Phase behaviour of tri-n-butylmethylammonium chloride hydrates in the presence of carbon dioxide

The phase behaviour of the system water?Ctri-n-butylmethylammonium chloride (TBMAC)?CCO₂ was investigated by pressure-controlled differential scanning calorimetry in the range 0?C10?mol% TBMAC in water and at CO₂ pressures ranging from 0 to 1.5?MPa. In the absence of CO₂, an incongruent melting hydrate, which estimated composition corresponds to TBMAC·30H₂O, crystallizes at temperatures below ?13.6?°C and forms with ice a peritectic phase at approximately 3.9?mol% TBMAC. In the presence of CO₂ at pressures as low as 0.5?MPa, curves evidenced the presence of an additional phase exhibiting congruent melting at temperatures that are strongly pressure dependent and significantly higher than those of hydrates obtained without CO₂. This new phase, whose enthalpy of dissociation and CO₂ content increase slightly with CO₂ pressure, was identified as a mixed semi-clathrate hydrate of TBMAC and CO₂ of general formula: (TBMAC?+?xCO₂)·30H₂O.     

Tuning the electronic structure of octahedral iron complexes [FeL(X)] (L = 1-alkyl-4,7-bis(4-tert-butyl-2-mercaptobenzyl)-1,4,7-triazacyclononane,X = Cl,CH(3)O,CN, NO). The S = 1/2 <==>3/2 Spin equilibrium of [FeL(Pr)(NO)

Two new pentadentate, pendent arm macrocyclic ligands of the type 1-alkyl-4,7-bis(4-tert-butyl-2-mercaptobenzyl)-1,4,7-triazacyclononane where alkyl represents an isopropyl, (L(Pr))(2-), or an ethyl group, (L(Et))(2-), have been synthesized. It is shown that they bind strongly to ferric ions generating six-coordinate species of the type [Fe(L(alk))X]. The ground state of these complexes is governed by the nature of the sixth ligand, X: [Fe(III)(L(Et))Cl] (2) possesses an S = 5/2 ground state as do [Fe(III)(L(Et))(OCH(3))] (3) and [Fe(III)(L(Pr))(OCH(3))] (4). In contrast, the cyano complexes [Fe(III)(L(Et))(CN)] (5) and [Fe(III)(L(Pr))(CN)] (6) are low spin ferric species (S = 1/2). The octahedral [FeNO](7) nitrosyl complex [Fe(L(Pr))(NO)] (7) displays spin equilibrium behavior S = 1/2<==>S = (3)/(2) in the solid state. Complexes [Zn(L(Pr))] (1), 4.CH(3)OH, 5.0.5toluene.CH(2)Cl(2), and 7.2.5CH(2)Cl(2) have been structurally characterized by low-temperature (100 K) X-ray crystallography. All iron complexes have been carefully studied by zero- and applied-field M?ssbauer spectroscopy. In addition, Sellmann's complexes [Fe(pyS(4))(NO)](0/1+) and [Fe(pyS(4))X] (X = PR(3), CO, SR(2)) have been studied by EPR and M?ssbauer spectroscopies and DFT calculations (pyS(4) = 2,6-bis(2-mercaptophenylthiomethyl)pyridine(2-)). It is concluded that the electronic structure of 7 with an S = 1/2 ground state is low spin ferrous (S(Fe) = 0) with a coordinated neutral NO radical (Fe(II)-NO) whereas the S = 3/2 state corresponds to a high spin ferric (S(Fe) = 5/2) antiferromagnetically coupled to an NO(-) anion (S = 1). The S = 1/2<==>S = 3/2 equilibrium is then that of valence tautomers rather than that of a simple high spin<==>low spin crossover.     

REALISIS: a medicinal chemistry-oriented reagent selection, library design, and profiling platform

REALISIS is a software system for reagent selection, library design, and profiling, developed to fit the workflow of bench chemists and medicinal chemists. Designed to be portable, the software offers a comprehensive graphical user interface and rapid, integrated functionalities required for reagent retrieval and filtering, product enumeration, and library profiling. REALISIS is component-based, consisting of four main modules: reagent searching; reagent filtering; library enumeration; and library profiling. Each module allows the chemist to access specific functionalities and diverse filtering and profiling mechanisms. By implementing the entire process of reagent selection, library design, and profiling and by integrating all the necessary functionalities for this process, REALISIS cuts the time required to design combinatorial and noncombinatorial libraries from several days to a few hours.     

An Easy Way Toward ε‐Caprolactone Macromonomers by Microwave Irradiation Using Early Lanthanide Halides as Catalysts

Poly(ε‐caprolactone) macromonomers were synthesized under microwave irradiation from commercial caprolactone, using commercial hydrated lanthanide halides as catalysts. The molecular weight of the polymers was in the range 3 000–5 000. Higher molecular weights (5 000–20 000) and lower polydispersity indices were obtained with THF adducts of the lanthanide halides as catalysts and also by applying longer reaction times or using diethylene glycol as a coupling reagent.     

FeCp]+-induced hexafunctionalization of hexamethylbenzene with dendrons for the direct synthesis of redox-active iron-centered metallodendrimers

Phenol tri- and nonaallyl dendrons (3 and 7, respectively) were functionalized at the focal position to give the new triallyl dendrons 4 and 6 and the nonaallyl dendrons 11 and 13 that contain a iodoalkyl or a bromobenzyl termini. All these dendrons were used for the [FeCp]+-induced hexafunctionalization of hexamethylbenzene in [FeCp(eta6-C6Me6)][PF6] (1) under mild conditions in the presence of KOH. These reactions directly yielded the 18-allyl and 54-allyl dendrimers 9, 10, and 14 with a [FeCp(eta6-arene)]+ unit located at the dendrimer core. Cyclic voltammetry studies were recorded in THF and DMF with these metallodendrimers and compared with those of analogous dendrimers or complexes of smaller size that contain a [FeCp(eta6-arene)]+ unit at the core. The decreased rate of heterogeneous electron transfer when the dendritic size increases first disclosed by Diederich and Gross is confirmed. The variation of the redox potential of the Fe(II/I) redox system with increasing dendritic size is negligible even in a solvent of high dielectric constant such as DMF. This trend is attributed to fact that the involved "redox" orbital is buried on the metal center, well protected by the shell of alkyl chains (electron-reservoir nature), unlike in ferrocene. The chemical irreversibility increases in THF as the dendrimer size increases, due to more facile ligand substitution with THF at the 19-electron level when the chain bulk increases.     

Synthesis of methylenedioxy-bearing 1-aryl-3-carboxylisoquinolines using a modified Ritter reaction procedure

This paper describes original approaches aimed at the preparation of electron-rich 1-aryl-3-carboxylisoquinolines. Our first attempt led to an efficient preparation of 1-hydroxyisoquinoline-3-carboxylic acid methyl ester starting from bromophthalide via a rearrangement of 2-acetylamino-2-(3-oxo-1,3-dihydroisobenzofuran-1-yl)-malonic acid dimethyl ester. However, as its eventual application to the synthesis of methylenedioxy-bearing substrates seemed rather long, a second approach involving an extension of the Ritter reaction to safrole was devised. We thus report that, under proper experimental settings, the use of 54% tetrafluoroboric acid in ether enables a Ritter reaction between safrole and 3,4,5-trimethoxybenzonitrile yielding 17% of 7-methyl-5-(3,4,5-trimethoxyphenyl)-7,8-dihydro-[1,3]dioxolo[4,5-g]isoquinoline. This acidic reagent avoids the extensive decomposition seen when using the classical Ritter reaction conditions (i.e.: concentrated sulfuric acid). Further chemical transformations of this methyl-bearing dihydroisoquinoline led to the methylenedioxy-bearing 1-aryl-3-carboxylisoquinoline. These derivatives are related to the peripheral benzodiazepine receptor ligand PK 11195 as well as falcipain-2 inhibitors and other potential antitumor agents.     

Blends of polycarbonate and acrylic polymers: Crystallization of polycarbonate

The microstructure of amorphous polymer blends has been extensively studied in the past, but now there is a growing interest for polymer blends where one or more of the components can crystallize. In this study we investigate such blends, namely miscible polycarbonate (PC)/acrylic blends. Using small angle X-ray scattering (SAXS) measurements, combined with atomic force microscopy (AFM), electron microscopy (SEM), and optical microscopy, we demonstrate that the amorphous acrylic component mostly segregates inside the spherulites between the lamellar bundles (interfibrillar segregation). Varying the PC molecular weight or the mobility of the amorphous component (by changing its molecular weight and T_g) does not change the mode of segregation. So far qualitative predictions of the mode of segregation in semicrystalline polymer blends have been proposed using the δ parameter (the ratio between the diffusion coefficient D of the amorphous component in the blend and the linear crystallization rate G), introduced by Keith and Padden. Our results suggest that other parameters have to be considered to fully understand the segregation process. © 1998 John Wiley & Sons, Inc. J. Polym. Sci. B Polym. Phys. 36: 2197–2210, 1998     

A very efficient,copper-free palladium catalyst for the Sonogashira reaction with aryl halides

The new complex [Pd[t-Bu2PCH2N(CH2Ph)CH2P t-Bu2](OAc)2] is a very efficient catalyst for the Sonogashira cross-coupling reaction of aryl halides with acetylenes at room temperature, without co-catalyst.