用于光学神经网络硬件系统误差纠正的虚拟神经网络

提出了一种用于修正光学神经网络硬件系统误差的虚拟神经网络模型，光学实验结果表明该网络能够有效地消除硬件系统误差对实验结果的影响。     

A Note on L（2, 1）-labelling of Trees

An L(2,1)-labelling of a graph G is a function from the vertex set V (G) to the set of all nonnegative integers such that |f(u) f(v)| ≥ 2 if d G (u,v)=1 and |f(u) f(v)| ≥ 1 if d G (u,v)=2.The L(2,1)-labelling problem is to find the smallest number,denoted by λ(G),such that there exists an L(2,1)-labelling function with no label greater than it.In this paper,we study this problem for trees.Our results improve the result of Wang [The L(2,1)-labelling of trees,Discrete Appl.Math.154 (2006) 598-603].     

快速凝固Cu-Pb过偏晶合金的性能表征

研究了Cu-Pb过偏晶合金的急冷快速凝固组织特征,定量表征了快速凝固Cu-Pb过偏晶合金的电阻率和力学性能,理论分析了冷却速率和组织形态对合金性能的影响规律. 研究结果表明,在急冷快速凝固条件下,Cu-Pb过偏晶合金中的(Cu)相和(Pb)相均以枝晶方式生长,晶体形态以均匀细小的等轴晶为特征. 随着冷却速率增大,一方面,凝固组织显著细化,晶界增多,对自由电子的散射作用增强,合金电阻率显著增大;另一方面,细晶强化作用增强,合金的抗拉强度呈线性升高,同时,伴随着晶体缺陷数量的增多,合金的伸长率降低. 关键词： Cu-Pb过偏晶合金 快速凝固 电阻率 力学性能     

SBN:Cr晶体的光折变四波混频相位共轭特性实验研究

从实验上研究了同成分SBN:Cr晶体在He-Ne激光照射下的四波混频相位共轭特性.首先测量了在不同泵浦光与信号光光强比m及不同光束夹角2θ的情况下,晶体的四波混频相位共轭反射率R随泵浦光强比p的变化关系.其次测量了泵浦光束与信号光束耦合方向对SBN:Cr晶体的四波混频相位共轭特性的影响,并就两种不同掺杂浓度的晶体样品进行了对比,所得实验结果与理论分析基本一致.最后,利用SBN:Cr晶体四波混频相位共轭特性进行了图象畸变消除实验.     

Experimental study of a plasma-filled backward wave oscillator

Experimental studies of a plasma-filled X-band backward-wave oscillator (BWO) are presented. Depending on the background gas pressure, microwave frequency upshifts of up to 1 GHz appeared along with an enhancement by a factor of 7 in the total microwave power emission. The bandwidth of the microwave emission increased from ⩽0.5 GHz to 2 GHz when the BWO was working at the RF power enhancement pressure region. The RF power enhancement appeared over a much wider pressure range in a high beam current case (10-100 mT for 3 kA) than in a lower beam case (80-115 mT for 1.6 kA). The plasma-filled BWO has higher power output than the vacuum BWO over a broader region of magnetic guide field strength. Trivelpiece-Gould modes (T-G modes) are observed with frequencies up to the background plasma frequency in a plasma-filled BWO. Mode competition between the T-G modes and the X-band Tm₀₁ mode prevailed when the background plasma density was below 6×10¹¹ cm^-3 . At a critical background plasma density of ≃8×10¹¹ cm^-3 power enhancement appeared in both X-band and the T-G modes. Power enhancement of the S-band in this mode collaboration region reached up to 8 dB. Electric fields measured by the Stark-effect method were as high as 34 kV/cm while the BWO power level was 80 MW. These electric fields lasted throughout the high-power microwave pulse     

Mössbauer study of Fe-B alloys containing Nd additives

The influence of a few percent neodynium additives to Fe-B alloy on the hyperfine parameters was investigated. It was found that Nd decreases the hyperfine field of amorphous Fe-B alloys. The samples annealed at temperatures between 600°C and 700°C contain α-Fe and Fe₃B phases. The average hyperfine field of Fe₃B phase increases with increasing Nd content and decreases with increasing annealing temperature. The average isomer shift of Fe₃B phase decreases with increasing Nd content. The experimental data show that the change of hyperfine parameters of the Fe₃B phase in the studied alloys is due to Nd atom.     

A 100 kHz Narrow-Pulse-Width Mid-Infrared Optical Parametric Oscillator Based on PPMgLN Crystal

We report a narrow pulse width optical parametric oscillator based on periodically poled MgO:LiNbO₃ (PPMgLN) with a high repetition rate under quasi-phase matched conditions. When the maximum pumping power of the 1,064-nm laser was 14.57 W, the acousto-optical (A-O) Q-switch repetition rate was 100 kHz, and the PPMgLN crystal grating period was 29.5 μm. A 1,474-nm signal light output power of 4.21 W and a 3,828 nm idler light output power of 1.547 W were obtained, corresponding to a pulse width of 9.52 ns and 9.65 ns, respectively. The overall optical–optical conversion efficiency was 39.5%. Additionally, by changing the temperature from 25°C to 150°C, a tunable signal wavelength of 1,474–1,499 nm and idler wavelength at 3,676–3,828 nm of the output laser were achieved.     

Angular-Multiplexing Optical Multiple-Image Encryption Based on Digital Holography and Random Amplitude Mask

We propose an improved optical image encryption scheme. By illuminating original images positioned in the input plane of the 4-f correlator and introducing reference waves with different incident angles in the output plane, we accomplish multiple-image encryption. To enhance the feasibility of the system and decrease the coding compliance for random phase mask, we apply the random amplitude masks and some digital manipulations in the encryption and decryption procedure. We also analyze the encryption and decryption quality of the method proposed together with the influence of different random number generators. Numerical simulation has proved the validity of the architecture suggested.     

Jet formation in shock-heavy gas bubble interaction

The influences of the acoustic impedance and shock strength on the jet formation in shock-heavy gas bubble interaction are numerically studied in this work. The process of a shock interacting with a krypton or a SF 6 bubble is studied by the numerical method VAS2D. As a validation, the experiments of a SF 6 bubble accelerated by a planar shock were performed. The results indicate that, due to the mismatch of acoustic impedance, the way of jet formation in heavy gas bubble with different species is diversified under the same initial condition. With respect to the same bubble, the manner of jet formation is also distinctly different under different shock strengths. The disparities of the acoustic impedance result in different effects of shock focusing in the bubble, and different behaviors of shock wave inside and outside the bubble. The analyses of the wave pattern and the pressure variation indicate that the jet formation is closely associated with the pressure perturbation. Moreover, the analysis of the vorticity deposition, and comparisons of circulation and baroclinic torque show that the baroclinic vorticity also contributes to the jet formation. It is concluded that the pressure perturbation and baroclinic vorticity deposition are the two dominant factors for the jet formation in shock-heavy gas bubble interaction.     

Equivalent theories and tension properties of semi-reentrant structures

Meccanica - Semi Reentrant structures, which exhibit zero Poisson’s ratio and monoclastic curvature, are combinations of hexagonal Honeycomb and auxetic Reentrant structures. Deflections and...