Exponential convergence for one dimensional contact processes

The complete convergence theorem implies that starting from any initial distribution the one dimensional contact process converges to a limit ast. In this paper we give a necessary and sufficient condition on the initial distribution for the convergence to occur with exponential rapidity.This work was discussed while the authors were visiting the Nankai Mathematics Institute in Tianjin.Partially supported by the National Science Foundation, the Army Research Office through the Mathematical Sciences Institute at Cornell University, and a Guggenheim fellowship.Research supported by the National Science Foundation of China.     

Percolation and electrical resistivity in the YBa2Cu3O7−Ag composite system

We have measured the resistivity of the YBa₂Cu₃O₇–Ag composite system with Ag volume fraction,p _Ag ranging from 0–100%. The percolation behavior and the normal-state resistivity are studied. We find a three-dimensional threshold for the Ag matrix occurring atp _Ag 20% and a threshold for the superconducting matrix occurring at 1–p _Ag30%. The electrical resistivity is interpreted in terms of a resistivity model for granular YBa₂Cu₃O₇ proposed by Halbritter et al. [Z. Phys. B —Condensed Matter71, 411 (1988)]. Based on this model, we show that the resistivities between the YBa₂Cu₃O₇ grains and flaws in the grains are greatly diminished in the samples, indicating significantly improved grain growth behavior of the YBa₂Cu₃O₇ phase resulting from the addition of Ag. With the diminishing of the grain boundary resistivities, an intrinsic value for the temperature coefficient of resistivity, (1/gr)(d/dT), can be inferred, which is 3.3×10^–3/K at 300 K. This value is very close to that observed in the Cu–O₂ planes in single crystals and epitaxial films of YBa₂Cu₃O₇.     

The asymptotic properties of the multichannel autoregressive spectral estimates

If we fit a-vector stationary time series using observationsx(1), ...,x(T) with AR models , then the spectral densityf() of {x(t)} can be estimated byf _k ^(T) ()=(2)^– A _k ^(T) (e ^–)^–1 _k ^(T) A _k ^(T) (e ^–i)^–, where are estimates of the variance matrix of(t), the residuals of the best linear prediction. By extending some results for the scalar case, this paper treats the asymptotic properties of the estimates in the multichannel case.     

4-Amino-imidazole durchThorpe-Cyclisierung

The alkylation of arylaminomethylenecyanamides1 or cyano-imidothiocarbamates2 with -halogen carbonyl compounds followed by base catalysed cyclization yields substituted 4-amino-imidazoles4. Imidazo[4,5-d]pyrimidones5, 6 and imidazo[4,5-b]pyridines7 can be obtained from4.     

The electrocapillarity of polyacrylates

Summary The electrocapillary properties of polyacrylic acid have been studied by two methods. Exploratory measurements have been made of the effect of the polymer on the differential capacity of a mercury drop in 0.1 m sodium perchlorate. They showed that the polymer was strongly adsorbed over a wide range of potentials but that it did not appear to form a monolayer. The surface excess of polymer obtained from drop weight data showed a maximum at very low concentrations and then a decline at higher concentrations. The bulk of the work was carried out by making surface tension measurements, using a sessile mercury drop, in solutions of a fraction of polyacrylic acid (mol. wt. 7.02×10⁴) in potassium chloride at 0.01, 0.1, 0.2, and 0.5 m at 25°C.The data have been used to evaluate the surface excesses of the polymer and of the inorganic ions. The distribution of K⁺ and Cl^– in the electrical double layer and the contact adsorption of Cl^– on the mercury were very little affected by the presence of the polymer. The surface excess of polymer was always found to be greatest at low concentrations, to decrease steeply at first as the concentration was increased and then to decrease more slowly at higher concentrations.Possible explanations of this behaviour are discussed and it is concluded that the rapid decrease is a consequence of molecular weight dispersion and the stronger adsorption of high molecular weight polymer. The slow decrease in surface excess at higher concentrations may be a result of configurational changes of the polymer molecules.Surface pressure data show that, despite this decrease in the surface excess, the surface coverage reaches a high level at very low polymer concentrations and then continues to increase slowly as the concentration of polymer is increased. This apparent contradiction is due to changes in configuration of the adsorbed polymer molecules. At higher bulk concentrations the chain configurations are more compact and each adsorbed molecule makes more contacts with and so occupies a greater area of the mercury surface than at low concentrations.The conclusion is reached that the surface excess of polymer is mostly contained in a layer probably more than 1000 Å thick. It consists of a concentrated and entangled mass of polymer chains. Relatively few of these chains are in contact with the mercury at any istant. The concentration in this surface layer decreases steadily with increasing distance from the mercury surface and it merges without discontinuity into the bulk solution.With 10 figures in 22 details     

Stereochemie von Metallocenen, 40. Mitt.

Starting from optically active methylferrocene-- and--carboxylic acids (1 a and1 b) of known absolute configuration and enantiomeric purity about 15 chiral ferrocenes (of each isomeric series— and ) were obtained by suitable ligand transformations. Thereby (almost) all possible chiral combinations of the ligands CH₃, COOH (COO^–), COOCH₃, CN and NH₂ (NH₃ ⁺) were accessible which are necessary for a potential test of approximations of chirality functions for compounds with basic symmetry C_5v. The chiroptical properties of these disubstituted ferrocenes are recorded.Preliminary tests using a shortened Ansatz revealed large discrepancies between calculated () and found [M]_D-values. Possible reasons for this failure are discussed.

---

---

61. Mitt. über Ferrocenderivate

---

39. Mitt.:A. Meyer, H. Neudeck undK. Schlögl, Chem. Ber.110, 1403 (1977).

---

60. Mitt.:V. Rapi, K. Schlögl undB. Steinitz, J. Organometal. Chem.94, 87 (1975).     

Neue Wege der Analytik durch Kombination der direkten quantitativen Dünnschicht-Chromatographie mit elektronischer Datenverarbeitung

A computer program for direct evaluation of thin-layer chromatograms, which already was described earlier [3] has been tested with a laboratory and some technical formulations of a pesticide. Results have been compared with those obtained by two conventional methods. Mean relative standard deviation calculated from results compiled by electronic data processing (method A) is about 6%, compared to 10% received by graphic method (method C) which is employed by most investigators. In addition, overall time of analysis is 34% higher if graphic method is used. Method A saves time and expense especially in routine analysis because working of the process is easier and may be performed even by assistent personal. The proposed method is suitable for the determination of different active ingredients and impurities even in difficult technical products.     

Molecular dynamics studies on octadecylammonium chloride at the air/liquid interface

Molecular dynamics simulations on surfactant octadecylammonium chloride at the air/liquid interface were performed. It was found that the alkyl chains of octadecylammonium would change to order with increasing the concentration of octadecylammonium at the air/liquid interface. Some functions, such as the concentration distributions, the radial distribution function and the mean squared displacement (MSD) were evaluated to investigate the structural properties of interface. We found that the salts can affect octadecylammonium aggregate at the interface: (1) univalent ions, such as chloride and sodium ions, affect slightly the structure of monolayer and (2) bivalent ions, such as sulfate or calcium ions, affect greatly, especially for the bivalent negative ions.