Bis[μ‐1‐(1,10‐phenanthrolin‐2‐yl)‐2‐pyridone]bis{aqua[1‐(1,10‐phenanthrolin‐2‐yl)‐2‐pyridone]cadmium(II)} tetrakis(perchlorate)

In the title centrosymmetric binuclear complex, [Cd₂(C₁₇H₁₁N₃O)₄(H₂O)₂](ClO₄)₄, the Cd^II ion assumes a distorted octahedral geometry. There are π–π stacking interactions between the pyridine and 1,10‐phenanthroline ring systems of adjacent ligands at the same Cd^II centre. Intermolecular hydrogen bonds between the coordinated aqua ligand and the O atom of a keto group connect adjacent complex cations into extended chains. Hydrogen bonds also exist between the complex cations and the perchlorate anions. Compared with the fluorescence spectrum of the organic ligand, the complex displays strong fluorescent emission and an ipsochromic shift of the emission peaks, which may be attributed to the structural character.     

微型网状结构支架的力学性能研究

冠状动脉支架为圆柱形微型网状结构，直径1mm，厚度0．1mm，长度10～16mm。在经皮冠状动脉介入PCI治疗中由球囊充气撑开到直径为2．5～3．5mm的支架，在血管内承受血管壁回弹压力。为了保持血液流通支架必须保持其几何圆形。这是一个结构弹塑性稳定性问题。但是目前国际上对于支架的力学性能质量指标主要以强度性能评定而不涉及支架屈曲性能是不妥的。本文对于支架的强度和屈曲性能进行了全面的理论分析和实验研究，自行研制了智能式电子检测仪成功地对微型网状结构支架的强度和屈曲性能实现了实测实验研究。由于微型支架的离散型网状结构的特点，在实验中出现一些特殊的屈曲现象。本文研究结果对于支架的形状与性能设计的改进和力学性能质量标准规范的制订具有重要意义。     

<Emphasis FontCategory="NonProportional">L</Emphasis>-Matrices and solvability of linear complementarity problems by a linear program-Matrices and solvability of linear complementarity problems by a linear program

The classes ofL ₁-matrices,L ₂-matrices,L ₃-matrices andW-matrices are introduced to study solvability of a linear complementarity problem via solving a linear program. Three sufficient conditions are presented to guarantee that a linear complementarity problem is solvable via a linear program. The new sufficient conditions are weaker than the ones introduced by Mangasarian. This fact is also illustrated by an example. Partially supported by NSFC. This author is also with College of Business Administration of Human University as a Lotus chair professor.     

一类非线性弹簧振子的周期性振动

本文用数值计算的方法讨论了一类非线性弹簧振子的周期性振动及其特点．     

Selected-area growth of carbon nanotubes by the combination of focused ion beam and chemical vapor deposition techniques.

In this article, we report a technique for growing carbon nanotubes in a more controllable fashion, which enables us to synthesize nanotubes directly in various forms of designed patterns. This nanofabrication process is based on a combination of focused ion beam (FIB) and chemical vapor deposition (CVD) techniques. In this process, arrays of conductive patterns were first deposited on silicon substrates by directing a gaseous compound (C(9)H(16)Pt) via the capillary needle-sized nozzles within a FIB system. The substrates were then coated with catalyst and further modified by the FIB to localize the position of the catalyst. Finally, the growth of carbon nanotubes on the designed substrates was carried out by CVD of hydrocarbon gases. This fabrication technique has the advantage of positioning carbon nanotubes in selected locations. This may open up opportunities for the direct synthesis of carbon nanotubes onto almost any substrate material, thus allowing fabrication of carbon nanotube-based devices.     

利用计算机辅助装调检测矩形大口径离轴非球面的方法研究

通过非球面的零位补偿法,完成了对矩形大口径离轴非球面镜的检测。先用光学设计软件Zemax从理论上分析了在检测中会出现的现象,并结合计算机辅助装调技术,确定在检测过程中相对敏感的自由度,然后控制这些量,使补偿器和非球面的相对关系与理论设计相吻合,在Zygo相位干涉仪上测得最终结果。在λ=632.8nm时,中心圆口径与两个边缘圆口径面形误差RMS分别为0.022λ,0.037λ,0.032λ。检测结果,达到预期目的。     

KxCoO2·yH2O(x《0.2,y≤0.8)的晶体结构、输运及磁学性质

利用熔融KOH和Co3O4在较低温度(480℃)下反应制备出K0.36CoO2,然后用高锰酸钾溶液和饱和的过硫酸钾溶液进行氧化处理.氧化的同时伴随有水分子嵌入.K0.36CoO2用高锰酸钾和过硫酸钾溶液处理后分别得到K0.12CoO2·0.8H2O和K0.16CO2·0.6H2O.这两种化合物都属于六角晶系,表现出金属行为,脱水后主相变为正交结构并且呈现出半导体特性.K0.16CoO2·0.6H2O在56K附近可能存在自旋玻璃转变行为或其他涨落.随着钾含量的减少和水含量的增多,样品的自旋玻璃行为受到抑制或发生磁性相分离.样品K0.12CoO2·0.8H2O在零场冷却和有场冷却曲线上的分叉现象基本上消失.还讨论了产生KxCoO2与NaxCoO2体系结构和物性差别的原因.     

35Cr25Ni12奥氏体耐热钢中碳化物的电子显微分析

应用扫描电镜（SEM）和透射电镜（TEM）研究了长期使用前后的35Cr25Ni12奥氏体耐热钢中的碳化物演变行为；该钢固溶时效后的组织由初晶奥氏体及M23C6共晶碳化物组成，奥氏体基体中析出了二次M23C6，二次碳化物总是与基体保持立方－立方取向关系；长期使用（3、5年）后，奥氏体中析出的二次碳化物量明显增加，部分M23C6已转变为M6C，M6C与奥氏体基体以及二次碳化物M23C6保持[001]M6C//[221]A//[221]M23C6孪晶取向关系。     

Enhancement of Overall Photovoltaic Efficiency by Changing the Position of the Attaching Group -RSO3- on the Hemicyanine Dye Molecules

A new photoresponsive D-π-A dye, mPS, has been designed and synthesized.Compared to the parent dye PS, IPCE values in the region from 400 nm to 560 nm was greatly improved upon changing the attaching group from the p- position to the o- position of the π-conjugation bridge. A solar cell based on mPS generated a remarkably high overall yield η of 5.4% under irradiation of 80.0 mW cm^-2 white light from a Xe lamp, Compared with PS, the overall yield η increased by 64%.