to the editor should be sent to either of the editors-in-chief, Chandler Davis or Marjorie Senechal.     

Shape transition from InAs quantum dash to quantum dot on InP(3 1 1)A

We report on the shape transition from InAs quantum dashes to quantum dots (QDs) on lattice-matched GaInAsP on InP(3 1 1)A substrates. InAs quantum dashes develop during chemical-beam epitaxy of 3.2 monolayers InAs, which transform into round InAs QDs by introducing a growth interruption without arsenic flux after InAs deposition. The shape transition is solely attributed to surface properties, i.e., increase of the surface energy and symmetry under arsenic deficient conditions. The round QD shape is maintained during subsequent GaInAsP overgrowth because the reversed shape transition from dot to dash is kinetically hindered by the decreased ad-atom diffusion under arsenic flux.     

Degradative chain transfer in vinyl acetate polymerizations using toluene as solvent

In this work, we propose that retardation in vinyl acetate polymerization rate in the presence of toluene is due to degradative chain transfer. The transfer constant to toluene (C_trs) determined using the Mayo method is equal to 3.8 × 10^?3, which is remarkably similar to the value calculated from the rate data, assuming degradative chain transfer (2.7 × 10^?3). Simulations, including chain‐length‐dependent termination, were carried out to compare our degradative chain transfer model with experimental results. The conversion–time profiles showed excellent agreement between experiment and simulation. Good agreement was found for the M_n data as a function of conversion. The experimental and simulation data strongly support the postulate that degradative chain transfer is the dominant kinetic mechanism. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 3620–3625, 2007     

Pressure effects in a plastic columnar discotic triphenylene

The effect of hydrostatic pressure on the structure of a plastic columnar discotic triphenylene has been investigated. The goal was to determine whether pressure can be used to modify electronic properties via changes in structural properties of columnar discotics to any significant extent. The findings are that (i) the intra- and inter-columnar distances are reduced in a nearly isotropic fashion, (ii) that the crystal sizes are reduced and (iii) that a transition takes place from a more highly ordered plastic columnar to a less ordered hexagonal columnar state with increasing pressure. The induced decrease of the molecular distances, amounting to 6% for pressures up to 17 kbar, are clearly too small to induce an appreciable modification of the electronic structure and thus opto-electronic properties.     

Control of a liquid–liquid heat exchanger

 The analytical solutions of equations describing the dynamics of distributed parameter systems are usually complicated in form and derivations and inconvenient to use for simulation and control system design. The liquid–liquid counter flow heat exchanger is an example of these disturbed parameter systems. An analytical solution of the dynamics of a symmetrically operated counter flow heat exchanger in the form of transfer function matrix is investigated in open-loop and close-loop conditions. The resulting non-linear model was linearized using perturbation approach. A feed-forward path controller to counteract at any disturbances in the boundary temperature and a non-interactive controller to decouple the outputs were implemented. Received on 22 February 2001 / Published online: 29 November 2001     

Structure of norbornene-fused 3,1-oxazine double cycloadducts

Pentacyclic isoxazolines were obtained by the cycloaddition of benzonitrile oxide to norbornene-azetidinone-fused 3,1-oxazines. The constitutions of two of the isomers obtained, and the configurations and conformations of all products, were determined by means of ¹H and ¹³C NMR spectroscopy and DNOE experiments.     

Galactic model of element formation

A cosmological model is presented that produces He, C, O, D, Li, Be, and B in their observed abundances without a Big Bang. The elements are produced during the 1.5-Gy formation period of a galaxy, with C, O, and other heavy elements produced by stars of M>12 M₃ , He by stars of 6 M_s<M<12 M_s, and D, Li, Be, and B by cosmic-ray reactions in a nearly pure H plasma halo. Thus, the model shows that the major elements used in astrophysical studies can be produced during galactic formation by exactly the same processes known to function today at much lower rates     

On Critical Stability of Three Quantum Charges Interacting Through Delta Potentials

We consider three one-dimensional quantum, charged and spinless particles interacting through delta potentials. We derive sufficient conditions which guarantee the existence of at least one bound state.