Crystal growth simulations of methane hydrates in the presence of silica surfaces

We present a molecular dynamics simulation study of the crystal growth of methane hydrates in the presence of model silica (SiO(2)) surfaces. The crystal growth under apparent steady-state conditions shows a clear preference for bulk solution. We observe rather disordered water arrangements very close to the silica surface within about 5 ? in both liquid and crystalline regions of the system. These disordered structures have dynamic and structural properties intermediate between those exhibited by molecules in bulk liquid and crystalline phases. The presence of methane molecules appears to help stabilize these structures. We observe that under appropriate conditions, the hydroxylated silica surfaces can serve as a source of methane molecules which can help promote hydrate growth near the surfaces.     

Mirror symmetry for Del Pezzo surfaces: Vanishing cycles and coherent sheaves

We study homological mirror symmetry for Del Pezzo surfaces and their mirror Landau-Ginzburg models. In particular, we show that the derived category of coherent sheaves on a Del Pezzo surface X _k obtained by blowing up ℂℙ² at k points is equivalent to the derived category of vanishing cycles of a certain elliptic fibration W _k :M _k →ℂ with k+3 singular fibers, equipped with a suitable symplectic form. Moreover, we also show that this mirror correspondence between derived categories can be extended to noncommutative deformations of X _k , and give an explicit correspondence between the deformation parameters for X _k and the cohomology class [B+iω]∈H ²(M _k ,ℂ).     

Electrophoresis in capillary cells with detection gap

A novel design of the detection zone in multicapillary arrays used for electrophoretic separation is presented. The use of a detection gap (DG), in which the reflective surfaces separating the channels of the array are eliminated, is proposed to improve the illumination and detection of the separated DNA fragments. The electric field compression in the DG is achieved by optimization of the gap geometry. The results of the computer simulation and experiment demonstrate no substantial band-broadening in the DG. We believe that the proposed method will be useful for application in the microfabricated devices.     

Unconventional zigzag indium phosphide single-crystalline and twinned nanowires

Unconventional zigzag indium phosphide (InP) single-crystalline and twinned nanowires were produced via thermal evaporation of indium phosphide in the presence of zinc selenide. The structure and morphology of the as-synthesized products were characterized by X-ray diffraction, scanning electron microscopy, and transmission electron microscopy. Studies found that two type of nanowires exist in the products, namely, the periodic-rhombus-decorated single-crystalline InP (type I) nanowires and jagged twinned InP (type II) nanowires. Both of them have preferential 111 growth directions. The optical properties were also investigated at room temperature, and they show that the nanowires display a strong emission at approximately 750 nm, which is quite different from that observed in all previous reports related to the InP nanostructures.     

Morphology-controlled synthesis of ZnO nanostructures by a simple round-to-round metal vapor deposition route

One-dimensional ZnO nanostructures with different morphologies have been successfully synthesized through a simple round-to-round metal vapor deposition route at 550 degrees C with a zinc powder covered indium film as the source material. The structures and morphologies of the products were characterized in detail by using X-ray diffraction, scanning electron microscopy, and transmission electron microscopy. Studies found that the morphology of the products can be easily tuned from one experimental round to another. Possible growth mechanisms for the formation of one-dimensional ZnO nanostructures with different morphologies are discussed. Photoluminescence studies show that there are sharp UV emission and broad defect-related green emissions for the products obtained in all experimental rounds. Relative intensity of the UV emission to defect-related emissions gradually increased from one experimental round to another.     

Nanosecond relaxation dynamics of protein GB1 identified by the time-dependent red shift in the fluorescence of tryptophan and 5-fluorotryptophan

The B1 domain of Streptococcal protein G (GB1) is a small, thermostable protein containing a single tryptophan residue. We recorded time-resolved fluorescence of the wild-type GB1 and its 5-fluorotryptophan (5FTrp) variant at more than 30 emission wavelengths between 300 and 470 nm. The time-resolved emission spectra reveal no signs of heterogeneity, but show a time-dependent red shift characteristic of microscopic dielectric relaxation. This is true for both 5FTrp and unmodified Trp in GB1. The time-dependent red shifts in the fluorescence of 5FTrp and unmodified Trp are essentially identical, confirming that the shift is caused by the relaxation of the protein matrix rather than by the fluorophore itself. The total amplitude (but not the rate) of the time-dependent red shift depends on the fluorophore, specifically, on the magnitude of the vector difference between its excited state and ground state electric dipole moments; for 5FTrp this is estimated to be about 88% of that for the unmodified Trp. The decay of the excited state fluorophore population is not monoexponential for either fluorophore; however, the deviation from the monoexponential decay law is larger in the case of unmodified Trp. The relaxation dynamics of GB1 was found to be considerably faster than that of other proteins studied previously, consistent with the small size, tightly packed core, and high thermodynamic stability of GB1.