The Role of Radical Bridges in Polynuclear Single-Molecule Magnets

Employing radical bridges between anisotropic metal ions has been a viable route to achieve high-performance single-molecule magnets (SMMs). While the bridges have been mainly considered for their ability to promote exchange interactions, the crystal-field effect arising from them has not been taken into account explicitly. This lack of consideration may distort the understanding and limit the development of the entire family. To shed light on this aspect, herein we report a theoretical investigation of a series of N -radical-bridged diterbium complexes. It is found that while promoting strong exchange coupling between the terbium ions, the N -radical induces a crystal field that interferes destructively with that of the outer ligands, and thus reduces the overall SMM behavior. Based on the theoretical results, we conclude that the SMM behavior in this series could be further maximized if the crystal field of the outer ligands is designed to be collinear with that of the radical bridge. This conclusion can be generalized to all exchange-coupled SMMs.     

Wechselnde Bindungen in einem Zweikörpersystem mit trockener Reibung

Übersicht Betrachtet wird ein zwangserregtes Zweikörpersystem mit wechselnden Bindungen infolge trockener Reibung. Stationäre Bewegungen werden als Grenzfall instationärer Einschwingvorgänge berechnet. Abhängig von den Systemparametern ergeben sich drei typische Bewegungsformen. Ihnen entsprechen dauernde Haftzustände, wechselnde Haft-Gleitzustände oder dauernde Gleitzustände an der Berührfläche beider Körper.

---

Intermittant constraints in a two-body-system with dry friction

Summary An externally excited two-body-system with intermittant constraints due to dry friction is considered. Stationary motions are calculated as limit cases of instationary transients. Depending on the parameters of the system, three typical modes are of interest. These correspond to permanent sticking, slipstick behaviour, or to permanent slipping in the contact surface of the bodies, respectively.

     

Notiz über Parachloraldehyd

Ohne Zusammenfassung     

Selective Propargylation of Carbonyl Compounds and Imines with Barium Reagents

A Barbier‐type regioselective propargylation of aldehydes and ketones with (3‐bromobut‐1‐ynyl)trimethylsilane has been achieved using reactive barium as a low‐valent metal in THF. Especially in the case of ketones, the corresponding homopropargylic alcohols form almost exclusively. In the reaction of α,β‐unsaturated carbonyl compounds, only 1,2‐adducts have been observed. This method is also applicable to propargylation of imines, and the corresponding homopropargylic amines are obtained regiospecifically in good yields with diastereomeric ratios of up to 87:13.     

Synthesis and Characterization of Silica@Copper Core–Shell Nanoparticles: Application for Conjugate Addition Reactions

Silica@copper (SiO₂@Cu) core–shell nanoparticles were synthesized and well characterized by XRD, TEM, AFM, XPS, UV/Vis, TGA–MS, and ICP–AES techniques. The synthesized SiO₂@Cu core–shell nanoparticles were employed as catalysts for the conjugate addition of amines to α,β‐unsaturated compounds in water to obtain β‐amino carbonyl compounds in excellent yields in shorter reaction times. Furthermore, the catalyst works well for hetero‐Michael addition reactions of heteroatom nucleophiles such as thiols to α,β‐unsaturated compounds. As the reaction is performed in water, it allows for easy recycling of the catalyst with consistent activity.     

Soluble,saturated‐red‐light‐emitting poly(p‐phenylenevinylene) containing triphenylamine units and cyano groups

A conjugated poly(p‐CN‐phenylenevinylene) (PCNPV) containing both electron‐donating triphenylamine units and electron‐withdrawing cyano groups was prepared via Knoevenagel condensation in a good yield. Gel permeation chromatography suggested that the soluble polymer had a very high weight‐average molecular weight of 309,000. A bright and saturated red emission was observed under UV excitation in solution and film. Cyclic voltammetry showed that the polymer presented quasi‐reversible oxidation with a relatively low potential because of the triphenylamine unit. A single‐layer indium tin oxide/PCNPV/Mg–Ag device emitted a bright red light (633 nm). © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 3947–3953, 2004     

Fluorescent-based single-strand conformation polymorphism/heteroduplex capillary electrophoretic mutation analysis of the P53 gene.

Fluorescent-based single-strand conformation polymorphism (F-SSCP) analysis with capillary electrophoresis (CE) is the most common method for the detection of mutation because of its high sensitivity and resolution. In this study, we prepared an inexpensive linear polyacrylamide (LPA), and successfully applied it to CE-SSCP analysis and tandem CE-SSCP/heteroduplex analysis (HA) of the P53 gene on an ABI capillary genetic analyzer. A comparison of the sieving capabilities of a homemade LPA and commercial polydimethylacrylamide (PDMA) demonstrates that the homemade LPA has a higher resolution, a shorter analysis time, and is more suitable for tandem SSCP/HA than commercial PDMA. To show the usefulness, mutations of P53 gene exon 7 - 8 in 37 tumor samples were investigated by using homemade LPA. The results indicate that 10 mutations were found in 9 of 37 cases; the majority of P53 mutations were missense mutations, and 70% were located in exon 7, which plays an important role in neoplastic progression in human tumorigenesis.     

Determination of tyrosine traces by adsorption voltammetry of its copper (II) complex

The electrochemical behavior of the copper-tyrosine complex has been studied by linear-sweep adsorption voltammetry. In 0.02 mol/L Na₂HPO₄ buffer solution (pH=9.6), the complex can be adsorped on a hanging mercury drop electrode and reduced at a peak potential of about –0.42 V (vs. SCE). The secondary derivative peak height is linear proportional to the concentration of tyrosine in the range 1.0×10^–7–5.0×10^–5 mol/L. The detection limit is 5×10^–8 mol/L.Project supported by the Provincial Science Foundation of Shandong Province     

FTIR spectroscopic study on the interaction between a fluoroionophore and metal ions.

A fluoroionophore sensor, N-[4-(1-pyrene)butyroyl]-L-tryptophan (PLT), has been reported. It can distinguish lead ion from other 12 metal ions via forming a pyrene dimer and it exhibits a very high sensitivity (0.15 microM) in aqueous solution (Chem. Commun., 2006, 2702). When the indole moiety in PLT was changed to benzene, in forming a new fluoroionophore of N-[4-(1-pyrene)butyroyl]-L-phenylalanine (PLP), it could not form a pyrene dimer in response to Pb(2+) in water. The present study describes the spectroscopic clarification of the intrinsic differences of the binding model between PLP and PLT in binding with Pb(2+). The model shows identical chelating bidentate coordination between COO(-) and Pb(2+) both in PLP-Pb and PLT-Pb; however, there is no indication of the interaction between the phenyl ring and the metal ion or the hydrogen bonding between amide groups in PLP-Pb. These differences in the binding model between PLP-Pb and PLT-Pb illustrate that the indole ring in PLT appears to play a crucial role in the high selectivity and sensitivity of PLT to lead(II) ion.