O′-β′复相Sialon陶瓷中相组成的控制

用Si₃N₄,SiO₂和Al₂O_?作原料,以Y₂O_?为添加剂,研究了O’-β’所在的四个相容性区中组成,于1400—1800℃之间,O’和β’的形成动力学。O’于1400℃开始生成,1600℃达到最大形成量。高于1600℃,O’减少乃至消失。研究发现,O’的这种不稳定性,并非自身热分解的结果。Al含量的增加,液相出现和β’的形成,才是导致O’-Sialon溶解而消失的原因。 此外,认为Si₃N₄-O’(x=0.3)-Y₂Si₂O₇-YAG相容性区,是在制备具有合理的O’-β’平衡相组成的复相陶瓷时,可供实际选用的组成区。     

Pressure and temperature dependence of the gas‐transport properties of dense poly[2,6‐toluene‐2,2‐bis(3,4‐dicarboxylphenyl)hexafluoropropane diimide] membranes

The gas‐transport properties of poly[2,6‐toluene‐2,2‐bis(3,4‐dicarboxylphenyl)hexafluoropropane diimide] (6FDA‐2,6‐DAT) have been investigated. The sorption behavior of dense 6FDA‐2,6‐DAT membranes is well described by the dual‐mode sorption model and has certain relationships with the critical temperatures of the penetrants. The solubility coefficient decreases with an increase in either the pressure or temperature. The temperature dependence of the diffusivity coefficient increases with an increase in the penetrant size, as the order of the activation energy for the diffusion jump is CH₄ > N₂ > O₂ > CO₂. Also, the average diffusion coefficient increases with increasing pressure for all the gases tested. As a combined contribution from sorption and diffusion, permeability decreases with increases in the pressure and the kinetic diameter of the penetrant molecules. Even up to 32.7 atm, no plasticization phenomenon can be observed on flat dense 6FDA‐2,6‐DAT membranes from their permeability–pressure curves. However, just as for other gases, the absolute value of the heat of sorption of CO₂ decreases with increasing pressure at a low‐pressure range, but the trend changes when the feed pressure is greater than 10 atm. This implies that CO₂‐induced plasticization may occur and reduce the positive enthalpy required to create a site into which a penetrant can be sorbed. Therefore, a better diagnosis of the inherent threshold pressure for the plasticization of a glassy polymer membrane may involve examining the absolute value of the heat of sorption as a function of pressure and identifying the turning point at which the gradient of the absolute value of the heat of sorption against pressure turns from a negative value to a positive one. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 354–364, 2004     

Synthesis and optoelectronic properties of silole‐containing polyfluorenes with binary structures

2,5‐Bis(2‐bromofluorene‐7‐yl)silole was prepared by a modified one‐pot synthesis with a reverse addition procedure, from which novel silole‐containing polyfluorenes with binary random and alternating structures (silole contents between 4.5 and 25% and high M_w up to 509 kDa were successfully synthesized. The well‐defined repeating unit of the alternating copolymer comprises a terfluorene and a silole ring. Optoelectronic properties including UV absorption, electrochemistry, photoluminescence (PL), and electroluminescence (EL) of the copolymers were examined. The different excitation energy transfers from fluorene to silole of the copolymers in solution and in the solid state were compared. The films of the copolymers showed silole‐dominant green emissions with high absolute PL quantum yields up to 83%. EL devices of the copolymers with a configuration of ITO/PEDOT/copolymer/Ba/Al displayed exclusive silole emissions peaked at around 543 nm and the highest EL efficiency was achieved with the alternating copolymer. Using the alternating copolymer and poly(9,9‐dioctylfluorene) as the blend‐type emissive layer, a maximum external quantum efficiency of 1.99% (four times to that of the neat film) was realized, which was a high efficiency so far reported for silole‐containing polymers. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 756–767, 2007     

An algorithm for three-way data analysis that alternatively minimizes coupled vector (COV) resolution error and PARAFAC error.

A novel algorithm, alternatively minimizing coupled vector (COV) resolution error and PARAFAC error algorithm, is proposed in this paper. This algorithm can overcome the problem of slow convergence and is insensitive to the estimation of component number, such problems are unavoidable while using the traditional parallel factors analysis (PARAFAC) algorithm. In other words, this algorithm is capable of improving the computing speed and providing accurate resolutions provided that the number of factors used in the computation is no less than that of the actual underlying ones. The characteristic performances were demonstrated with a novel fluorescence data array.     

Coriatone and corianlactone, two novel sesquiterpenes from Coriaria nepalensis

Both coriatone (1). a novel highly oxygenated picrotoxane-type sesquiterpene, and corianlactone (2). with an unprecedented sesquiterpene basic skeleton, named coriane, were isolated from Coriaria nepalensis Wall. The structures of 1 and 2 were determined by analysis of their two-dimensional NMR data, and the structure of 2 was confirmed by X-ray analysis. Compounds 1 and 2 showed no remarkable inhibitory activity toward K(562) cells. They are cytotoxic with IC(50) > 50 microg/mL (cis-platinim: IC(50) = 0.49 microg/mL).     

聚苯乙烯稀溶液的小角激光弹性和准弹性光散射

随着激光技术的发展,近年来出现了与散射光频加宽相应的光子相干光谱即准弹性光散射。于是,利用光散射(也称弹性光散射)法不仅能获得高聚物的各种物性参数如分子量(?),第二维利系数A_2和均方旋转半径(),而且还能得到大分子在溶液中的动态参数,即扩散系数D_0。由D_0求得流体力学半径R_H。本文只涉及小角度准弹性光散射(1°<θ<7°)对稀溶液范围的平动扩散系数的测定。与文献比较,表明方法是成功的。