石墨炉原子吸收光谱法直接测定血样中硒

用石墨炉原子吸收光谱法，以硝酸铜和硝酸铵为基体改进剂，塞曼效应扣背景，采用标准加入法可直接测定血样中硒，回收率为95％～105％，相对标准偏差为5．8％，检出限为96pg，测定结果准确可靠。     

Terminally functionalized polyisobutylene oligomers as soluble supports in catalysis

A new phase selective hydrocarbon soluble polymer support is described.     

Stereochemie von Metallocenen, 40. Mitt.

Starting from optically active methylferrocene-- and--carboxylic acids (1 a and1 b) of known absolute configuration and enantiomeric purity about 15 chiral ferrocenes (of each isomeric series— and ) were obtained by suitable ligand transformations. Thereby (almost) all possible chiral combinations of the ligands CH₃, COOH (COO^–), COOCH₃, CN and NH₂ (NH₃ ⁺) were accessible which are necessary for a potential test of approximations of chirality functions for compounds with basic symmetry C_5v. The chiroptical properties of these disubstituted ferrocenes are recorded.Preliminary tests using a shortened Ansatz revealed large discrepancies between calculated () and found [M]_D-values. Possible reasons for this failure are discussed.

---

---

61. Mitt. über Ferrocenderivate

---

39. Mitt.:A. Meyer, H. Neudeck undK. Schlögl, Chem. Ber.110, 1403 (1977).

---

60. Mitt.:V. Rapi, K. Schlögl undB. Steinitz, J. Organometal. Chem.94, 87 (1975).     

Neue Wege der Analytik durch Kombination der direkten quantitativen Dünnschicht-Chromatographie mit elektronischer Datenverarbeitung

A computer program for direct evaluation of thin-layer chromatograms, which already was described earlier [3] has been tested with a laboratory and some technical formulations of a pesticide. Results have been compared with those obtained by two conventional methods. Mean relative standard deviation calculated from results compiled by electronic data processing (method A) is about 6%, compared to 10% received by graphic method (method C) which is employed by most investigators. In addition, overall time of analysis is 34% higher if graphic method is used. Method A saves time and expense especially in routine analysis because working of the process is easier and may be performed even by assistent personal. The proposed method is suitable for the determination of different active ingredients and impurities even in difficult technical products.     

反气相色谱法研究聚丙烯结晶动力学及对熔点和结晶度的测定

<正> 研究聚合物的结晶动力学,过去大多采用膨胀计法和解偏振光法。曾有文献报道采用反气相色谱法测得聚乙烯等温结晶线。通过实验可知,测定聚丙烯结晶度时,试样热历史和测定前陈化温度的选择均影响测定结果。此外在测定聚丙烯试样的熔点时,保留图中出现了两个转折,经反复实验证实:此两转折对应于聚丙烯中不同晶形(α-、β-形)的熔点。     

Zur Kenntnis von Natrium-hexafluoromanganat(III)

Sodium hexafluoromanganate(III) has been synthesized by heating equimolecular quantities of Na₂MnF₅ and NaF in argon atmosphere. The compound is monoclinic witha=5.56 (1) Å,b=5.84 (1) Å,c=8.10 (2) Å, =90.7 (2) andZ=2. It is a high spin complex with _eff and the deformation of the octahedra is evident from its IR-spectra. Two enantiotropic transitions (at 562 and 653°C) and the melting point at 800°C have been observed.

---

---

8. Mitt.: Mh. Chem.106, 483 (1975).     

Discussion on the method for the measurement of the flexural modulus of coupled materials and reasons of the shifts of theQ −1 maxima caused by coupling

Summary When measuringQ ^–1 and the flexural resonance frequency of bars clamped at one end, constituted by a viscoelastic polymeric material glued to a rigid support of modulusE ₁, it is possible to calculate the componentsE ₂ andE ₂ of the complex elastic modulus of the polymeric material examined. In this work the minimum (critical) value of the ratioa=E ₂ /E ₁=a _c and the values of the ratioQ ₂ ^–1/Q ^–1=F ₁ are evaluated beyond which no exact calculation ofE ₂ and ofQ ₂ ^–1 is possible.Within the confidence limits of the linear viscoelasticity theory, these values depend on the accuracy of measurement of both frequency and resonance curve, as well as on the instrument employed, on the operating temperature and on the ratio between the thicknesses of the two coupled materials.In order to keep outside the critical conditions, the most convenient method involves the use of measurements of coupled test-pieces having different ratiosz between their thicknesses and of supports having different modulusE ₁, depending on the field of temperature of the analysis ofE ₂ and tg ₂ concerning and E.P.R. elastomer and a vulcanized cis-1,4 polyisoprene in very wide ranges of temperature comprising the glass transition. Moreover, it is demonstrated by analysis the shift on the temperature axis of the tg maximum of the composite test-piece with respect to the position of the tg maximum of the polymeric material alone.With 11 figures and 1 table