Synthesis of a seven-membered analog of eledoisin using the solid-phase method of peptide synthesis

Summary 1. The solid-phase method of peptide synthesis has been used to obtain the heptapeptide HGly-L-Ala-L-Phe-L-Val-Gly-L-Leu-L-Met which is an analog of eledoisin.2. The possibility has been shown of using o-nitrophenylsulphenyl derivatives of amino acids in the solid-phase method of peptide synthesis.Khimiya Prirodnykh Soedinenii, Vol. 2, No. 3, pp 200–202, 1966     

Triterpene glycosides ofSapindus mukorossi

Conclusions The structure of two triterpone glycosides fromSapindus mukorossi Gaertn. has been established. It has been shown that sapindoside A is hederagenin 3-O--L-arabinosyl-(2 1)--L-rhamnopyranoside and sapindoside B is the 3-O--L-arabopyranosyl-(2 1)-O--L-rhamnopyranosyl-(3 1)--D-xylopyranoside.     

Direct flame-photometric determination of calcium in soil and plant extracts,water and serum with special reference to sodium,potassium and phosphate interference

An investigation of the possibilities for the direct determination of calcium with a single-cell filter flame photometer, without preliminary separation as oxalate, led to the following conclusions:Calibration curves for 100 p.p.m. of calcium are rectilinear.Sodium causes an appreciable positive error.The error due to potassium interference is relatively much smaller than that due to sodium. Up to a certain concentration it is positive and increases with the concentration, then the emission seems to be gradually depressed and the error finally becomes negative.Phosphates cause a very significant negative error, which tends to be asymptotic. The “radiation buffer” method of correction is not practical here because the max. error is too high (—92.5%).Except for extreme cases, calcium can be determined by direct spraying, without preliminary separation as oxalate: (a) in drinking and irrigation water, correction being necessary only for sodium interference, (b) in soil extracts, correcting only for phosphate effects, (c) in normal blood sera, without clinically significant corrections at 1+3 dilution.Owing to the large variations in the contents of Na, K and PO₄^-3 in plants, calcium cannot be determined in plant-ash extracts without preliminary separation as oxalate. This applies also to abnormal sera, although there the variations in Na and PO₄^-3 content are not so large.     

Synthesen von Heterocyclen, 45. Mitt.: Über eine Synthese von substituierten Barbitursäuren

Zusammenfassung Kürzlich wurde in einer Publikation vonA. K. Bose undS. Garratt über eine neue Synthese von substituierten Barbitursäuren aus Malonsäuren und substituierten Malonsäuren mit Carbodiimiden berichtet. Hierdurch sehen wir uns veranlaßt, über unsere bisherigen Ergebnisse im Rahmen ähnlicher Untersuchungen kurz zu berichten.     

Influence of a Surface Microheterogeneity on the Disjoining Pressure of Adsorbed Lennard–Jones Fluid. Computer Simulation

Computer simulation of the adsorption of Lennard–Jones fluid in slitlike micropores with structured walls was performed by the Monte Carlo and molecular dynamic methods. The influence of pore width, temperature, pressure, and surface structure on the disjoining pressure was considered. Structural and energy characteristics of the surface affect significantly the value of the disjoining pressure. Among the surface structural characteristics, the important role is played by the number and localization of vacancy-type defects.     

Darstellung und thermische Zersetzung von Lithiumcyanuraten Eine einfache Methode zur Gewinnung von wasserfreiem Lithiumcyanat

Zusammenfassung Die Darstellung von Mono-, Di- und Tri-Lithiumcyanurat durch Umsetzung von Cyanursäure mit LiOH bzw. Li₂CO₃ in hochsiedenden Alkoholen und durch lösungsmittelfreie Festkörperreaktion wird beschrieben. Die Festkörperreaktionen werden mit Hilfe thermoanalytischer Methoden untersucht. Die Reaktion mit LiOH erfolgt in zwei Schritten und ergibt bei 400°C. Trilithium-cyanurat. Unter denselben Bedingungen wird mit Li₂CO₃ nur Dilithium-cyanurat gebildet. Die Thermolyse von Trilithium-cyanurat bei 550°C liefert in hoher Ausbeute Lithiumcyanat und stellt somit eine einfache Methode zur Darstellung dieser Verbindung in wasserfreier Form dar.

---

Formation and thermolysis of lithium cyanurates (a simple preparation of anhydrous lithium cyanate)

The formation of mono-, di- and tri-lithium cyanurate by reaction of LiOH or Li₂CO₃ with cyanuric acid has been investigated as a solid state reaction and by using high boiling alcohols as reaction medium. For investigating the solid state reactions thermoanalytical methods were used. The reaction with LiOH proceeds in two steps yielding trilithium cyanurate at 400°C. Under the same conditions only dilithium cyanurate is formed by reaction with Li₂CO₃. Lithium cyanate is obtained in high yields by thermolysis of trilithium cyanurate at 550°C. This procedure is therefore a simple method in synthesizing pure anhydrous lithium cyanate.

---

---

Mit 3 Abbildungen

---

Herrn Univ.-Prof. Dr.O. Kratky zum 70. Geburtstag gewidmet.     

Heterogeneous-catalytic fischer reaction

The catalytic synthesis of 7-azaindole and its 2-methyl derivative has been accomplished for the first time by cyclization of acetaldehyde and acetone 2-pyridylhydrazones in the presence of -Al₂O₃ and fluorinated aluminum oxide. The temperature dependence of the yields of reaction products — azaindoles and 2-aminopyridine — was studied. The cyclization of acetaldehyde 2-pyridylhydrazone proceeds under more severe conditions. The maximum yield of 7-azaindole is 15% at 450° on fluorinated aluminum oxide. The yield of 2-methyl-7-azaindole reaches 50% at 315°. Fluorinated aluminum oxide displays higher catalytic activity.See [1] for communication III.Translated from Khimiya Geterotsiklicheskikh Soedinenii, No. 5, pp. 656–658, May, 1972.     

Synthesis of 1, 2-diazabicyclo [4.4.0] decane and its derivatives

A new heterocyclic system, 1, 2-diazabicyclo [4.4.0] decane is synthesized, starting from-(piperidyl-2) propionic acid. The latter is converted to-(1-nitrosopiperidyl-2)-propionic acid, and thence, via-(1-aminopiperidyl-2) propionic acid, to 3-keto-1, 2-diazabicyclo [4.4.0] decane. Derivatives of 1, 2-diazabicyclo [4.4.0] decane with a substituent at position 2 are prepared.