Ab initio crystal orbital studies on linear chains of H atoms

Anab initio crystal orbital method is used to calculate the energies of an infinite chain of H atoms and of linear arrangements of H₂ molecules with different interatomic distances. The H₂ arrangements are not stable in respect to isolated molecules. The cohesive energy of an optimized arrangement of H atoms chain is 0.0354 a.u.     

Rapid qualitative analysis of metallic alloys by electrospot chromatography

Summary Electrography and paper chromatography were combined to analyse rapidly metallic alloys in an almost non destructive technique. Using anodic dissolution the sample is applied on the start point of the chromatographic paper. Known ketones-HCl-water mixtures are usually used as solvents to analyse electrospots of different alloys and metal coatings and a separate electrospottest is recommended for Cr. Results of qualitative analysis of some steels, Cu–Ni, and Pb alloys are presented.     

Study of the segmental dynamics in semi-crystalline poly(lactic acid) using mechanical spectroscopies

The glass transition of poly(L-lactic acid) (PLLA) occurs not far above typical service temperatures (room or body temperatures) which has consequences on the material properties during its use, such as damping or the occurrence of structural relaxation. This work aims at characterising the glass transition dynamics of a semi-crystalline PLLA using both dynamic mechanical analysis (DMA) and thermally stimulated recovery (TSR). The main viscoelastic parameters have been characterised at 1 Hz using DMA and the master curve obtained after isothermal experiments at different temperatures provided a full picture of the solid-state rheological behaviour throughout a wide frequency range. The activation energies calculated from the shift factors agree with the TSR ones, exhibiting a maximum near the T(g). Above the T(g), the results can be described with the WLF model. In the glassy state, the activation energy decreases with decreasing temperatures being always higher than the prediction of the Adam and Gibbs theory, at least down to temperatures 30 degrees C below the T(g). This suggests the existence of non-arrested degrees of freedom in the glassy state, being consistent with the existence of a significant degree of cooperativity in the TSR results.     

N,N'-ethylenebis(pyridoxylideneiminato) and N,N'-ethylenebis(pyridoxylaminato): synthesis, characterization, potentiometric, spectroscopic, and DFT studies of their vanadium(IV) and vanadium(V) complexes

The Schiff base N,N'-ethylenebis(pyridoxylideneiminato) (H(2)pyr(2)en, 1) was synthesized by reaction of pyridoxal with ethylenediamine; reduction of H(2)pyr(2)en with NaBH(4) yielded the reduced Schiff base N,N'-ethylenebis(pyridoxylaminato) (H(2)Rpyr(2)en, 2); their crystal structures were determined by X-ray diffraction. The totally protonated forms of 1 and 2 correspond to H(6)L(4+), and all protonation constants were determined by pH-potentiometric and (1)H NMR titrations. Several vanadium(IV) and vanadium(V) complexes of these and other related ligands were prepared and characterized in solution and in the solid state. The X-ray crystal structure of [V(V)O(2)(HRpyr(2)en)] shows the metal in a distorted octahedral geometry, with the ligand coordinated through the N-amine and O-phenolato moieties, with one of the pyridine-N atoms protonated. Crystals of [(V(V)O(2))(2)(pyren)(2)].2 H(2)O were obtained from solutions containing H(2)pyr(2)en and oxovanadium(IV), where Hpyren is the "half" Schiff base of pyridoxal and ethylenediamine. The complexation of V(IV)O(2+) and V(V)O(2) (+) with H(2)pyr(2)en, H(2)Rpyr(2)en and pyridoxamine in aqueous solution were studied by pH-potentiometry, UV/Vis absorption spectrophotometry, as well as by EPR spectroscopy for the V(IV)O systems and (1)H and (51)V NMR spectroscopy for the V(V)O(2) systems. Very significant differences in the metal-binding abilities of the ligands were found. Both 1 and 2 act as tetradentate ligands. H(2)Rpyr(2)en is stable to hydrolysis and several isomers form in solution, namely cis-trans type complexes with V(IV)O, and alpha-cis- and beta-cis-type complexes with V(V)O(2). The pyridinium-N atoms of the pyridoxal rings do not take part in the coordination but are involved in acid-base reactions that affect the number, type, and relative amount of the isomers of the V(IV)O-H(2)Rpyr(2)en and V(V)O(2)-H(2)Rpyr(2)en complexes present in solution. DFT calculations were carried out and support the formation and identification of the isomers detected by EPR or NMR spectroscopy, and the strong equatorial and axial binding of the O-phenolato in V(IV)O and V(V)O(2) complexes. Moreover, the DFT calculations done for the [V(IV)O(H(2)Rpyr(2)en)] system indicate that for almost all complexes the presence of a sixth equatorial or axial H(2)O ligand leads to much more stable compounds.     

Highly stereoselective and efficient total synthesis of (+)-laurencin

A highly stereoselective and efficient asymmetric total synthesis of (+)-laurencin (1) has been accomplished from the known oxazolidinone 5 in 15 steps. The route features an efficient internal alkylation to form oxocene 3 from 4 and a novel use of acetonitrile anion as a two-carbon acetaldehyde equivalent for direct synthesis of ketone 2 from alpha-alkoxy amide 3.     

The effect of pH on the reactions of catalytically important RhI complexes in aqueous solution: reaction of [RhCl(tppms)3] and trans-[RhCl(CO)(tppms)2] with hydrogen (TPPMS = mono-sulfonated triphenylphosphine).

Hydrolysis and hydrogenation of [RhCl(tppms)3] (1) and trans-[RhCl(CO)(tppms)2] (2) was studied in aqueous solutions in a wide pH range (2 < pH < 11) in the presence of excess TPPMS (3-diphenylphosphinyl-benzenesulfonic acid sodium salt). In acidic solutions hydrogenation of 1 yields a mixture of cis-mer- and cis-fac-[RhClH2(tppms)3] (3a,b) while in strongly basic solutions [RhH(H2O)(tppms)3] (4) is obtained, the midpoint of the equilibrium between these hydride species being at pH 8.2. The paper gives the first successful 1H and 31P NMR spectroscopic characterization of a water soluble rhodium(I)-monohydride (4) bearing only monodentate phosphine ligands. Hydrolysis of 2 is negligible below pH 9 and its hydrogenation results in formation of [Rh(CO)H(tppms)3] (5), which is an analogue to the well known and industrially used hydroformylation catalyst [Rh(CO)H(tppts)3] (6) (TPPTS = 3,3',3'-phosphinetriyltris(benzenesulfonic acid) trisodium salt). It was shown by pH-potentiometric measurements that formation of 5 is strongly pH dependent in the pH 5-9 range, this gives an explanation for the observed but previously unexplained pH dependence of several hydroformylation reactions. Conversely, the effect of pH on the rate of hydrogenation of maleic and fumaric acid catalyzed by 1 in the 2 < pH < 7 range can be adequately described by considering solely the changes in the ionization state of these substrates. All these results warrant the use of buffered (pH-controlled) solutions for aqueous organometallic catalysis.     

Purification of plasmid DNA vectors by aqueous two-phase extraction and hydrophobic interaction chromatography

The current study explores the possibility of using a polyethyleneglycol(PEG)-ammonium sulphate aqueous two-phase system (ATPS) as an early step in a process for the purification of a model 6.1 kbp plasmid DNA (pDNA) vector. Neutralised alkaline lysates were fed directly to ATPS. Conditions were selected to direct pDNA towards the salt-rich bottom phase, so that this stream could be subsequently processed by hydrophobic interaction chromatography (HIC). Screening of the best conditions for ATPS extraction was performed using three PEG molecular weights (300, 400 and 600) and varying the tie-line length, phase volume ratio and lysate load. For a 20% (w/w) lysate load, the best results were obtained with PEG 600 using the shortest tie-line (38.16%, w/w). By further manipulating the system composition along this tie-line in order to obtain a top/bottom phase volume ratio of 9.3 (35%, w/w PEG 600, 6%, w/w NH4)2 SO4), it was possible to recover 100% of pDNA in the bottom phase with a three-fold increase in concentration. Further increase in the lysate load up to 40% (w/w) with this system resulted in a eight-fold increase in pDNA concentration, but with a yield loss of 15%. The ATPS extraction was integrated with HIC and the overall process compared with a previously defined process that uses sequential precipitations with iso-propanol and ammonium sulphate prior to HIC. Although the final yield is lower in the ATPS-based process the purity grade of the final pDNA product is higher. This shows that it is possible to substitute the time-consuming two-step precipitation procedure by a simple ATPS extraction.     

Hydroxypropyl chitosan bearing beta-cyclodextrin cavities: synthesis and slow release of its inclusion complex with a model hydrophobic drug

Hydroxypropyl chitosan-graft-carboxymethyl beta-cyclodextrin (HPCH-g-CM beta-CD) was synthesized by grafting CM beta-CD onto HPCH using water soluble 1-ethyl-3-(3-dimethylaminopropyl)carbodiimide (EDC) as the condensing agent. Due to the presence of hydrophobic beta-CD rings onto the HPCH backbone, this polymer can be used as a matrix for controlled drug release. The adsorption of a hydrophobic model drug, ketoprofen, by HPCH-g-CM beta-CD microparticles (using tripolyphosphate as an ionic crosslinking agent) fitted well in the Langmuir isotherm equation. The drug dissolution profile showed that HPCH-g-CM beta-CD microparticles provided a slower release of the entrapped ketoprofen than chitosan, and the release behavior was influenced by the pH value of the medium. These results suggest that beta-CD grafted with chitosan derivatives may become a potential biodegradable delivery system to control the release of hydrophobic drugs with pH-responsive capability.     

Influence of pretreatment conditions on low-temperature CO oxidation over Au/MOx/Al2O3 catalysts

Composite oxide MO_x/Al₂O₃ supported gold catalysts for low-temperature CO oxidation were prepared and investigated. The presence of transition metal oxide was proved to be beneficial to the improvement of catalytic performance of Au/Al₂O₃ catalysts for low-temperature CO oxidation. Furthermore, the influence of various pretreatment conditions on Au/MO_x/Al₂O₃ catalysts was studied carefully. The image of TEM showed that gold catalyst with small gold particles only in the form of a fine dispersion exhibited highly catalytic activity. The XPS, Fourier transform infrared (FTIR) spectroscopy characterization results of Au/FeO_x/Al₂O₃ catalyst showed that gold catalysts having partially oxidized gold species have the best catalytic performance. One possible pathway for CO oxidation on Au/FeO_x/Al₂O₃ catalyst is that the CO adsorbed on gold particles reacts with adsorbed oxygen, which is possible to occur on oxygen vacancies on the support or at the metal–support interface.