Operator‐splitting method for the analysis of cavitation in liquid‐lubricated herringbone grooved journal bearings

This paper presents an operator‐splitting method (OSM) for the solution of the universal Reynolds equation. Jakobsson–Floberg–Olsson (JFO) pressure conditions are used to study cavitation in liquid‐lubricated journal bearings. The shear flow component of the oil film is first solved by a modified upwind finite difference method. The solution of the pressure gradient flow component is computed by the Galerkin finite element method. Present OSM solutions for slider bearings are in good agreement with available analytical and experimental results. OSM is then applied to herringbone grooved journal bearings. The film pressure, cavitation areas, load capacity and attitude angle are obtained with JFO pressure conditions. The calculated load capacities are in agreement with available experimental data. However, a detailed comparison of the present results with those predicted using Reynolds pressure conditions shows some differences. The numerical results showed that the load capacity and the critical mass of the journal (linear stability indicator) are higher and the attitude angle is lower than those predicted by Reynolds pressure conditions for cases of high eccentricities. Copyright © 2004 John Wiley & Sons, Ltd.     

Grid‐free surface vorticity method applied to flow induced vibration of flexible cylinders

In order to study cross flow induced vibration of heat exchanger tube bundles, a new fluid–structure interaction model based on surface vorticity method is proposed. With this model, the vibration of a flexible cylinder is simulated at Re=2.67 × 10⁴, the computational results of the cylinder response, the fluid force, the vibration frequency, and the vorticity map are presented. The numerical results reproduce the amplitude‐limiting and non‐linear (lock‐in) characteristics of flow‐induced vibration. The maximum vibration amplitude as well as its corresponding lock‐in frequency is in good agreement with experimental results. The amplitude of vibration can be as high as 0.88D for the case investigated. As vibration amplitude increases, the amplitude of the lift force also increases. With enhancement of vibration amplitude, the vortex pattern in the near wake changes significantly. This fluid–structure interaction model is further applied to simulate flow‐induced vibration of two tandem cylinders and two side‐by‐side cylinders at similar Reynolds number. Promising and reasonable results and predictions are obtained. It is hopeful that with this relatively simple and computer time saving method, flow induced vibration of a large number of flexible tube bundles can be successfully simulated. Copyright © 2004 John Wiley & Sons, Ltd.     

The Spectrum of a Linearized 2D Euler Operator

We study the spectral properties of the linearized Euler operator obtained by linearizing the equations of incompressible two-dimensional fluid at a steady state with the vorticity that contains only two nonzero complex conjugate Fourier modes. We prove that the essential spectrum coincides with the imaginary axis, and give an estimate from above for the number of isolated nonimaginary eigenvalues. In addition, we prove that the spectral mapping theorem holds for the group generated by the linearized 2D Euler operator.     

Medicinal Organometallic Chemistry: Designing Metal Arene Complexes as Anticancer Agents

The field of medicinal inorganic chemistry is rapidly advancing. In particular organometallic complexes have much potential as therapeutic and diagnostic agents. The carbon‐bound and other ligands allow the thermodynamic and kinetic reactivity of the metal ion to be controlled and also provide a scaffold for functionalization. The establishment of structure–activity relationships and elucidation of the speciation of complexes under conditions relevant to drug testing and formulation are crucial for the further development of promising medicinal applications of organometallic complexes. Specific examples involving the design of ruthenium and osmium arene complexes as anticancer agents are discussed.     

On the dynamic electromechanical loading of dielectric elastomer membranes

Dielectric elastomer actuators (DEAs) have received considerable attention recently due to large voltage-induced strains, which can be over 100%. Previously, a large deformation quasi-static model that describes the out-of-plane deformations of clamped diaphragms was derived. The numerical model results compare well with quasi-static experimental results for the same configuration. With relevance to dynamic applications, the time-varying response of initially planar dielectric elastomer membranes configured for out-of-plane deformations has not been reported until now. In this paper, an experimental investigation and analysis of the dynamic response of a dielectric elastomer membrane is reported. The experiments were conducted with prestretched DEAs fabricated from 0.5 mm thick polyacrylate films and carbon grease electrodes. The experiments covered the electromechanical spectrum by investigating membrane response due to (i) a time-varying voltage input and (ii) a time-varying pressure input, resulting in a combined electromechanical loading state in both cases. For the time-varying voltage experiments, the membrane had a prestretch of three and was passively inflated to various predetermined states, and then actuated. The pole strains incurred during the inflation were as high as 25.6%, corresponding to slightly less than a hemispherical state. On actuation, the membrane would inflate further, causing a maximum additional strain of 9.5%. For the time-varying pressure experiments, the prestretched membrane was inflated and deflated mechanically while a constant voltage was applied. The membrane was cycled between various predetermined inflation states, the largest of which was nearly hemispherical, which with an applied constant voltage of 3 kV corresponded to a maximum polar strain of 28%. The results from these experiments reveal that the response of the membrane is a departure from the classical dynamic response of continuum membrane structures. The dynamic response of the membrane is that of a damped system with specific deformation shapes reminiscent of the classical membrane mode shapes but without same-phase oscillation, that is to say all parts of the system do not pass through the equilibrium configuration at the same time. Of particular interest is the ability to excite these deformations through a varying electrical load at constant mechanical pressure.     

Dispersion modeling by kinematic simulation: Cloud dispersion model

A new technique has been developed to compute mean and fluctuating concentrations in complex turbulent flows (tidal current near a coast and deep ocean). An initial distribution of material is discretized into any small clouds which are advected by a combination of the mean flow and large scale turbulence. The turbulence can be simulated either by kinematic simulation (KS) or direct numerical simulation. The clouds also diffuse relative to their centroids; the statistics for this are obtained from a separate calculation of the growth of individual clouds in small scale turbulence, generated by KS. The ensemble of discrete clouds is periodically re-discretized, to limit the size of the small clouds and prevent overlapping. The model is illustrated with simulations of dispersion in uniform flow, and the results are compared with analytic, steady state solutions. The aim of this study is to understand how pollutants disperses in a turbulent flow through a numerical simulation of fluid particle motion in a random flow field generated by Fourier modes. Although this homogeneous turbulent is rather a “simple” flow, it represents a building block toward understanding pollutant dispersion in more complex flow. The results presented here are preliminary in nature, but we expect that similar qualitative results should be observed in a genuine turbulent flow.     

3,4‐[2,2‐Bis(methoxyethoxymethoxymethyl)propylenedithio]‐3′,4′‐(ethylenedithio)tetrathiafulvalene: a spiro‐substituted BEDT–TTF analogue

The crystal structure of the title compound [systematic name: 2‐(1,3‐dithiolo[4,5‐b][1,4]dithiin‐2‐ylidene)‐6,6‐bis(methoxyethoxymethoxymethyl)‐1,3‐dithiolo[4,5‐b][1,4]dithiepine], C₂₁H₃₀O₆S₈, a spiro‐substituted BEDT–TTF analogue [BEDT–TTF is bis(ethylenedithio)tetrathiafulvalene], has a strongly bent heterocyclic framework. The seven‐membered ring adopts a pseudo‐chair conformation with notably widened ring bond angles, especially at the methylene C atoms [119.49 (11) and 117.60 (11)°]. The axial side chain adopts an extended conformation, but the equatorial side chain curls back on itself and the O atom nearest the ring system is involved in three short contacts to H atoms (2.45–2.53 Å). The molecules pack in centrosymmetrically related pairs, which are isolated from each other by columns of the polyether side chains. This study emphasizes the ease of distortion of the neutral bis(propylenedithio)tetrathiafulvalene ring structure, and how the need to accommodate side chains can easily override the tendency of these donor systems to form stacks in the crystalline state.     

Mechanics of hexagonal atomic lattices

A theoretical framework for describing the kinematics and energetics of hexagonal atomic lattices, including planar carbon graphene sheets and cylindrical nanotubes, is proposed. By analogy with the membrane theory of thin shells, the deformation of the particulate lattice in the neighborhood of each atom is described in terms of a uniquely defined deformation gradient and companion local inner displacement. Expressions for the pointwise tensions developing in the plane of the lattice are developed, and a rational procedure for deriving discrete equilibrium equations is discussed. An alternative formulation involving the second-order deformation gradient that parallels the strain gradient theory of bulk media is proposed, and a tentative analogy with a the theory of micropolar elastic media is outlined.     

Genetically Encoded Bioluminescent Indicator for ERK2 Dimer in Living Cells

In this study, a genetically encoded bioluminescent indicator for ERK2 dimer was developed with the split Renilla luciferase complementation method, in which the formation of ERK2 dimer induces a spontaneous emission of bioluminescence in living cells. In response to extracellular stimuli, such as epidermal growth factor (EGF) or 17β‐estradiol (E2), extracellular signal‐regulated kinase 2 (ERK2) is phosphorylated by its upstream kinase MEK, and also phosphorylates its substrates in various regions of the cell, including the nucleus. Phosphorylated ERK2 is led to form its dimer, thereby transporting itself into the nucleus. We demonstrated with the indicator that stimulation with EGF or E2 induces the formation of ERK2 dimer in living MCF‐7 cells. The dynamics of this dimer formation was examined and discussed.